Question is ⇒ In floating point number 0110100000010101, the exponent is equal to __________ <sub>10</sub>, Options are ⇒ (A) 11, (B) -11, (C) 10, (D) -10, (E) , Leave your comments or Download question paper.

Question is ⇒ In floating point number 0110100000010101, the exponent is equal to __________ <sub>10</sub>, Options are ⇒ (A) 11, (B) -11, (C) 10, (D) -10, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In floating point number 0110100000010101, the exponent is equal to __________ ₁₀
A.	11 [Wrong Answer]
B.	-11 [Correct Answer]
C.	10 [Wrong Answer]
D.	-10 [Wrong Answer]
View Answer 1 -3 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Figure shows characteristics curves for bipolar transistor. These curves
output characteristics of n-p-n transistor (common base)
output characteristics of p-n-p transistor (common base)
output characteristics of n-p-n transistor (common emitter)
output characteristics of p-n-p transistor (common emitter)

⇒ Which of the following modes of transmission will not be supported by a rectangular waveguide?
TE₁₅
TE₁₂
TM₁₁
TM₁₀

⇒ The electrolyte in nickel cadmium cell is dilute potassium hydroxide.
TRUE
FALSE

⇒ In which one of the following types of analog to digital convertors the conversion time is practically independent of the amplitude of the analog signal?
The dual slope integrating type
Successive approximation type
Counter ramp type
Tracking type

⇒ Which of the following is NOT associated with a p-n junction?
Junction capacitance
Charge Storage Capacitance
Depletion Capacitance
Channel Length Modulation

⇒ Assuming accumulator contain A 64 and the carry is set (1). What will register A and (CY) contain after CMA?
6 AH, 1
6 AH, 0
59 H, 0
9 H, 0

⇒ Coupling and bypass filters can be a source of
low-frequency parasitics
high-frequency parasitics
carrier frequency parasitics
none of the above

⇒ A rectifier circuit has load resistance R. It uses a capacitance filter having capacitance C. For low ripple in the output
RC should be 1
RC should be low
RC should be high
RC should be neither low nor high

⇒ In an R-L circuit excited by a battery of voltage E, the current and voltage across resistor are 1- e^-t and 2(1 - e^-t) respectively. If there were an initial current of 2 A in the inductance, the voltage across resistance would have been
1 - e^-t
2 - 2e^-t
2 + 2e^-t
4 - 4e^-t

⇒ The given figure shows a pole zero diagram. The transfer function G(j1
0.5 ∠0
2.7 ∠- 31°
2 ∠45°
2 ∠- 67.4°

⇒ The output y(t) of a linear time invariant system is related to its input x(t) by the following equation y(t) = 0.5x(t - t_d + 1) + x(t - t_d) + 0.5 x(t - t_d + 7). The filter transfer function H(ω) of such a system is given by
(1 + cos ωt)e^-jωt d
(1 + 0.5 cos ωt)e^-jωt d
(1 + cos ωt)e^jωt d
(1 - 0.5 cos ωt)e^-jωt d

⇒ An electromagnetic wave can be completely guided by a dielectric rod or slab.
TRUE
FALSE

⇒ For a photoengraving the mask used is
master mask
slave mask
working mask
photo mask

⇒ If a small amount of Cu is added to Ni conductor, then
resistivity of Ni will decrease at all temperatures because Cu is a better conductor than Ni
residual resistivity of Ni at low temperature will increase as Cu atoms act as defect centres
resistivity of Ni will increase at all temperatures as Cu destroys the periodicity of Ni and acts as defects
resistivity of Ni remains the same

⇒ In some on-off controllers a differential gap is provided
to make the manufacture process easier
to prevent too often frequent operation of controller
both (a) and (b)
neither (a) nor (b)

⇒ A series resonant circuit has parameters 10 ω, 1 H and 0.1 F. It is excited by a voltage v = 100 sin ωt. At resonant frequency, the power dissipated in the circuit is
1000 W
707 W
500 W
414.14 W

⇒ The tape recorders used in homes have
common head and common amplifier system for recording and playback
different heads and amplifiers for recording and playback
same head but different amplifiers for recording and playback
different heads but same amplifier for recording and playback

⇒ In a J-K FF we have J = Q and K = 1. Assuming the FF was initially cleared and then clocked for 6 pulses, the sequence at the Q output wil
10000
11001
10010
10101

⇒ The passband of the tuned circuits of a radio receiver should be equal to
20 kHz
455 kHz
1455 kHz
more than 455 kHz

⇒ Which of the following is not a necessary advantage of negative feedback system?
Feedback improves speed of response
Feedback improves stability
Feedback reduces effect of variations in system parameters
Feedback reduces the effect of external disturbances

⇒ Directive gain is
a power ratio
a voltage ratio
a current ratio
a distance ratio

⇒ Leak type bias is used in plate modulated class C amplifier to
increase the bandwidth
prevent over modulation
prevent excessive grid current
prevent tuned circuit damping

⇒ Common base configuration is little used because
it has low input impedance
it has high input impedance
it does not heat up
it has very high gain

⇒ In a step down chopper using pulse width modulation, T_on = 3 x 10^-3 and T_off = 1 x 10^-3 s. The chopping frequency is
333.33
250
500
1000

⇒ The switch board instruments
should be mounted in vertical position
should be mounted in horizontal position
should be mounted at about 45°
should be mounted at about 80°

⇒ A single layer air cored coil has n turns and inductance L. If a new coil is formed by having 2n turns while keeping the coil length and diameter the same, the new inductance is
0.5 L
L
2 L
4 L

⇒ Maxwell's curl equation for the static electric field E can be expressed as
Δ x E = 0
Δ x E = constant
Δ - E = constant
Δ . E = 0

⇒ A periodic voltage has following values for equal time intervals changing suddenly from one value to next : 0, 5, 10, 20, 50, 60, 50, 20, 10, 5, 0, - 5, - 10
42.2 V
19.098 V
38.2 V
none of these

⇒ The dual of a loop is
twig
node pan
mesh
tree

⇒ If i_b is plate current, e_b is plate voltage and e_c is grid voltage the v-i curve of a vacuum triode
0.5 and 1
- 2 and 1
30 and 1
30 and 1.5