Question is ⇒ In figure, the switch is closed at t = 0. After some time i = 6A and rate of change of current was 4A/s. The value of inducto, Options are ⇒ (A) 1 H, (B) 1.5 H, (C) indeterminate, (D) 0.5 H, (E) , Leave your comments or Download question paper.

Question is ⇒ In figure, the switch is closed at t = 0. After some time i = 6A and rate of change of current was 4A/s. The value of inducto, Options are ⇒ (A) 1 H, (B) 1.5 H, (C) indeterminate, (D) 0.5 H, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In figure, the switch is closed at t = 0. After some time i = 6A and rate of change of current was 4A/s. The value of inducto
A.	1 H [Wrong Answer]
B.	1.5 H [Wrong Answer]
C.	indeterminate [Wrong Answer]
D.	0.5 H [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A P-channel MOSFET operating in the enhancement mode is characterized by V_t = - 4 V and I_DQ = - 10 mA, when V_GSQ = - 5.5 V, what will be V_GSQ if I_DQ = -15 mA and I_{D, on} = - 16 mA
- 2 V
3 V
0.13 V
1.3 V

⇒ The slope of the transfer characteristics of an N-channel JFET is
positive
negative
constantly varying
zero

⇒ When the length of antenna is a whole wavelength
the radiation at right angles is zero
the radiation at right angles is maximum
the radiation is zero in all directions
the radiation is maximum in all directions

⇒ In a BJT CE amplifier circuit the value of coupling capacitor should be such that
its reactance is small for the lowest frequency in the input and output
its reactance is high for the lowest frequency in the input and output
its reactance is zero for the lowest frequency in the input and output
its reactance is infinite for the lowest frequency in the input and output

⇒ In a JFET, the drain current is maximum when
V_GS = 0
V_GS is not zero but is slightly negative
V_GS is negative
V_GS is negative and equal to V_DS

⇒ For free space propagation
γ = a + jβ
γ = jβ
γ = a
a = β = 0

⇒

Assertion (A): Millman's theorem helps in replacing a number of current sources in parallel by a single current source.

Reason (R): Maximum power transfer theorem is applicable only for dc, circuits.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ The Z inverse of the given Z transform i
unit step
unit impulse
unit ramp
unit parabola

⇒ A lead compensator is basically a
high pass filter
low pass filter
band stop filter
none of the above

⇒ Which of the following is used to provide tracking between RF amplifier and local oscillator stages of receiver?
Variable tuning inductor
Ganged tuning inductor
Variable capacitor
Variable preset

⇒ V(t) across R₂ for t > 0 is given
2 - 2e^-2t
2 - e^-2t
2 - e^-t
1 - e^-t

⇒ In order to protect a MOSFET against damage from any stray voltage at the gate
grounding rings are provided
terminals are shorted
source terminal is earthed during transit
none of these

⇒ When a bit is 0 is a DDR, it makes the corresponding port pin an __________ On the other hand, a 1 bit programs a __________ Pin.
output, input
output, output
input, input
input, output

⇒ The braking torque in single phase energy meter is proportional to speed of disc.
TRUE
FALSE

⇒ The secondary constants of a line are
Z₀
Z₀ and γ
Z₀, γ and wave velocity
Z₀, γ and L

⇒ Which of the following element has four valence electrons?
Silicon
Germanium
Both (a) and (b) above
None of the above

⇒ The turn ratio of a transformer is 20:1, if a load of 10Ω is connected across the secondary, what will be the effective resistance seen looking into the Primary?
2 kΩ
4 kΩ
8 kΩ
32 kΩ

⇒ An FM signal with a deviation δ is passed through a mixer, and has its frequency reduced 5 fold. The deviation in the output of the mixer is
5/δ
Intermediate
δ/5
δ

⇒

Assertion (A): Strain measurement using strain gauge invariably requires a dummy strain gauge.

Reason (R): The resistance of strain gauge depends on temperature.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ One can format a disc using window explorer.
TRUE
FALSE

⇒ An electromagnetic wave can be completely guided by a dielectric rod or slab.
TRUE
FALSE

⇒ The two terms used to describe performance of a directional coupler are
coupling and directivity
gain and coupling
gain and directivity
gain and isolation

⇒ Charge needed within a unit sphere centred at the origin for producing a potential fie
12 p_c
60 p_c
120 p_c
180 p_c

⇒ Bit is
smallest piece of electronic hardware
a drilling tool
an abbreviation for binary digit
the smallest number

⇒

Match the following:

	List I (Set operation)		List II (Set operator)
A.	Set equality	1.	-
B.	Set inclusion	2.	=
C.	Set intersection	3.	< =
D.	Set difference	4.	∗

A-2, B-3, C-4, D-1
A-3, B-2, C-4, D-1
A-1, B-2, C-3, D-4
A-4, B-2, C-3, D-1

⇒ In an integrated circuit the SiO₂layers provide
electrical connection to external Ckt.
physical strength
isolation
conducting path.

⇒ In binomial arrays the elimination of secondary lobes takes place
at the cost of directivity
at the cost of gain
both (a) and (b)
none of the above

⇒ The cut in voltages for germanium and silicon diodes respectively as
0.3 V and 0.7 V
0.7 V and 0.3 V
0.6 V and 0.9 V
0.5 V and 0.7 V

⇒ When diodes are connected in series to increase voltage rating the peak inverse voltage per junction
should not exceed half the breakdown voltage
should not exceed the breakdown voltage
should not exceed one third the breakdown voltage
may be equal to or less than breakdown voltage

⇒ Which of the following uses 'transferred electron effect' for production of microwaves?
Silicon
Germanium
Metal-semiconductor junction
Gallium Arsenide