Question is ⇒ In household energy meters the flux of series magnet is in phase with current but the flux of shunt magnet lags the voltage by 88°. The reading of energy meters, Options are ⇒ (A) will be correct, (B) will have a negative error, (C) will have a positive error, (D) may have positive or negative error, (E) , Leave your comments or Download question paper.

Question is ⇒ In household energy meters the flux of series magnet is in phase with current but the flux of shunt magnet lags the voltage by 88°. The reading of energy meters, Options are ⇒ (A) will be correct, (B) will have a negative error, (C) will have a positive error, (D) may have positive or negative error, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In household energy meters the flux of series magnet is in phase with current but the flux of shunt magnet lags the voltage by 88°. The reading of energy meters
A.	will be correct [Wrong Answer]
B.	will have a negative error [Correct Answer]
C.	will have a positive error [Wrong Answer]
D.	may have positive or negative error [Wrong Answer]
View Answer 2 -2 Explanation:- Answer : B Discuss it below : LiFE CHAnGer Said on 2020-06-08 01:43:00 Since angle is less than 90°, reading will be less. Therefore error is negative and correction is positive. !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In an 8085 microprocessor, the instruction CMP B has been executed while the content of the accumulator is less than that of register B, As a result.
carry flag will be set but zero flag will be reset
carry flag will be reset but zero flag will be set
both carry flag and zero flag will be reset
both carry flag and zero flag will be set

⇒ With respect to the differential amplifier configuration shown below, the differential gain A_d will
273.63
213.63
113.63
233.63

⇒ In figure the current through resist
is always equal to 130 mA
may vary between 130 mA and 10 mA
may vary between 65 mA and 10 mA
is always equal to 65 mA

⇒ The number of thyristors in a single phase fully controlled bridge rectifier is
16
8
4
2

⇒ If x_k = a^k and k &l
TRUE
FALSE

⇒ Read the following statements

The circuitry of ripple counter is more complex than that of synchronous counter.
The maximum frequency of operation of ripple counter depends on the modulus of the counter.
The maximum frequency of operation of synchronous counter does not depend on the modulus of the counter.

Which of the above statements are correct?
1 only
1, 2
1, 2, 3
2, 3

⇒ Which of the following term applies to troposcatter propagation?
SIDs
Faraday rotation
Atmospheric storms
Fading

⇒ Consider the differential amplifier shown in figure. (Assume β is very hi
2 mA
1 mA
0.5 mA
3 mA

⇒ Induction wattmeter is an absolute instrument.
TRUE
FALSE

⇒ Figure represen
Diode rectifier
Schottky diode
Varistor
None of the above

⇒ The volt ratio box is basically a
potential divider
current transformer
a high resistance voltmeter
either (a) or (c)

⇒ 2's complement representation of a 16 bit number (one sign bit and 15 magnitude bit) is FFFF. Its magnitude in decimal representation is
0
1
32676
65, 535

⇒ In what condition does BJT act like an open switch
cut off
saturation
active
both (b) and (c)

⇒ Complex pole in z-plane is as shown below. This is the pole diagram for ________
Decaying sinusoidal sequence
Growing sinusoidal sequence
Decaying non sinusoidal sequence
Growing non sinusoidal sequence

⇒ The units for apparent power are watts.
TRUE
FALSE

⇒ Contents of RAM cannot be altered.
TRUE
FALSE

⇒ A 10 bit ADC with a full scale output voltage of 10.24 V is to be designed to have ± LSB/2 accuracy. If ADC is calibrated at 25°C, the maximum net temperature coefficient of ADC should not exceed
± 200 μV/°C
± 400 μV/°C
± 600 μV/°C
± 800 μV/°C

⇒ In a differential amplifier, CMRR can be improved by using an increased
emitter resistance
collector resistance
power supply voltages
source resistance

⇒ A signal occupies a band 5 kHz to 10 kHz. For proper error free reconstruction at what rate it should be sampled?
10 kHz
20 kHz
5 kHz
(10 + 5) x 2 kHz

⇒ In a FET, g_m varies as
I_DS
I_DS2
1/IDS
I_DS

⇒ The circuit given below
counter
digital to analog converter
two-bit series-to-parallel converter
analog-to digital converter

⇒ A 0-200 V voltmeter has an accuracy of 0.75% of full scale reading. If voltage measured is 100 V, the error is
0.03
0.02
0.015
0.0075

⇒ The effect of lead resistance is important in measurement of
resistance of shunt
resistance of shunt winding
resistance of ammeter
both (a) and (c)

⇒

Assertion (A): At a temperature of 1000 K, thermionic emission current is about 0.1 A/cm² of surface.

Reason (R): Thermionic emission current is given by I_th = SA₀ T² e^-Ew/kT.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒

Assertion (A): An electrostatic voltmeter is free from hysteresis and eddy current errors.

Reason (R): An electrostatic voltmeter has a number of fixed and moving vanes in parallel.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ In the given figure shows a 10dB directional coupler. If power input at port 1 is 100 mW, power output at port
10 mW
15 mW
20 mW
25 mW

⇒ Which of the following functions would have only odd powers of x in its Taylor series expansion about the point x = 0?
sin (x³)
sin (x²)
cos (x³)
cos (x²)

⇒ In the above case, what will be the value of capacitor to obtain 100 kHz frequency?
0.0065 pF
0.0130 pF
0.0260 pF
0.520 pF

⇒ Which of the following is an indirect method of generating FM?
Reactance BJT modulator
Armstrong modulation
Varactor diode modulation
Reactive FM modulator

⇒

Assertion (A): Mnemonics are used in assembly level program.

Reason (R): Computer cannot understand mnemonics.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

Since angle is less than 90°, reading will be less. Therefore error is negative and correction is positive.