Question is ⇒ In figure what is the base current if V<sub>BE</sub> = 0, Options are ⇒ (A) 10 mA, (B) 9.3 mA, (C) 10 μA, (D) 9.3 μA, (E) , Leave your comments or Download question paper.

Question is ⇒ In figure what is the base current if V<sub>BE</sub> = 0, Options are ⇒ (A) 10 mA, (B) 9.3 mA, (C) 10 μA, (D) 9.3 μA, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In figure what is the base current if V_BE = 0
A.	10 mA [Wrong Answer]
B.	9.3 mA [Wrong Answer]
C.	10 μA [Wrong Answer]
D.	9.3 μA [Correct Answer]
View Answer 1 -2 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Adder is a combinational logic circuit.
TRUE
FALSE

⇒ In a linear circuit, the superposition principle can be applied to calculate the
voltage and power
voltage and current
current and power
voltage, current and power

⇒ The radiation resistance of a resonant long wire antenna of half wavelength (λ/2) is given
73 Ω
120 p
377 Ω
7.3 Ω

⇒

Assertion (A): A large negative feedback is deliberately introduced in an amplifier to make its gain independent of variation is in parameters of active device and other components.

Reason (R): A large negative feedback results in a high value of return difference compared to unity which makes the feedback gain inversely proportional to feedback factor.

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ In a purely inductive circuit, the current __________ the voltage by __________ .
lags, 0°
leads, 90°
lags, 90°
lags, 45°

⇒ For input and later stages, BI-FET op-amp use
JFETs and MOSFETs respectively
MOSFETs and JFETs respectively
JFETs and BJTs respectively
BJTs and JFETs respectively

⇒ Permittivity has the units of F/m.
TRUE
FALSE

⇒ The eign values of n x n matrix A are the root of the characteristic equation 1λI - AI = 0
TRUE
FALSE

⇒ The first geostationary satellite was named
Intelsat I
Intelsat II
Intelsat III
Early bird

⇒ Consider the following statements about Rhombic antenna

It is non resonant
It is a broad band antenna
It is ideally suited for HF transmission

Which of the above are correct?
1, 2, 3
1, 3 only
2, 3 only
1 only

⇒ Kirchoff's laws are applicable to
steady state conditions only
transient conditions only
both steady state and transient condition
both steady state and transient condition but with some constraints

⇒ Mc Murray full bridge inverter uses
4 thyristors and 2 diodes
4 thyristors and 4 diodes
8 thyristors and 4 diodes
8 thyristors and 8 diodes

⇒ n-type semiconductors
are negatively charged
are produced when indium is added as impurity to germanium
are produced when phosphorus is added as impurity to silicon
none of the above

⇒ When microprocessor processes both positive and negative numbers, the representation used is
l's complement
2's complement
signed binary
any of the above

⇒ With respect to transmission parameters, which one of the following is correct?
A and B are dimensionless
B and C are dimensionless
A and D are dimensionless
B and D are dimensionless

⇒ In the circuit shown, the device connected to Y5 can have address in the r
2000 - 20FF
2D00 - 2DFF
2E00 - 2EFF
FD00 - FDFF

⇒ A 60 W, 23 V bulb is used for 45 minutes. The electrical energy consumed in commercial units is
2700 units
0.45 units
4.5 units
0.045 units

⇒ What is the minimum value of VSWR that may exist on a transmission line?
Less than zero
Zero
One
10

⇒ In a p-n-p transistor operating in forward active mode
base is positive with respect to emitter and collector
base is negative with respect to emitter and collector
emitter is positive with respect to base and base is positive with respect to collector
emitter is negative with respect to base and base is positive with respect to collector

⇒ Consider the following circuit configuration

common Emitter
common Base
emitter follower
emitter follower using Darlington pair.

The correct sequence in increasing order of I/P impedance of these configuration:
2, 1, 4, 3
1, 2, 4, 3
2, 1, 3, 4
1, 2, 3, 4

⇒

Assertion (A): The impedance of a series resonant circuit is minimum at resonance.

Reason (R): Resonance condition implies unity power factor condition.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ ∈₀ has no other physical meaning than that of a fundamental conversion factor.
TRUE
FALSE

⇒ The dc output voltage from a power supply
increases with higher values of filter capacitance and decreases with more load current
decreases with higher values of filter capacitance and increases with more load current
decreases with higher values of filter capacitance as well as with more load current
increases with higher values of filter capacitance as well as with more load current

⇒ Ferrities are particularly suited for high frequency applications because of their
low distortion
low eddy current loss
high conductivity
high mobility

⇒ For a wave propagating in air filled rectangular waveguide.
guide wavelength is never less than free space wavelength.
wave impedance is never less than the free space impedance
TEM mode is possible if the dimension of the waveguide are properly chosen.
propagation constant is a real quantity.

⇒ For a system with transfer funct
2.828
5.2915
5.088
cannot be determined

⇒ The trapezoidal pattern of figure is obtained when examining an AM wave by an oscilloscope. Modulation factor of the wave
0.33
0.5
2
1

⇒ Which of the following is a valid integer variable in FORTRAN 77?
ALPHA
NEXT
BANGLORE
ABC

⇒ The number of computer viruses is some thousands.
TRUE
FALSE

⇒ An ideal current source has
infinite source resistance
zero source resistance
large value of source resistance
finite value of source resistance