Question is ⇒ In Maxwell's bridge the unknown inductance is measured by comparing it with a standard capacitor., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper.

Question is ⇒ In Maxwell's bridge the unknown inductance is measured by comparing it with a standard capacitor., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In Maxwell's bridge the unknown inductance is measured by comparing it with a standard capacitor.
A.	TRUE [Wrong Answer]
B.	FALSE [Correct Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Match the following:

	List I		List II
A.	Mu Metal	1.	very high magnetic permeability
B.	Samrium/cobalt	2.	very high magnetic remanence
C.	Sapphire	3.	very high thermal conductivity
D.	Ferrites	4.	very stable magnetic permeability

A-1, B-2, C-3, D-4
A-3, B-4, C-1, D-2
A-2, B-3, C-4, D-1
A-4, B-1, C-2, D-3

⇒ The magnitude plot of a rational transfer function G(s) with real coefficients is shown below. Which of the following compensators has such a magnitude p
Lead compensator
Lag compensator
PID compensator
Lead-lag compensator

⇒

Assertion (A): A Smith chart can be used for a number of calculations of a transmission line

Reason (R): Smith chart is basically a polar impedance diagram.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In a reverse biased P-N junction, the current through the junction increases abruptly at
zero voltage
1.2 V
0.72 V
breakdown voltage

⇒ In a CE amplifier the input impedance is equal to the ratio of
ac base voltage to ac base current
ac base voltage to ac emitter current
ac emitter voltage to ac collector current
ac collector voltage to ac collector current

⇒ If C is thermal capacitance, m is mass of liquid and c is specific heat, then
C = mc
c = mC
m = cC
C = (mc)²

⇒ Which one of the following devices is not used as the controller in a stabilizer?
DIAC
TRIAC
SCR
Power transistor

⇒ In a single phase full wave regulator feeding R-L load, the minimum firing angle can be zero.
TRUE
FALSE

⇒

Assertion (A): Electronic and Ionic polarization in a polyatomic gas are independent of temperature.

Reason (R): The orientation polarization is independent of temperature.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which one of the following is a passive device/Component?
Transformer
Oscillator
Generator
None

⇒ Which one of the following compounds is widely used for making ferrites?
FeO
CuO
MgO
Fe₂O₃

⇒ Dielectric strength of polythene is around
10 kV/mm
40 kV/mm
100 kV/mm
140 kV/mm

⇒ For an insulating material, dielectric strength and dielectric loss should be respectively
high and high
low and high
high and low
low and low

⇒ In a superheterodyne receiver, the IF stage has better selectivity than RF stage because
of higher frequency
of lower frequency
of high L/C ratio
of constant passband

⇒ Multiplexer can be used as logic function generator.
TRUE
FALSE

⇒ In figure, Z₁ = 200∠60° Ω, Z₂ = 400∠ - 90° Ω, Z₃ = 300∠0°. Then Z₄ for bridge to be balanced
150∠30° Ω
400∠ - 90° Ω
300∠90° Ω
600∠ - 150° Ω

⇒ In auxiliary commutated chopper, the peak value of thyristor current is
equal to peak value of load current
equal to peak value of capacitor current
sum of peak value of load current and capacitor current
none of the above

⇒ By placing an inverter between both inputs of an S-R flip-flop, the resulting flip-flop becomes
J-K flip-flop
D-flip-flop
T-flip-flop
Master salve JK flip-flop

⇒ Each cell of a static RAM has
4 MOS transistors
4 MOS transistors and 2 capacitors
2 MOS transistors and two capacitors
1 MOS transistor and 1 capacitor

⇒ Friction forces acts in a direction
opposite to that of velocity
same as that of velocity
at right angle to that of velocity
partly opposite and partly at right angle to the direction of velocity

⇒ The 'h' parameters of the circuit shown in the figure are h_ib = 25 Ω, h_fb = 0.999 and h_ob = 10^-6Ω The Voltage gai
0.99
1.98
2
4

⇒ In 8085 microprocessor, what is the length of SP (stack) pointer?
6 bits
8 bits
12 bits
16 bits

⇒ Which amplifier has a voltage gain of less than 1?
Common emitter
Common collector
Common base
Both CB and CC

⇒ An image uses 512 x 512 picture elements. Each of the picture elements can take any of the 8 distinguishable intensity levels. The maximum entropy in the above image will be
2097152 bits
648 bits
786432 bits
144 bits

⇒ The output of a linear system for any input can be computed in which of the following ways?
Only by summation of inpulse response by convolution integral
Only by summation of step response by superposition integral
Neither a nor b
Either (a) or (b)

⇒

Assertion (A): Impatt diode can be used in both amplifiers and oscillators.

Reason (R): Impatt diode has a low resistance.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ What is meant by "continuous collector current" in BJT?
Maximum collector current
Current at Quiescent condition
Leakage current
Junction Capacitance charging and discharging current

⇒ In intrinsic semiconductor the increase in conductivity per degree increase in temperature is about
0.02
0.06
0.15
0.25

⇒ Which characteristics of a memory chip is called dc characteristics?
Organisation
Timing characteristics
Physical dimensions
Power consumption and bus loading

⇒ If a transistor is operating with both of its Junctions forward biased, but with the collector base forward biased, but with the collector base forward bias greater than the emitter-base forward bias, then it is operating in the
forward active mode
reverse saturation mode
reverse active mode
forward saturation mode