Question is ⇒ In figure, Z1 = 200∠60° Ω, Z2 = 400∠ - 90° Ω, Z3 = 300∠0°. Then Z4 for bridge to be balanced, Options are ⇒ (A) 150∠30° Ω, (B) 400∠ - 90° Ω, (C) 300∠90° Ω, (D) 600∠ - 150° Ω, (E) , Leave your comments or Download question paper.

Question is ⇒ In figure, Z1 = 200∠60° Ω, Z2 = 400∠ - 90° Ω, Z3 = 300∠0°. Then Z4 for bridge to be balanced, Options are ⇒ (A) 150∠30° Ω, (B) 400∠ - 90° Ω, (C) 300∠90° Ω, (D) 600∠ - 150° Ω, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In figure, Z₁ = 200∠60° Ω, Z₂ = 400∠ - 90° Ω, Z₃ = 300∠0°. Then Z₄ for bridge to be balanced
A.	150∠30° Ω [Wrong Answer]
B.	400∠ - 90° Ω [Wrong Answer]
C.	300∠90° Ω [Wrong Answer]
D.	600∠ - 150° Ω [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a class C operation V_CC = 30 V and V_CE(sat) = 2 V. The efficiency is
0.9375
0.88
0.0666
0.0333

⇒ In thermal ohm's law, temperature and power loss are analogous to
V and I respectively of ohm's law
I and V respectively of ohm's law
R and V respectively of ohm's law
I and R respectively of ohm's law

⇒

Assertion (A): In 8085 WR and RD signals are active high.

Reason (R): LOW WR means write operation and low RD means read operation.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ A directional coupler is used to determine
r_v
r_v and VSWR
L and C
wave velocity

⇒ Which of the following is used as a passive component in electronic circuits?
Tunnel diode
Capacitor
Transistor
Vacuum tube

⇒ If an additional two diodes were used to connect the 1 kW load across a bridge rectifier circuits, utilizing the full secondary of the transformer, how much d.c. power could be delivered using a transformer with the rating of 105 VA?
35 W
60 W
85 W
100 W

⇒ When a transistor is to be at a temperature above 25°C
smaller heat sink be provided
maximum power rating be derated
biasing circuit must be strengthened
earth connections must be connected through a resistor

⇒ A class D chopper
can operate in first quadrant only
can operate in second quadrant only
can operate in either first or fourth quadrant
can operate in all the quadrants

⇒ If B is the bandwidth, the thermal noise voltage is proportional to
B
B^0.5
B^1.5
B²

⇒ The diffusion current is proportional to
applied electric field
concentration gradient of charge carrier
square of the electric field
cube of the applied electric field

⇒ Consider the following statem
2 and 3
1 only
2 and 4
none

⇒ In the given figure the input frequency f = 10(1/2 p
0 dB
3 dB
-3 dB
-20 dB

⇒ (9)₁₁ x (9)₁₃ x(9)₁₅ = (?)₁₆
933
2D9
339
9AB

⇒ A Charge Couple Device (CCD) is a
RAM
sequential accessed memory
content addressable memory
read only memory

⇒ A circuit is fed by two sources of different frequency and magnitudes 100 ∠0° V and 50 ∠30°V. The current in a particular branch is 10 ∠20° A. If the magnitudes of the sources are changed to 200 ∠0° V and 100 ∠0° V, the current in that branch should be
20 ∠20° A
10 ∠20° A
14.14 ∠20° A
10 ∠- 20° A

⇒ Fermi level in intrinsic semiconductor is at the centre of forbidden energy band.
TRUE
FALSE

⇒ In the circuit of figure the current through L at t = &infin
0
0.416666666666667
6.67 A
5.1 A

⇒ In high power radars, which of the following are used for switching?
Power diode
Power BJT
Power MOSFET
Thyristor

⇒ For ideal performance, a filter should be terminated in characteristic impedance.
TRUE
FALSE

⇒

Assertion (A): Derivative control action cannot be used alone.

Reason (R): Derivative control action is effective only during transient periods.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ The current flow in a semiconductor is due to
holes
electrons
holes and electrons
holes, electrons and ions

⇒

Assertion (A): Silicon is the most favoured semiconductor material.

Reason (R): PIV for silicon diode is more than that for germanium diode.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ The speeds used in recording audio programs in house hold recorders are
38 cm/s and 9.5 cm/s
38 cm/s and 19 cm/s
9.5 cm/s and 4.75 cm/s
38 cm/s and 4.75 cm/s

⇒ The derating factor, for ambient temperature higher than specified, for a transistor is about
2.5 mW/°C
0.5 mW/°C
10 mW/°C
20 mW/°C

⇒ In a complex wave, the negative half of the wave is a reproduction of the positive half wave. Then
the wave contains only fundamental and third harmonic
the wave does not contain even harmonics
the wave does not contain odd harmonics
the wave does not contain triple harmonics

⇒ The maximum phase difference between the applied voltage and current in a RLC series current with finite values of R, L, C, and f can be
less than 90°
less than 45°
180°
30°

⇒ A universal shift register can shift
from left to right
from right to left
both from left to right and right to left
none of the above

⇒ A 4 bit shift register is initialized to value 1000 for (Q₃, Q₂, Q₁, Q₀). The D input is derived from Q₀, Q₂ and Q₃ through two XOR gates as shown in figure. The pattern 1000 will appea
3rd pulse
7th pulse
6th pulse
4th pulse

⇒ For a directional coupler the power is in the ratio of
40 dB
30 dB
20 dB
10 dB

⇒ The noise figure of klystron amplifier is about
25 dB
3 dB
zero
1 dB