Question is ⇒ In microwave communication, some times, microwave signals reach large distances by following the earth curvature. This phenomenon is called, Options are ⇒ (A) tropospheric scatter, (B) faraday effect, (C) ionospheric reflection, (D) ducting, (E) , Leave your comments or Download question paper.

Question is ⇒ In microwave communication, some times, microwave signals reach large distances by following the earth curvature. This phenomenon is called, Options are ⇒ (A) tropospheric scatter, (B) faraday effect, (C) ionospheric reflection, (D) ducting, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In microwave communication, some times, microwave signals reach large distances by following the earth curvature. This phenomenon is called
A.	tropospheric scatter [Wrong Answer]
B.	faraday effect [Wrong Answer]
C.	ionospheric reflection [Wrong Answer]
D.	ducting [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Nichrome is used for
overload line wires
heater coils
lamp filaments
all of the above

⇒ To prevent overloading in the last IF amplifier one should use
variable sensitivity
squelch
double conversion
variable selectivity

⇒ An intrinsic semiconductor (intrinsic electron density = 10¹⁶ m^-3) is deped with donors to a level of 10²² m^-3. What is the hole density assuming all donors to be ionized?
10⁷ m^-3
10⁸ m^-3
10¹⁰ m^-3
10⁶ m^-3

⇒ The effective channel length of a MOSFET in saturation decreases with increase in
gate voltage
drain voltage
source voltage
body voltage

⇒ In case of photo conductor for germanium when forbidden energy gap is 0.72 eV, the critical wavelength for intrinsic excitation will be
1.43 m
1.43 mm
1.73 mm
1.73 x 10¹² m

⇒ The use of thermocouple meters for ac measurement leads to a scale which is
linear
square law
logarithmic
exponential

⇒ In floating point number 0110100000010101, the exponent is equal to __________ ₁₀
11
-11
10
-10

⇒ If A = 0101, then A' is
1010
1011
1001
110

⇒ The saving of power in DSB-SC modulated at 80% is
NIL
0.8
0.7576
0.5

⇒ A single phase dual converter consists of
two fully controlled converters connected in parallel
two fully controlled converters connected in antiparallel
two fully controlled semiconverters connected in antiparallel
two fully controlled semiconverters connected in parallel

⇒ Which of these are universal gates?
Only NOR
Only NAND
Both NOR and NAND
NOR, NAND, OR

⇒

Assertion (A): A video monitor does not need RF tuner and IF amplifier

Reason (R): The picture tube in TV is basically a CRT.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Assume that x = 5 and y = 2. Then in Java operation x + = y, the result is
x = 7
x = 2
x = 3
x = 2

⇒ A load commutated chopper circuit has
one thyristor
two thyristors
four thyristors
six thyristors

⇒ Directivity means
maximum directive gain
zero directive gain
minimum directive gain
none of the above

⇒ Ohmic range of metal film resistors is
1 to 100 ohms
10 to 1 K ohms
100 to 1 M ohms
100 to 100 M ohms

⇒ Wide banding technique is employed in the
video amplifier of a TV receiver
IF amplifier of an FM receiver
RF amplifier of an AM receiver
input section of a communication receiver

⇒

Assertion (A): Hamming code is commonly used for error correction

Reason (R): In Hamming code the number of parity bits increases as the number of information bits increases.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ Which of the following is/are correct? The circuit shown in the fig
1 and 3
1 and 2
1 and 4
3 only

⇒ Circular polarized waves result when
magnitudes are the same
phases are the same
magnitudes are same and phase difference is 90°
magnitudes are same and phase difference is zero

⇒ When the gate terminal of MOSFET is positive, it is said to operate in
depletion mode
conduction mode
enhancement mode
none of the above

⇒ Most electromagnetic transmission in rectangular wave-guide uses
TE₁₀ mode
TE₀₁ mode
TE₂₀ mode
TE_₁₁ mode

⇒ MTI stands for
Moving Target Indicator
Microprocessor Tracking Index
Multiplexed Telemetry Index
Maximum Transmission Index

⇒ In an 8085 microprocessor, the instruction CMP B has been executed while the content of the accumulator is less than that of register B, As a result.
carry flag will be set but zero flag will be reset
carry flag will be reset but zero flag will be set
both carry flag and zero flag will be reset
both carry flag and zero flag will be set

⇒ Read the following rules for scanning Boolean expressions in Pascal

The expressions are scanned from left to right.
The operations are scanned in the order NOT, AND, OR.
All operators (i.e., NOT, AND and OR) are scanned together.
In one scanning all the operators of only one type are scanned.

Which of the above are correct?
All
1, 2 and 3 only
1, 2 and 4 only
2, 3 and 4 only

⇒ For decimal numbe'r 13.5, the floating point representation in 4 byte excess 128 code is
01101100 00000000 00000000 10000100
00000000 01101100 00000000 10000100
00000000 01101100 10000100 00000000
01101100 00000000 10000100 00000000

⇒

Assertion (A): SSB and ISB receivers have good S/N ratio

Reason (R): SSB and ISB receivers have good suppression of adjacent channels.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In the given figure x_{6de(ax₁ + bx₂ + cx₃)
(a + b + c) (x₁ + x₂ + x₃) (d + e)
(ax₁ + bx₂ + cx₃) (d + e)
a b c d e (x₁ + x₂ + x₃)}

⇒ A Schottky diode has
no minority carriers and very low voltage drop in forward direction
no minority carriers and very high voltage drop in forward direction
large number of minority carriers and very high voltage drop in forward direction
large number of minority carriers and very low voltage drop in forward direction

⇒ The code used to reduce the error due to ambiguity in reading of a binary optical encoder is
Octal code
Excess-3 code
gray code
BCD code