Question is ⇒ In intrinsic semiconductor, the fermi level, Options are ⇒ (A) lies at the centre of forbidden energy gap, (B) is near the conduction band, (C) is near the valence band, (D) may be anywhere in the forbidden energy gap, (E) , Leave your comments or Download question paper.

Question is ⇒ In intrinsic semiconductor, the fermi level, Options are ⇒ (A) lies at the centre of forbidden energy gap, (B) is near the conduction band, (C) is near the valence band, (D) may be anywhere in the forbidden energy gap, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In intrinsic semiconductor, the fermi level
A.	lies at the centre of forbidden energy gap [Correct Answer]
B.	is near the conduction band [Wrong Answer]
C.	is near the valence band [Wrong Answer]
D.	may be anywhere in the forbidden energy gap [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a CD player the speed of CD is
constant at 500 rpm
constant at 200 rpm
varies from 200 to 500 rpm
none of the above

⇒ Hall effect can be used
to find type of semiconductor (whether p or n)
to find carrier concentration
to measure conductivity
all of the above

⇒ Which of the following methods can be used to measure power in a single phase circuit without using wattmeter?

One voltmeter, one ammeter
Two voltmeters, two ammeter
Three voltmeters
Three ammeters

1 and 2 only
2 and 4 only
1 and 3 only
3 and 4 only

⇒ In C the keywords are also called
special words
reserved words
class words
character words

⇒

Assertion (A): If the reading of an instrument is low, the error is large.

Reason (R): The error of an instrument is certain percentage of its full scale deflection.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ The minimum sampling frequency in sample/sec. required to reconstruct the following signal from its samples wuthout distor
2 x 10³
4 x 10³
6 x 10³
8 x 10³

⇒ If a driving point function N(s) = p(s)/q(s), then
the degree of p(s) and q(s) may differ by one only
the degree of p(s) and q(s) may differ by zero only
the degrees of p(s) and q(s) be equal
the degrees of p(s) and q(s) must not be equal

⇒ If A = B = 1, the outputs P and Q in the given figure
P = Q = 0
P = 0, Q = 1
P = 1, Q = 0
P = Q = 1

⇒ An n channel JFET has I_DS whose value is
maximum for V_GS = 0 and minimum for V_GS negative and large
minimum for V_GS = 0 and maximum for V_GS negative and large
maximum for V_GS = 0 and minimum for V_GS positive and large
minimum for V_GS = 0 and maximum for V_GS positive and large

⇒ Divergence of curl A is
∇ . (∇ x A) = 1
∇ . (∇ x A) = 0
∇ . (∇ x A) = ∇
∇ . (∇ x A) = - ∞

⇒ At f = 7 GHz, a 120 cm dish antenna gives a gain of about
50
500
5000
50000

⇒ A planar array radar uses a high gain planar array antenna.
TRUE
FALSE

⇒ What would be the rms value of a sine wave having the same peak value as that of the above mentioned periodic wave?
42.2 V
19 V
38.2 V
none

⇒ For satellite transmission, analog signals may be converted into digital form with the help of
modem
transponder
codec
compandor

⇒ Measurement of Hall coefficient enables the determination of
transportation factor decreases and a increases
transportation factor increases and a increases
transportation factor increases and a decreases
transportation factor decreases and a decreases

⇒ In CE amplifier circuit, voltage gain is directly proportional to
β
collector supply voltage
base resistance
none of the above

⇒ Method of images is applicable to which fields?
Electrostatic fields only
Electrodynamic fields only
Neither electrostatic fields nor electro-dynamic fields
Both electrostatic fields and electro-dynamic fields

⇒ In CE approximately, the active region is where the collector curves are
almost horizontal
almost vertical
inclined at 45°
inclined at 60°

⇒

Match the following:

	List I (Instrument)		List II (Measured quantity)
A.	Hot wire	1.	only voltage
B.	PMMC	2.	phase
C.	Electrostatic	3.	true RMS value
D.	Lock in Amplifier	4.	dc value

A-3, B-2, C-1, D-4
A-1, B-4, C-2, D-3
A-3, B-4, C-1, D-2
A-2, B-3, C-4, D-1

⇒ The gradient of any scalar field always yields __________ .
a solenoidal field
a conservative field
an irrotational field
none of these

⇒ In microwave circuits, a mode transducer is used to
change mode of wave transmission
change direction of wave transmission
change polarization of wave transmission
change mode, direction or polarization wave transmission

⇒ In the given figure the input frequency f = 10(1/2 p
0 dB
3 dB
-3 dB
-20 dB

⇒ In a BJT circuit a pnp transistor is replaced by npn transistor. To analyse the new circuit
all calculations done earlier have to be repeated
replace all calculated voltages by reverse values
replace all calculated currents by reverse values
replace all calculated voltages and currents by reverse values

⇒ Which of the following is a valid FORTRAN assignment statement?
10 = N
X + 2.1 = 5.6
A = B
A = B = 1

⇒

Assertion (A): Dielectric constant is independent of temperature unless the temperature is extremely high.

Reason (R): For normal temperatures the number of atoms per unit volume is constant.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒

Assertion (A): Microprocessor 8085 has an 8 bit register called accumulator which stores intermediate answers during a computer operation.

Reason (R): Accumulator can send or receive data.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Find the radiation resistance of an antenna of length λ/10 meter?
8 Ω
780 Ω
7.8 Ω
78 Ω

⇒ The trigonometric Fourier series for the waveform f(t) shown below con
only cosine terms and zero value for the dc component
only cosine terms and a positive value for the dc component
only cosine terms and a negative value for the dc component
only sine terms and a negative for the dc component

⇒ If f_h(t) is the Hilbert transform of f(t), and f(t) is a real valued signal, the pre-envelope of f(t) is
f(t) - jf_h(t)
f(t) + jf_h(t)
f_h(t) + jf(t)
f_h(t) - jf(t)

⇒ Resistivity of electrical conductors is most affected by
Pressure
temperature
composition
ageing