Question is ⇒ In figure, V<sub>C</sub> is approximately equa, Options are ⇒ (A) 2 V, (B) 4.6 V, (C) 8 V, (D) 7.6 V, (E) , Leave your comments or Download question paper.

Question is ⇒ In figure, V<sub>C</sub> is approximately equa, Options are ⇒ (A) 2 V, (B) 4.6 V, (C) 8 V, (D) 7.6 V, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In figure, V_C is approximately equa
A.	2 V [Wrong Answer]
B.	4.6 V [Wrong Answer]
C.	8 V [Correct Answer]
D.	7.6 V [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Consider the following state
1 only
1 and 2
2 only
3 only

⇒ A full wave bridge diode rectifier uses diodes having forward resistance of 50 ohms each. The load resistance is also 50 ohms. The voltage regulations is
0.2
0.5
1
2

⇒ When a lead acid battery is fully charged the colours of its positive and negative plates are
grey and dark brown
dark grey and brown
grey and brown
dark brown and grey

⇒ In a transistor push pull amplifier
there is no dc present in the output
there are no even harmonics in the output
both (a) and (b)
neither (a) nor (b)

⇒ A narrow band noise n(t) has symmetrical spectrum and has power density spectrum 0.2 x 10^-6. The power density of quadrature component is
0.2 x 10^-6
10^-7
4 x 10^-7
5 x 10^-8

⇒ Consider the following statement: At finite temperature, magnetic dipoles in a material are randomly oriented giving low magnetization. When magnetic field H is applied, the magnetization?

Increases with H
Decreases with H
Decreases with temp for constant H

Which of the statement given above is/are correct?
1
2
2, 3
1 and 3

⇒ In a channel voice coder, the outputs of sixteen 20 Hz low pass filters are sampled, multiplexed and A/D converted. If sampling is at 40 samples/second and 3 bits/sample represents each voltage sample, the bit rate is about
1.9 k bits/sec
0.95 k bits/sec
3.8 k bits/sec
7.6 k bits/sec

⇒ Amplification of ultrasonic waves is possible in a piezoelectric semiconductor under applied electric field. The basic phenomenon involved is known as
electrostriction
acousto-optic interaction
acousto-electric interaction
stimulated Brillouin scattering

⇒ Considerable ionization occurs between the range
50 km to 400 km
100 to 400 km
50 km to 250 km
10 to 50 km

⇒ If the average power of radar transmitters is 2 kW and the peak power of the transmitter is 1000 kW, what will be the duty cycle?
0.002
0.02
0.001
0.01

⇒ The ability of a radio receiver to discriminate between different input signals and to accept only one definite signal is called its
sensitivity
attenuation
selectivity
modulation

⇒

Assertion (A): The rms value of v = 1 + sin ωt is 1.5

Reason (R): If i = I₀ + I_1m sin ω₁t + I_3m sin 3ω₁t,
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ A multilevel decoder is more costly as compared to single level decoder.
TRUE
FALSE

⇒ At t = 0⁺, the current i_{1- V/2R
- V/4R
- V/R
zero}

⇒ One volt equals
one joule
one joule/coulomb
one coulomb/joule
none of the above

⇒ Data from a satellite is received in serial form (1 bit after another). If this data is coming at a 5 MHz rate and if the clock frequency is 5 MHz how long will it take to serially load a word in a 32-bit shift register?
1.6ms
3.2ms
6.4ms
12.8ms

⇒ At room temperature, the current in intrinsic semiconductor is due to
holes
electrons
ions
holes and electrons

⇒ The most commonly used system of modulating for telegraphy is
single tone modulation
on-off keying
frequency shift keying
pulse code modulation

⇒ Lag compensation permits a high gain at low frequencies.
TRUE
FALSE

⇒ In voltage amplifiers, the load resistance
should be a small as possible
should be as large as possible
must be equal to output impedance
must be half of output impedance

⇒ A 6 bit dual slope A/D converter uses a reference of -6v and a 1 MHz clock. It uses a fixed count of 40 (101000). Then, what will be input, if the output register shows 100111 at the end of conversion.
5.85 V
6 V
5 V
10 V

⇒

Assertion (A): When Diode used as rectifier the reverse breakdown voltage should not be exceeded.

Reason (R): A high inverse voltage can destroy a p-n junction.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ What is typical bandwidths of a 2-wire telephone line?
300 Hz to 3.4 kHz
20 Hz to 4 kHz
dc to 4 kHz
20 Hz to 20 kHz

⇒ A semi converter operates in two quadrants.
TRUE
FALSE

⇒ In telephone systems the relation between load r, number of calls initiated during a specified interval λ and average duration of a call (h) is
r = λh
r = λh²
λ = rh
h = λr

⇒ A planar graph has 6 nodes and 7 branches. The number of meshes in the dual graph is
2
3
4
6

⇒ Consider the following BJT circ
2.46 kΩ
2.88 kΩ
200 Ω
18.48 Ω

⇒ Above a certain temperature, the specific heat of a metal becomes constant. This temperature is called
Debye temperature
Curie temperature
Neel temperature
Transition temperature

⇒ In 8086 the number of lines on which data and address is multiplexed is
8
16
20
32

⇒ How many and what are the machine cycles needed for execution of MOV D, C?
1, Fetch
2, Fetch and Memory Read
2, Memory Read and Memory write
2, Fetch 4 Bus idle