Question is ⇒ In figure, the switch is closed at t = 0. At t = 0+, di/dt = 4 A/s. Then, Options are ⇒ (A) 10 V, (B) 20 V, (C) 40 V, (D) 80 V, (E) , Leave your comments or Download question paper.

Question is ⇒ In figure, the switch is closed at t = 0. At t = 0+, di/dt = 4 A/s. Then, Options are ⇒ (A) 10 V, (B) 20 V, (C) 40 V, (D) 80 V, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In figure, the switch is closed at t = 0. At t = 0⁺, di/dt = 4 A/s. Then
A.	10 V [Wrong Answer]
B.	20 V [Wrong Answer]
C.	40 V [Wrong Answer]
D.	80 V [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The transfer function of a system is given by H(s) = 1/s² (s - 2). The impulse response of the system is
(t^2* e^-2t) U(t)
(t^* e^2t) U(t)
(te^-2t) U(t)
(te^2t) U(t)

⇒ Find the electric charge required on the earth and moon to balance their gravitational attraction if the charge on the earth is 12.5 times that on the m
48.9 TC
4.89 GC
4.89 TC
48.9 GC

⇒ In the given figure x_{6de(ax₁ + bx₂ + cx₃)
(a + b + c) (x₁ + x₂ + x₃) (d + e)
(ax₁ + bx₂ + cx₃) (d + e)
a b c d e (x₁ + x₂ + x₃)}

⇒

Assertion (A): KCL is dual of KVL.

Reason (R): Node is dual of mesh.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒

Match the following:

	List I		List II
A.	Television	1.	Either AM or FM used
B.	Radio	2.	Both AM and FM are used
C.	Radar	3.	PCM is used
D.	Data Communication	4.	Digital system

A-4, B-3, C-1, D-2
A-2, B-1, C-3, D-4
A-4, B-1, C-3, D-2
A-2, B-3, C-1, D-4

⇒ If u is input, y is output and a, b are constants, the system y = au + b
is linear
is nonlinear
may be linear or nonlinear dependig on values of a and b
may be linear or nonlinear depending on value of u

⇒ The current flowing in a certain P-N junction at room temperature is 2 x 10^-7 Amp. When a large reverse biased voltage is applied. Calculate the current flowing when 0.1 volts is applied.
9 μA
10 μA
2 μA
4 μA

⇒ In commercial FM Broadcasting, A radio station transmitting the signal at 98.3 MHz, it is
carrier frequency
modulation frequency
message frequency
channel frequency

⇒ The integral of unit step function is a ramp of slope unity.
TRUE
FALSE

⇒ The frame of electric motor is connected to three plates having earthing resistance of 10 Ω, 20 Ω and 30 Ω respectively. The materials of the three plates are copper, aluminium and iron respectively. The percentage of energy dissipated by 10 Ω earthing plate
is more than 50% of total energy
is less than 50% of total energy
depends on the materials of the three plates
may be more or less than 50% of total energy

⇒ Which of the following statements about the matched filter in a communication receiver are correct?

Its impulse response depends on the signed shape
It maximizes the SNR at the detection shape.
It produces ISI.
It may produce phase error if synchronization is improper.

Select the correct answer from the codes given below:
1 and 4 only
1 and 2 only
2, 3 and 4
1, 2 and 4

⇒ Work function of oxide coated cathode is much lower than that of tungsten cathode.
TRUE
FALSE

⇒ An E transformer is a
displacement transducer
velocity transducer
acceleration transducer
pressure transducer

⇒ As compared to an ordinary semiconductor diode, a Schottky diode
has higher reverse saturation current
has higher reverse saturation current and higher cut in voltage
has higher reverse saturation current and lower cut in voltage
has lower reverse saturation current and lower cut in voltage

⇒ The dynamic characteristics of capacitive transducer are similar to those of
LP filter
HP filter
notch filter
band stop filter

⇒ Introducing a resistor in the emitter of a common amplifier stabilizes the d.c. operating point against variations in
only the temperature
only β of the transistor
both temperature and β
none of these

⇒ In TE₁₀mode the largest electric field in a rectangular wave guide, occurs
along centre line of broad wall (i.e. x = a/2)
along the broad wall (i.e. x = 0 and x = a)
either (a) or (b)
neither (a) nor (b)

⇒ The output y(t) of a linear time invariant system is related to its input x(t) by the following equation y(t) = 0.5x(t - t_d + 1) + x(t - t_d) + 0.5 x(t - t_d + 7). The filter transfer function H(ω) of such a system is given by
(1 + cos ωt)e^-jωt d
(1 + 0.5 cos ωt)e^-jωt d
(1 + cos ωt)e^jωt d
(1 - 0.5 cos ωt)e^-jωt d

⇒ The bandwidth required for amplitude modulation is
half the frequency of modulating signal
equal to the frequency of modulating signal
twice the frequency of modulating signal
four times the frequency of modulating signal

⇒ The depth of penetration at 4 MHz is 10 cm, then at 2.5 MHz it is
62.5 cm
13 cm
6.25 cm
8 cm

⇒ Measurement of radiation resistance by reflection method is suitable for
parasitic element antennas
low frequency vertical conductor antenna
all type of antennas
none of the above

⇒ A Read/Write memory chip has a capacity of 64 k bytes. Assuming separate data and address line and availability of chip enable signal, what is the minimum number of pins required in the IC chip?
28
26
24
22

⇒ For a transistor if a_dc = 0.98 and emitter current I_E is 2 mA, then base current will be
10 μA
40 μA
80 μA
200 μA

⇒ The orientation polarization of a polyatomic gas is inversely proportional to absolute temperature.
TRUE
FALSE

⇒ As applied to a flip flop the word edge triggered's means
flip flop can change state when clock transition occurs
flip flop can change state when clock signal goes from LOW to HIGH only
flip flop can change state when clock signal goes from HIGH to LOW only
none of the above

⇒ A memory system of size 16 k bytes is to be designed using memory chips which have 12 address lines and 4 data lines each. The number of such chips required to design the memory system is
2
4
8
18

⇒ In a bipolar junction transistor a_dc = 0.98, I_CO= 2 μA and 1_B = 15 μA. The collector current I_C is
635 mA
735 mA
835 mA
935 mA

⇒ The horizontal intercept of dc load line is the same as ideal
cut off point
saturation point
operating point
quasi saturation point

⇒

Assertion (A): In microprocessor 8085 instruction LXIB, 90 FF H means register B and C are loaded with upper and lower bytes to get B = 90 H and C = FFH.

Reason (R): In 8085 the stack pointer indicates which memory location is to accessed.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ In the circuit of figure the current through C at t = &infin
0.166666666666667
2.5 A
3.1 A
0