Question is ⇒ In FSK no synchronous carrier is needed at the receiver, Options are ⇒ (A) TRUE, (B) FALSE, (C) depend on distance, (D) none, (E) , Leave your comments or Download question paper.

Question is ⇒ In FSK no synchronous carrier is needed at the receiver, Options are ⇒ (A) TRUE, (B) FALSE, (C) depend on distance, (D) none, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In FSK no synchronous carrier is needed at the receiver
A.	TRUE [Wrong Answer]
B.	FALSE [Correct Answer]
C.	depend on distance [Wrong Answer]
D.	none [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): Demodulation of SSB and AM signals is exactly similar

Reason (R): The basic SSB demodulation device is product detector.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ ECL is a saturating logic.
TRUE
FALSE

⇒ A current source inverter has simple commutation circuit.
TRUE
FALSE

⇒

Assertion (A): L[af₁(t) + bf₂(t)] = aF₁(s) - bF₂(s)

Reason (R): Initial value theroem enables us to find the value of f(t) at t = 0 directly from F(s)

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The earliest uses of electromagnetic waves were
point to point communication
radar
both (a) and (b)
neither (a) nor (b)

⇒ In practical commercial AM system channel bandwidth is
150 kHz
100 kHz
15 kHz
200 kHz

⇒ An ammeter of 0-25 A range has a guaranteed accuracy of 1% of full scale reading. The current measured is 5 A. The limiting error is
0.02
0.025
0.04
0.05

⇒ In a three phase to single phase full wave bridge cycloconverter, the number of thyristors is
36
18
12
8

⇒ A hertzian dipole has a radiation pattern with
a null in the direction of the dipole
a null in the plane perpendicular to the dipole
a peak in the direction of the dipole
none of the above

⇒ L[c₁f₁(t) + c₂f₂(t)] =
c₁ F₁ (jω) + c_₂ F₂(jω)
c₁ F₁ (jω) - c_₂ F₂(jω)
c₁ F₁ (jω) + c_₂ F₂(jω) + c₁c₂
c₁ F₁ (jω) + c_₂ F₂(jω) + c₁/c₂

⇒ The response of a thermistor overs the whole of its temperatures range is
linear
non-linear
almost linear
either (a) or (c)

⇒

Assertion (A): The transient performance of a control system is generally analysed by using unit step function as reference input.

Reason (R): Impulse is the most common input found in practice.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ For the truth table of the given figure
A + B + C
A + BC
A
B

⇒ In a CE amplifier the Q point is very close to saturation point on the dc load line. This results in
positive clipping of collector current
negative clipping of collector current
both positive and negative clipping of collector current
either positive or negative clipping of collector current

⇒ Which of the following has the highest input impedance?
CE
CB
CC
Push pull

⇒ Beam width of an antenna is expressed in
metres
degrees
ratio of two powers
ratio of two angles

⇒ When the carrier is unmodulated, a certain transmitter radiates 9 kW when the carrier is sinusoidally modulated the transmitter radiates 10.125 kW. The modulation index will be
0.1
10.15
0.4
0.5

⇒ Multiphase choppers are used in
low power circuits
high power circuit
both low and high power circuits
medium power circuits

⇒ The number of counter states which an 8 bit stair step A/D converter has to pass through before conversion takes place is equal to
1
8
255
256

⇒ The box on the external left of the title bar of menu is called control menu box.
TRUE
FALSE

⇒

Assertion (A): Power transistor has lower switching time than SCR

Reason (R): Power transistor has greater switching time than SCR

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The given figure shows log magnitude versus ω plots of a system for different values of gain. For this sy
curve 1 shows highest gain margin and curve 2 shows poorest gain margin
gain margins shown by the three curves are equal
curve 1 shows poorest gain margin and curve 3 shows highest gain margin
curve 3 shows poorest gain margin while curve 1 shows highest gain margin

⇒ The highest modulating frequency typically used in AM systems is
1 kHz
5 kHz
20 kHz
50 kHz

⇒ Image frequency rejection mainly depends upon
detector
mixer
IF
RF

⇒ In microwave detector used in laboratory measurements of relative power levels, standing wave ratio is about
0.1
1.25
5
10

⇒ A clipper
adds a dc component to the input signal
removes signal voltages above or below a specified value
both (a) and (b)
either (a) or (b)

⇒ The effect of current shunt feedback in an amplifier is to
increase the I/P resistance and decrease the O/P resistance
increase both I/P and O/P resistance
decrease both I/P and O/P resistance
decrease the I/P resistance and increase O/P resistance

⇒ The intermediate frequency of a superheterodyne receiver is 450 kHz. If it is tuned to 1200 kHz, the image frequency will be
750 kHz
900 kHz
1600 kHz
2100 kHz

⇒ A tweeter should be fed from the input through a
low pass filter
high pass filter
band pass filter
band stop filter

⇒ To determine the polarity of voltage drop across a resistor, it is sufficient to know
direction of current through the resistor
direction and magnitude of current through the resistor
direction and magnitude of current and value of resistance
magnitude of current through the resistance