Question is ⇒ In figure, V<sub>G</su, Options are ⇒ (A) 2.22 V, (B) 22.2 V, (C) 0.22 V, (D) 0.022 V, (E) , Leave your comments or Download question paper.

Question is ⇒ In figure, V<sub>G</su, Options are ⇒ (A) 2.22 V, (B) 22.2 V, (C) 0.22 V, (D) 0.022 V, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In figure, V_G
A.	2.22 V [Correct Answer]
B.	22.2 V [Wrong Answer]
C.	0.22 V [Wrong Answer]
D.	0.022 V [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The power gain of a half-wave dipole with respect to an isotropic radiator is
2.15 db
3 db
4.15 db
6 db

⇒ Epitaxial growth is used in IC_s
because it produces low parasitic capacitance
because it yields back to back isolating pn Junction
to grow single crystal n doped silicon on a single crystal P-type substrate
to grow Selectivity single crystal P doped silicon of one resistivity on a P type substrate of a different resistivity

⇒ Which of the following is not an omnidirectional antenna?
Log periodic
Half-wave dipole
Discone
Marconi

⇒ For transmission-line matching over range of frequencies, it is best to use a
single stub of adjustable position
double stub
broadband directional coupler
balun

⇒

Assertion (A): If integral control action is included in the controller the offset can be eliminated.

Reason (R): Integral control action may lead to oscillatory response.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ A moving iron instrument can be used for
dc only
ac only
both dc and ac
dc and high frequency ac

⇒ To find current in a resistance connected in a network, Thevenin's theorem is used V_TH = 20 V and R_TH = 5 Ω. The current through the resistance
is 4 A
is 4 A or less
is less than 4 A
may be 4 A or less or more than 4 A

⇒

Assertion (A): If power gain doubles the power gain increases by 3 dB

Reason (R): The bel power gain of cascaded stages is equal to sum of each bel power gain

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ The output of the 74 series of TTL gates is taken from a BST in
totem pole and common collector configuration
either totem pole or open collector configuration
common base configuration
common collector configuration

⇒ Transport lag usually exists in
thermal systems
hydraulic systems and thermal systems
pneumatic systems
thermal, hydraulic and pneumatic systems

⇒ For the two port of figure, z_{2226/7 Ω
6/7 Ω
2/3 Ω
1 Ω}

⇒ Strip lines are used at
microwave frequency
low frequency
High frequency
at any frequency

⇒ In high power AM transmission modulation is done at
IF stage
RF power
buffer stage
oscillator stage

⇒

Assertion (A): Electric coupling, magnetic coupling and ground loop can cause unwanted high frequency oscillations.

Reason (R): Hartley oscillator uses a tapped inductor

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ Twelve resistance each 2 ohm are connected to form a cube, one resistance being in each arm of cube. The resistance between any two diagonally opposite comers is
1 Ω
2 Ω
4 Ω
8 Ω

⇒ The main advantage of CC amplifier is
High input impedance and low output impedance
Low input impedance and high output impedance
High voltage gain
High current gain

⇒ If an amplifier with gain of - 100 and feedback of β = - 0.1 has a gain change of 20% due to temperature the change in gain of the feedback amplifier will be
0.0002
0.02
0.001
0.0001

⇒ When a JFET is cut off, it's like an __________ switch and when it is saturated, it's like a __________ switch.
closed, open
open, closed
open, open
closed, closed

⇒

Assertion (A): In C it is possible for functions to call themselves.

Reason (R): C makes use of 'Pointers'.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ In which mode of circular waveguide does the attenuation continuously decrease as frequency is increased?
TE₀₁
TE₁₁
TE₀₅
TE₂₁

⇒ In transistor radio receivers the number of IF amplifier stages are
1
2
4
6

⇒ In a modified series inverter with two inductors and two capacitors, the load current
has 2 parallel paths
has only one parallel path
can have three parallel paths
has four parallel paths

⇒ The power consumption of a present day colour TV receiver is about
8 W
80 W
200 W
400 W

⇒ For a photoconductor with equal electron and hole mobilities and perfect ohmic contacts at the ends, an increase in illumination results in
a change in O.C. voltage
a change in S.C. current
a decrease in resistance
an increase in resistance

⇒ A coil of resistance R and inductance L is connected in series with 5 μF capacitor. The source frequency is equal to resonance frequency and circuit current is 0.5 A. Another 5 F capacitor is connected in parallel with the above capacitor. The circuit current will be
0.5 A
more than 0.5 A
less than 0.5 A
0.5 A or less

⇒ A full wave rectifier circuit using centre tapped transformer and a bridge rectifier are fed at 100 V, 50 Hz. The frequencies of outputs in these two rectifiers are
100 Hz each
50 Hz each
100 Hz and 50 Hz
50 Hz and 100 Hz

⇒ Voltage standing wave pattern in a loss less transmission line with characteristic impedance 50 Ω and a resistive load is shown in the figu
50 Ω
200 Ω
12.5 Ω
0 Ω

⇒

Assertion (A): In direct addressing the address of operand is specified in the instruction.

Reason (R): Direct addressing is also called absolute addressing.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ The current rating of dc tachogenerator is usually
small
high
medium
either (b) or (c)

⇒ Current derating may be necessary when thyristors are operating in
series
parallel
series or parallel
none of the above