Question is ⇒ In high frequency region, an amplifier behaves like a, Options are ⇒ (A) band pass filter, (B) low pass filter, (C) high pass filter, (D) any of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ In high frequency region, an amplifier behaves like a, Options are ⇒ (A) band pass filter, (B) low pass filter, (C) high pass filter, (D) any of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In high frequency region, an amplifier behaves like a
A.	band pass filter [Wrong Answer]
B.	low pass filter [Correct Answer]
C.	high pass filter [Wrong Answer]
D.	any of the above [Wrong Answer]
View Answer 3 -2 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For a reactance function H(s), the slope dH (jω)/dω is
0
always positive
always negative
either 0 or positive

⇒

Assertion (A): Mnemonics are used in assembly level program.

Reason (R): Computer cannot understand mnemonics.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ The maximum concentration of the element which can be dissolved in solid silicon at a given temperature is termed as
Solid solubility
Dissolution coefficient
Solidification index
Concentration index

⇒ TE₀₁ mode of propagation of electromagnetic energy
is merely the TE₁₀ mode rotated 90°
is merely the TE₁₀ mode rotated 180°
is the same as TE₁₀ mode
either (b) or (c)

⇒ Which of the following microphones works on the principle of Faraday's law?
Carbon
Condenser
Moving coil
Electret

⇒

Assertion (A): The forward resistance of a p-n diode is not constant.

Reason (R): The v-i characteristics of p-n diode is non-linear.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ If Laplace transform of f(t) is F(s), then £ f(t - a) u (t - a)= 0
e^as F(s)
e^-as F(s)
- e^as F(s)
- e ^-as F(s)

⇒ In a two terminals network the O.C. voltage measured at the given terminals is 100 V and s.c., currents at the same terminals 5 A. If a load of 80 Ω resistance is connected at the terminals, load current is
0.0416666666666667
1.25 A
0.25
6.25 A

⇒ In all metals
conductivity decreases with increase in temperature
current flow by electrons as well as by holes
resistivity decreases with increase in temperature
the gap between valence and conduction bands is small

⇒ In an AM system, doubling of modulation index doubles the antenna current. The system is
single side band full carrier
vestigial side band
single side band suppressed carrier
double side band full carrier

⇒ The horizontal intercept of dc load line is the same as ideal
cut off point
saturation point
operating point
quasi saturation point

⇒ For an m x n matrix A, the eigen values are the roots of the characteristic equation
|I - A|
|λI - A| = 0
|λA - I| = 0
|A - I| = 0

⇒ If e = 10 sin(10⁸ t + 3 sin 10⁴ t) then carrier frequency is
0.159 MHz
1.59 MHz
15.9 MHz
159 MHz

⇒ Current through a charging capacitor exhibits
an exponential growth function
an exponential decay function
a step decay function
a linear decay function

⇒ The owner of a communication satellite is usually required to keep the spacecraft on station at its assigned place in the geosynchronous orbit with an accuracy of __________ degree.
0.1
1
2
0.5

⇒

Assertion (A): The phase angle plot in Bode diagram is not affected by change in system gain.

Reason (R): The variation in gain has no effect on phase margin of the system.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ When two port networks are connected in cascade, it is more convenient to use hybrid parameters.
TRUE
FALSE

⇒ A feedback network to be used with an amplifier to provide oscillation is tested and found to give an output of 0.124 V with a 0.5 V input. What must be the minimum gain of the oscillator to provide oscillations?
40
60
100
130

⇒ The static equalisation circuit for thyristors connected in series is
one resistor in series with each thyristor
one resistor in parallel with each thyristor
one resistor and one capacitor in parallel with each thyristor
none of the above

⇒ In EPROM integrated dose is defined as
UV light intensity x exposure time in seconds
UV light intensity / exposure time in seconds
exposure time in seconds / UV light intensity
none of the above

⇒ Symbol shown in figure represen
P-channel DEMOSFET
N-channel DEMOSFET
UJT with N-type base
UJT with P-type base

⇒ The phase difference between them is __________ degrees.
15
50
60
105

⇒ In the spectrum of a FM wave
the carrier frequency cannot disappear
the carrier frequency disappears when the modulation index is large
the amplitude of any sideband depends on the modulation index
the total number of sidebands depends on the modulation index

⇒ An 8085 executes the following instructionsPC = 2715 H HL = 30A0 H
PC = 30A0H HL = 2715H
PC = 6104 H HL = 6140 H
PC = 6140H HL = 2715H

⇒ Which of the following is the main difference between waveguide and transmission line?
Waveguides cannot be coupled to coaxial lines
Waveguides have no standing wave ratio
Transmission line does not suffer from the effect of low cut off frequency
Waveguides are not distributed like transmission lines

⇒ The materials having low retentivity are suitable for making
temporary smagnets
weak magnets
permanent magnets
both temporary and permanent magnets

⇒ Consider the following tasks in a micro computer

Receiving data and instruction
Performing arithmetic computation
Performing logical computations
Storing data and instructions

Which of the above are performed by ALU?
2 only
2 and 3 only
1, 2 and 3 only
All

⇒ In floating point representation decimal number 13.5 is
1101.1
1.1011 x 2³
0.11011 x 2⁴
11.011 x 2²

⇒ Which of the following meters cannot measure a.c. quantities?
Thermocouple
Hot wire
P.M.M.C.
Electrodynamometer.

⇒ In 8421 Binary coded Decimal system the decimal number 237 is represented by
1000110111
1000111110
1000110111
10010010011