Question is ⇒ In figure the collector to emitter breakdown voltage of the transistor (βVCEO) shoul, Options are ⇒ (A) more than VCC, (B) more than 0.5 VCC, (C) more than VCC + E, (D) more than 2 VCC, (E) , Leave your comments or Download question paper.

Question is ⇒ In figure the collector to emitter breakdown voltage of the transistor (βVCEO) shoul, Options are ⇒ (A) more than VCC, (B) more than 0.5 VCC, (C) more than VCC + E, (D) more than 2 VCC, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In figure the collector to emitter breakdown voltage of the transistor (βV_CEO) shoul
A.	more than V_CC [Wrong Answer]
B.	more than 0.5 V_CC [Correct Answer]
C.	more than V_CC + E [Wrong Answer]
D.	more than 2 V_CC [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The Z-inverse of the given Z-transform is _______
unit step
unit ramp
unit impulse
unit parabola

⇒ In an RC series circuit R = 100 Ω and X_C = 10 Ω. In this circuit
the current and voltage are in phase
the current leads the voltage by about 6°
the current leads the voltage by about 84°
the current lags the voltage by about 6°

⇒ Magnetic amplifier is used for
voltage amplification
power amplification
current amplification
frequency amplification

⇒ A device which converts BCD to seven segment is called
encoder
decoder
multiplexer
none of these

⇒ In home tape recorders the tape width is 2 inches.
TRUE
FALSE

⇒ A sinusoidal carrier voltage, having frequency 1000 Hz is amplitude modulated by a sinusoidal voltage of frequency 15 kHz. The frequency of upper and lower sidebands will be
1015 kHz and 985 kHz
1030 kHz and 970 kHz
13 kHz and 17 kHz
14 kHz and 16 kHz

⇒ When two conductors carry currents in the same direction the force is repulsive.
TRUE
FALSE

⇒ Fourier transform of signal obtained after taking difference between step function and its reverse version is given as __________ .
2jω
2/jω
4/jω
4jω

⇒ In 8085 microprocessor, an active low signal INTA is not needed from up service which of the following interrupt requ
TRAP
INTR
RST 7.5
RST 5.5

⇒ Which of the following statement is false?
A stationary process is always a ergodic process
A ergodic process is always a stationary random process
It is possible to have a stationary random
None of the above

⇒ The adjustment of position of shading bands, in an energy meter, is done to provide
friction compensation
creep compensation
braking torque
none of the above

⇒ TTL circuit with active pull up is preferred because of its suitability for
wired AND operation
bus operated system
wired logic operation
reasonable dissipation and speed of operation

⇒ An antenna having a high Q has
lower BW
higher BW
flat response
none of the above

⇒ If poles lie in first quadrant, damping ratio is
1
more than 1
less than 1
zero

⇒ The configuration of figure
Hartley oscillator
Precision Integrator
Wienbridge oscillator
Butterworth high pass filter

⇒ If t is relaxation time and t_c is average time between collisions, then in an isotropic metal
t = t_c
t < t_c
t_c < t
T = 0.01 t_e

⇒ In modern MOSFET_S, the material used for the gate is
high purity silicon
high purity silica
heavily doped polycrystalline silicon
epitaxial grown silicon

⇒ A λ/4 long high frequency transmission line is terminated into one impedance Z_R. If Z₀ be the characteristic impedance of the line, then input impedance Z_in is
Z_oZ_R
Z²_R/Z_o
Z²₀/Z_R
Infinity

⇒ Consider the following Statements regarding resistance strain gauge

The gauge factor is in the range of 2 to 5.
The resistance changes due to change in specific resistance with strain.
The resistance increases with increase in temperature.

Of the above statements, which are correct?
1, 2, 3
1 and 2
2 and 3
1 and 3

⇒ When Z₁ << Z, The circuit of figure work
inverting amplifier
Schmitt trigger
non-inverting amplifier
source follower

⇒ At f = 7 GHz, a 120 cm dish antenna gives a gain of about
50
500
5000
50000

⇒ In figure the cut in voltage of diode is 0.7 V and its bulk resistance is 20 Ω. The peak value of circuit current of during positive and negative half cycles
10 mA and zero
9.12 mA and zero
9.3 mA and zero
zero and 9.12 mA

⇒ The carriers of n channel JFET are
free electrons and holes
holes
free electrons or holes
free electrons

⇒ A signal x₁(t) and x₂(t) constitute the real and imaginary parts respectively of a complex valued signal x(t). What form of waveform does x(t) possess?
Real symmetric
Complex symmetric
Asymmetric
Conjugate symmetric

⇒ The radiation pattern of a parabola antenna is
omnidirectional
a figure of directional
highly directional
none of the above

⇒ In one time constant, the current in a circuit reaches __________ percent of its final value.
10
37
63
85

⇒

Match the following:

	List I (Processor in C)		List II (Output)
A.	Preprocessor	1.	Source code file
B.	Compiler	2.	Executable code in machine language
C.	Linker	3.	Relocatable object code

A-1, B-2, C-3
A-2, B-3, C-1
A-3, B-2, C-1
A-1, B-3, C-2

⇒ A silicon PN junction diode under reverse bias has depletion region of width 10 μm. The relative permittivity of silicon, ε_r = 11.7 and the permittivity of free space ε₀ = 8.85 x 10^-12 F/m. The depletion capacitance of the diode per square meter is
100 μF
10 μF
1 μF
20 μF

⇒ A 1 ms pulse can be converted into a 10 ms pulse by using which one of the following
An astable multivibrator
Stable multivibrator
A bistable multivibrator
A J-K flip-flop

⇒ In the given figure shows a 3 bit shift register using TTL flip flops. Initially all the flip flops are set to 0 state. After 8 clock pul
A = 1, B = 1, C = 1
A = 1, B = 1, C = 0
A = 0, B = 1, C = 1
A = 0, B = 0, C = 1