Question is ⇒ In FM, the frequency deviation is, Options are ⇒ (A) always constant, (B) directly proportional to modulating frequency, (C) inversely proportional to modulating frequency, (D) proportional to amplitude of modulating signal, (E) , Leave your comments or Download question paper.

Question is ⇒ In FM, the frequency deviation is, Options are ⇒ (A) always constant, (B) directly proportional to modulating frequency, (C) inversely proportional to modulating frequency, (D) proportional to amplitude of modulating signal, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In FM, the frequency deviation is
A.	always constant [Wrong Answer]
B.	directly proportional to modulating frequency [Wrong Answer]
C.	inversely proportional to modulating frequency [Wrong Answer]
D.	proportional to amplitude of modulating signal [Correct Answer]
View Answer 2 -3 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The trignometric Fourier series of an even function of time does not have
dc term
cosine term
sine term
odd harmonic terms

⇒ Consider the Boolean expression X = ABCD + ABCD + ABCD + ACBD The simplified form of X is
C + D
BC
CD
B

⇒ Hay bridge is suitable for measuring inductance of which one of the following inductors?
Having Q value less than 10
Having Q value greater than 10
Having any value of Q
Having phase angle of reactance very large

⇒

Assertion (A): A transistor requires a continuous base signal for conduction but a thyristor requires a gate pulse.

Reason (R): Transistor find widespread application in power electronic circuits.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The statement ! (b < 5) in C means
b = 5
b > 5
b > = 5
none of the above

⇒ The properties of JFET resemble those of
thermionic values
N-P-N transistors
P-N-P transistors
unijunction transistor

⇒ An incremental model of a solid state device is one which represents the
ac property of the device at desired operating point
dc property of the device at all operating points
complete ac and dc behaviour at all operating points
ac property of the device at all operating points

⇒ Crompton potentiometer has
14 coils and a slide wire all having the same resistance
14 coils and a slide wire but the resistance of slide wire is half that of each coil
14 coils each of different resistance
14 coils out of which 7 coils have resistance which is twice that of remaining 7 coils

⇒ According to maximum power transfer theorem, if the load is inductive, the source should be
inductive
capacitive
resistive
any of the above

⇒ The manufacturing technique used to manufacture strip type transmission line is
photoetching technique
oxidation technique
cladding
epitaxial

⇒ A sinusoidal ac voltage of amplitude 100 V is applied to a rectifying device which offers 10 Ω resistance in forward direction and infinite resistance in reverse direction. The reading on hot wire ammeter will be
0.416666666666667
0.208333333333333
3.185 A
1.414 A

⇒ In FSK no synchronous carrier is needed at the receiver
TRUE
FALSE
depend on distance
none

⇒

Assertion (A): Tie set schedule is used in nodal analysis.

Reason (R): Loop currents are fictitious quantities.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ An R-L series circuit is excited by a voltage v(t). The circuit was initially relaxed. Which of the following sources of v(t) would cause maximum current at t = 0⁺?
unit step
unit impulse
unit ramp
unit step plus unit ramp

⇒ The addressing mode depicted in the given figur
direct
register
register indirect
immediate

⇒ Pulse stuffing is used in
synchronous TDM
asynchronous TDM
Any TDM
All

⇒ It is desired to route data from many registers to one register. The device needed is
decoder
multiplexer
demultiplexer
counter

⇒ Simplify : A + B + A B + (A + B)AB + C(B + AB)
B + A
C
C
1

⇒ The converter whose conversion time is independent of number of bits is
dual stope
counter type
parallel conversion
successive approximation

⇒ In the given figure the input frequency f = 10(1/2 p
0 dB
3 dB
-3 dB
-20 dB

⇒

Assertion (A): Atomic number of sodium is 11.

Reason (R): Sodium has a body centred cubic lattice.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ In the circuit shown in the figure, steady-state was reached when the switch S was open. The switch was closed at t = 0. The initial value of the current through the capacitor 2
zero
0.0416666666666667
0.0833333333333333
0.125

⇒ Which of the following equations satisfy Maxwell's equations?
E_x = E_y = 0, E_z = cos (y - ct)
E_x = E_y = 0, E_z = cos (y- ct)
F_y = cos (y - ct), E_x = E_z = 0
None of these

⇒ Which of these has a magnetic brake?
Thermocouple ammeter
Energy meter
Dynamometer wattmeter
Frequency meter

⇒ The signal input to a given amplifier is made up of 100 mΩ signal power and 1 mΩ noise power. The amplifier contributes an additional 100 mΩ of noise and has a power gain of 20 dB. The input signal-to noise ratio is
2
10
20
100

⇒ In an integrated circuit the SiO₂layers provide
electrical connection to external Ckt.
physical strength
isolation
conducting path.

⇒ In a CE amplifier
both ac and dc load lines have the same slope
the ac load line has more slope than dc load line
the ac load line has less slope than dc load line
the two load lines may have slope more than the other

⇒ Giga watt is equal to
10¹² W
10⁹ W
10⁶ W
10³ W

⇒ Three point tracking can be achieved with
gang condenser
variable selectivity
paddar capacitor
any of the above

⇒ In a CE amplifier the dc load line is the same as ac load line when
ac collector resistance and dc collector resistance are equal
ac collector resistance and dc emitter resistance are equal
ac collector resistance is very high
ac collector resistance is one half of dc collector resistance