Question is ⇒ In h parameter representation, the independent variables are, Options are ⇒ (A) I1 and V2, (B) I2 and V1, (C) V1 and V2, (D) I1 and I2, (E) , Leave your comments or Download question paper.

Question is ⇒ In h parameter representation, the independent variables are, Options are ⇒ (A) I1 and V2, (B) I2 and V1, (C) V1 and V2, (D) I1 and I2, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In h parameter representation, the independent variables are
A.	I₁ and V₂ [Correct Answer]
B.	I₂ and V₁ [Wrong Answer]
C.	V₁ and V₂ [Wrong Answer]
D.	I₁ and I₂ [Wrong Answer]
View Answer 5 -2 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The circuit of the given figure perf
OR function
AND function
exclusive OR function
exclusive NOR function

⇒ A 3-digit voltmeter having a resolution of 100 mV can be used to measure a maximum of
100 V
200 V
1000 V
5000 V

⇒ In n type MOSFET, the substrate
is p type
is n type
is metallic
may be p or n type

⇒ Find R_L for maximum power trans
3 Ω
1.125 Ω
4.1785 Ω
None of these

⇒ In a turnstile antenna two-half wave resonant wire radiators are placed at 90° to each other in the same plane and are excited
in phase
in phase opposition
90° out of phase with each other
45° out of phase with each other

⇒ TV receivers use flyback switched mode power supply because
it can supply many voltage outputs
it does not require a filter choke and is cheap
it has very good regulation at all loads
both (a) and (c)

⇒ A step down cycloconverter has an input frequency f. If it uses natural commutation, the output frequency
must be a sub-multiple of input frequency
can be any frequency
must be an even sub-multiple of input frequency
must be an odd sub-multiple of input frequency

⇒ Which of the following features is not associated with Nichols chart?
(0 dB, -180°) point on Nichols chart represent critical Point (-1, 0)
It is symmetric about -180°
M loci are centred about (0 dB, -180°) point
The frequency at intersection of G(jω) locus and M = +3 dB locus gives bandwidth of closed loop system

⇒ Simplify : A + B + A B + (A + B)AB + C(B + AB)
B + A
C
C
1

⇒ The low pass filter characteristic shown in figure realiza
TRUE
FALSE

⇒ The disadvantage of direct coupled amplifiers is
drift
large size of transistor
low voltage gain
both (b) and (c)

⇒ The ratio of active power to apparent power is known as __________ factor.
power
load
form
demand

⇒ To convert SR latch to D latch
connect both S and R to D
connect D to S directly and D to R through inverter
connect D to R directly and D to S through inverter
connect S to D and leave R open

⇒ If the number of information bits is m, the number of parity bits p in the Hamming code is given by equation
2^p = m + p + 1
2^p ≥ m + p + 1
2^P = m + p
2^p ≥ m + p

⇒ The first dominant pole encountered in the frequency response of a compensated op-amp is approximately at
5 Hz
10 kHz
1 MHz
100 MHz

⇒ An electric heater is controlled by thyristors through on-off control. If a = 0.4, the heating is
16% maximum
40% of maximum
60% of maximum
84% of maximum

⇒ At night the ionosphere can be considered to be consisting of
D, E, F₁ and F₂ layers
D, E, F₁ layers
D, E, F₂ layers
E and F₂ layers

⇒

Assertion (A): Impulse function is an important function in network analysis.

Reason (R): Convolution integral enables us to find the response of a network to an arbitary input in terms of the impulse response.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒

Assertion (A): Secondary instruments require calibration at frequent intervals.

Reason (R): Secondary instruments have many errors.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ Which configuration is suitable for impedance matching?
CB
CE
CC
CB and CE

⇒ Which op-amp circuit uses a diode as one of the circuit components?
Integrating amplifier
Differentiating amplifier
Logarithmic amplifier
Summing amplifier

⇒ Which of the following Boolean Expression correctly represents the relation between P, Q, R and M_{1M₁ = (P OR Q) XOR R
M₁ = (P AND Q) XOR R
M₁ = (P NOR Q) XOR R
M₁ = (P XOR Q) XOR R}

⇒ If i_b is plate current, e_b is plate voltage and e_c is grid voltage the v-i curve of a vacuum triode
0.5 and 1
- 2 and 1
30 and 1
30 and 1.5

⇒ A gate function which occurs at t = t₀ and lasts for duration T can be written as
u (t - t₀ - T)
u(t - t₀) = u(t - t₀ - T)
u(t - t₀) - u(t - t₀ - T)
u(t - t₀) - u(t - t₀ + T)

⇒ Ohmic range of metal film resistors is
1 to 100 ohms
10 to 1 K ohms
100 to 1 M ohms
100 to 100 M ohms

⇒ An electrolytic capacitor can be used for
ac only
dc only
both ac and dc
high frequency ac

⇒ Skip distance depends on time of day and angle of incidence.
TRUE
FALSE

⇒ In a picture tube, the video signal is applied to
cathode
grid
any anode
either cathode or grid

⇒ The method of frequency compensation in moving iron voltmeter is
to use a capacitor in series with coil
to connect a capacitor in parallel with coil
to connect a capacitor in parallel with series resistance
none of the above

⇒ Binary multiplication can be done by repeated addition.
TRUE
FALSE