Question is ⇒ In free space, line of sight propagation case, the transmission losses between transmitter and receiver increase with frequency (f) as, Options are ⇒ (A) f, (B) f2, (C) f4, (D) f1/2, (E) , Leave your comments or Download question paper.

Question is ⇒ In free space, line of sight propagation case, the transmission losses between transmitter and receiver increase with frequency (f) as, Options are ⇒ (A) f, (B) f2, (C) f4, (D) f1/2, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In free space, line of sight propagation case, the transmission losses between transmitter and receiver increase with frequency (f) as
A.	f [Wrong Answer]
B.	f² [Wrong Answer]
C.	f⁴ [Correct Answer]
D.	f^1/2 [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For a NAND SR latch of input is the normal resting state of inputs is
S = R = 1
S = 0, R = 1
S = 1, R = 0
S = R = 0

⇒ The oscillator shown in figure
Clapp oscillator
R-C Phase shift oscillator
Hartley oscillator
Colpitt's oscillator

⇒ An AC circuit has two branches in parallel. The current in one branch is 5 A. Then the current source
must be less than 5 A
must be more than 5 A
may be equal or more or less than 5 A
0.208333333333333

⇒

Assertion (A): In intrinsic semiconductors, the charge concentration increases with temperature.

Reason (R): At higher temperatures, the forbidden energy gap in semiconductors is lower.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ The open loop gain of an ideal op-amp is
infinite
very high
neither high nor low
low

⇒ Radar is essentially an echo ranging system
TRUE
FALSE

⇒

Assertion (A): Power is the rate at which energy is supplied.

Reason (R): Energy = VIt.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Consider the following DO statement in Fortran 77 10
2
5
zero

⇒

Assertion (A): In a BCD to 7 segment decoder the number of outputs active at one time is always the same.

Reason (R): A decoder can be used to interface BCD input to LED display.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ Surface leakage current is a part of
reverse current
forward current
reverse breakdown
forward breakdown

⇒ The advantages of flash memory over EEPROM are
higher density
lower cost
both higher density and lower cost
none of the above

⇒ Two coils X and Y have self inductances of 5 mH and 10 mH and mutual inductance of 3 mH. If the current in coils X change at a steady rate of 100 A/s, the emf induced in coil Y is
0.3 V
0.5 V
1 V
1.5 V

⇒ An 8156 has A₁₅ connected to its CE input. A₁₄ to A₈ are unconnected, and AD₇ to AC₀ are connected ignoring shadows, what are the RAM locations?
(4000)_H - (40FF)_H
(8000)_H - (80FF)_H
(8000)_H - (40FF)_H
Any of the above

⇒

Assertion (A): In loss of charge method, it is preferable to use an electronic voltmeter.

Reason (R): The resistance of electronic voltmeter is very high.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ Two rectangular waveforms of duration t₁ and t₂ seconds are convolved. What is the shape of the resulting waveform?
Triangular
Rectangular
Trapezoidal
Semi-circular

⇒

Match the following:

	List I (Camera pick up tubes)		List II (Developed by)
A.	CCD charger	1.	Toshiba
B.	New vicon	2.	Philips
C.	Plumbicon	3.	Matushita
D.	Chalnicon	4.	RCA

A-3, B-4, C-1, D-2
A-4, B-3, C-2, D-1
A-4, B-3, C-1, D-2
A-1, B-2, C-3, D-4

⇒ Harmonic distortion analyser
measures amplitude of each harmonic
measures rms value of fundamental frequency component
measures rms value of all harmonics except fundamental frequency
displays rms value of each harmonic on screen of CRO

⇒ The advantage of pulse modulation is
the transmitted power can be concentrated into short bursts
the time intervals between pulses can be filled with sample values from other message
pulse wave may obtain appreciable D.C. and low frequency content
all of the above

⇒ In the circuit, shown the current I marked is give
2.22 A
1.78 A
4.44 A
0.0833333333333333

⇒ Which of the following statement is wrong?
A depletion type N-channel MOSFET conducts even when V_GS = 0
A BJT is very sensitive to radiation whereas FET is relatively immune
Bipolars need higher supply voltage than FETs
Both N-channel as well as p-channel JFETs work in the depletion mode

⇒ In N-type semiconductor
electrons are majority carriers while holes are minority carriers
electrons are majority carriers while holes are majority carriers
both electrons as well as holes are majority carriers
both electrons as well as holes are minority carriers

⇒ If temperature increases by about 50°, the resistance of thermistor changes to
half of its initial value
twice of its initial value
eight times of its initial value
one eight of its initial value

⇒

Assertion (A): In a push pull circuit each transistor stays in the active region for one half cycle

Reason (R): A push pull amplifier has low distortion

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ In a linear op-amp circuit
the product of gain and bandwidth is constant
input can be dc only
input can be ac only
saturation may occur

⇒ The characteristic impedance of loss less transmission line is
L/R
L/C
1/LC
C/L

⇒ The directivity of 20 turn helix having a = 12° circumference equal to one wavelength, will be
1.8 dB
6 dB
12 dB
18 dB

⇒ For the 8085 assembly language program given below, the content of the accumulator after the execution of the progra
00H
45H
67H
E7H

⇒ A sample of N type semiconductor has an electron density of 6.25 x 10¹⁸/cm³ at 300 K. If intrinsic concentration of carriers in this sample is 2.5 x 10¹³/cm³ at this temperature, the hole density is
10⁶ / cm³
10⁸ / cm³
10¹⁰ / cm³
10¹² / cm³

⇒ Which of the following statement about TRIAC is incorrect?
It is not particularly suited to A.C. or mains power control
Any one of its main terminals can be used either as cathode or as anode
It can be triggered in response to both positive and negative gate terminals
None of the above

⇒ The signals in 8086 are classified into
minimum mode and maximum mode
decrement mode and increment mode
low mode and high mode
none of the above