Question is ⇒ In floating point representation, mantissa is expressed in, Options are ⇒ (A) excess 3 notation, (B) gray code, (C) excess 32 notation, (D) 2's complement, (E) , Leave your comments or Download question paper.

Question is ⇒ In floating point representation, mantissa is expressed in, Options are ⇒ (A) excess 3 notation, (B) gray code, (C) excess 32 notation, (D) 2's complement, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In floating point representation, mantissa is expressed in
A.	excess 3 notation [Wrong Answer]
B.	gray code [Wrong Answer]
C.	excess 32 notation [Correct Answer]
D.	2's complement [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ To ensure that only dominant mode TE₁₀ is allowed to propagate in an air filled rectangular waveguide, the lower frequency limit and upper frequency limit are
about 25% above f_c for TE₁₀ and 5% below f_c for TE₂₀ mode respectively
about 50% above f_c for TE₁₀ and 25% below f_c for TE₂₀ mode respectively
about 25% above f_c for TE₁₀ and 25% below f_c for TE₂₀ mode respectively
none of the above

⇒ For the K map of the given figure the simplified Boolean expressio
A B + A B
B
A
AB

⇒ For static electric and magnetic fields in an homogenous source-free medium, which of the following represents the correct form of Maxwell's equations?
Δ.E = 0
Δ.E = 0
Δ x E = 0
Δ x E = 0

⇒ Which of the following is same in AM and FM receivers?
Demodulator
AGC
IF amplifier
All of the above

⇒ Which of the following can provide two or more voice circuits with the same carrier?
SSB
Carrier reinsertion
Lincompex
Independent side band system

⇒ The minimum gate source voltage that creates the n-type inversion layer is called
cut off voltage
on voltage
threshold voltage
zener voltage

⇒ The circuit in figure, the switched on at t = 0. After a long time the current through 5 Ω resistanc
0.0416666666666667
0.166666666666667
0.416666666666667
0

⇒ A h is the unit of quantity of electricity.
TRUE
FALSE

⇒ In a DM system, the granular noise occurs when modulating signal
decrease Rapidly
increase
has high frequency component
change within step size

⇒ With negative feedback the closed loop gain is always less than open loop gain.
TRUE
FALSE

⇒ In the given circuit, the switch has been in position 1 for quite a long time. At t = 0 the switch is moved to position 2. At this position what is the time const
0.1 s
1 s
0.11 s
1.11 s

⇒

Assertion (A): A TRIAC is a bidirectional SCR.

Reason (R): A TRIAC is a four layers 3 terminal device and can conduct in both directions.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In a CE amplifier the output coupling capacitor is short circuited. The dc collector voltage
will increase
may increase or decrease
will remain the same
will decrease

⇒ MUF is depend upon
electron density of the ionospheric layer
11 year sun spot cycle
received frequency by receiver
height of ionospheric layer

⇒ Choose the correct option
var (X) = σ_x²
σ² = E(X²) - μ²
var (CX) = C² Var (X)
all

⇒ An inductor filter has a ripple that __________ with load resistance and consequently is used only with relatively __________ load currents.
decreases, low
decreases, high
increases, low
increases, high

⇒ How many JK flip-flops are needed to make a 4-bit shift register?
2
4
6
8

⇒ The five flags in 8085 are designated as
Z, CY, S, P and AC
D, Z, S, P, AC
Z, C, S, P, AC
Z, CY, S, D, AC

⇒ Beamwidth of an antenna depends upon
shape of radiation pattern
dimensions
wavelength
all of the above

⇒ Two sinusoidal waves 1 and 2 have peak values V_m1 and V_m2. Wave 1 is leading wave 2 by ∠θ. Which of the following is correct?
v₁ = V_m1 sin θ and v₂ = V_m2 cos θ
v₁ = V_m1 sin ωt and v₂ = V_m2 sin (ωt - θ)
v₁ = V_m1 sin (ωt + θ/2) and v₂ = V_m2 sin ωt
none of the above

⇒ In following figure, the initial contents of the 4-bit serial in parallel out, right shift, shift register as shown in figure are 0110. After 3 clock pulses the contents of the shift register wil
0
101
1010
1110

⇒

Assertion (A): A high dv/dt may cause triggering of a thyristor.

Reason (R): A high dv/dt results in charging current in the thyristor.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Efficiency of a half wave diode rectifier is less than 40%.
TRUE
FALSE

⇒ In VHS format each video head is tilted from azimuth by
20°
10°
6°
1°

⇒ What does the instruction 'PCHL' in 8085 do?
Load the program counter with contents of register pair H L
Double the contents of register pair H L
Shift the contents of register pair H L by one bit to the right
Shift the contents of register pair H L by one bit to left

⇒ Which of the following are true for relative dielectric constant?

It is dimensionless.
It is equal to 1 for vacuum.
It is equal to 1 for all substances.

1 and 2 only
2 and 3 only
1 and 3 only
1, 2 and 3

⇒ For the floating point numbers 1.81 x 10^-29 and 0.0152 x 10¹⁸ the normalised forms are
0.181 x 10^-28 and 0.152 x 10¹⁷respectively
18.1 x 10^-30 and 0.152 x 10¹⁷ respectively
0.181 x 10^-28 and 1.52 x 10¹⁶ respectively
None of the above

⇒ In a microprocessor, the service routine for a certain interrupt starts from a fixed location of memory which cannot be externally set, but the interrupt can be delayed or rejected. Such an interrupt is
non-maskable and non-vectored
maskable and non-vectored
non-maskable and non-vectored
maskable and vectored

⇒ In figure, V_EB = 0.6 V, β = 99. Then V_C and I_C
9.3 V and 1.98 mA respectively
4.6 V and 1.98 mA respectively
9.3 V and 0.02 mA respectively
4.6 V and 0.02 mA respectively

⇒ If 1.5% of the output of an amplifier is feedback positively to the input, the minimum gain required of the amplifier for oscillations to occur, is
16.6
44.4
66.6
75