Question is ⇒ In figure base current is 10 μA and βdc = 100. Then VE</su, Options are ⇒ (A) 5 V, (B) 10 V, (C) 15 V, (D) 20 V, (E) , Leave your comments or Download question paper.

Question is ⇒ In figure base current is 10 μA and βdc = 100. Then VE</su, Options are ⇒ (A) 5 V, (B) 10 V, (C) 15 V, (D) 20 V, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In figure base current is 10 μA and β_dc = 100. Then V_E
A.	5 V [Wrong Answer]
B.	10 V [Wrong Answer]
C.	15 V [Correct Answer]
D.	20 V [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following is a computer language?
MS WORD
Page maker
MS EXCEL
LISP

⇒ FM transmitting and receiving equipment as compared to AM equipment is
costly
cheaper
almost equally costly
none of the above

⇒ The circuit shown below is functionally equivalen
NOR gate
OR gate
EX-OR gate
NAND gate

⇒ The most common method for biasing a JFET is
reverse bias
self bias
voltage divider bias
none of the above

⇒ The instruction MOV r₁, r₂ in 8085
causes contents of registers r₂ to be moved to r, and uses register addressing
causes contents of registers r₁ to be moved to r₂ and uses register addressing
causes contents of registers r₁ to be moved to r₂ and uses register immediate addressing
causes contents of registers r₂ to be moved to r₁ and uses register immediate addressing

⇒ Binary 1111 when subtracted from binary 11111 is
101110
10110
10000
100010

⇒ Transistor T₁ operates at 30 kHz and T₂ operates at 300 Hz. The flicker noise is
not depend on frequency
T₁ > T₂
T₁ = T₂
T₁ < T₂

⇒ The advantage of transistor over vacuum tube is
no heat is required
small size and light in weight
very low power consumption
all of the above

⇒ A sequence detector is required to give a logical output of 1 whenever the sequence 1011 is detected in the incoming pulse stream. Minimum number of flip-flops needed to built the sequence detector is
4
3
1
2

⇒ In pulse code modulation when the maximum frequency in the signal is f_max the bandwidth required will be
≤ p.f_max
≥ p.f_max
≤ (p.f_max)²
≥ (p.f_max)²

⇒ Consider the following statements :

Tellegen's theorem is applicable to any lumped networks.
The reciprocity theorem is applicable to linear bilateral networks.
Thevenin's theorem is applicable to two- terminal linear active networks.
Norton's theorem is applicable to two-terminal linear active networks.

Which of these statement are correct?
1, 2, and 3
1, 2 and 4
1, 2, 3 and 4
3 and 4

⇒ In metals the valence electron wave functions are strongly perturbed by the presence of neighbouring atoms.
TRUE
FALSE

⇒

Assertion (A): Gray code is used in shaft position encoding.

Reason (R): In gray code only a single bit change occurs when going from one code to another.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ Human body cannot sustain electric current beyond
1 μA
10 μA
5 μA
35 μA

⇒ An m derived and constant k filter section connected in cascade give
proper impedance matching
proper phase shift characteristic
proper attenuation characteristic
all of the above

⇒ During discharging a capacitor through a resistance, voltages across R and C are equal in magnitude.
TRUE
FALSE

⇒ An amplifier has open loop gain of 100, input impedance 1 kΩ and output impedance 100 Ω. If negative feedback with β = 0.99 is used, the new input and output impedances are
10 Ω and 1 Ω
10 Ω and 10 kΩ
100 kΩ and 1 Ω
100 kΩ and 10 Ω

⇒ Subroutines are used in larger programs not
to increase the programming case
to reduce storage equipment
to reduce program extension time
for ease of program testing at the program development time

⇒ As the number of flip flops are increased, the total propagation delay of
ripple counter increases but that of synchronous counter remains the same
both ripple and synchronous counters increase
both ripple and synchronous counters remain the same
ripple counter remains the same but that of synchronous counter increases

⇒ A power supply has full-load voltage of 20 V. What will be its no load voltage when its voltage regulation is 100%
0 V
10 V
20 V
40 V

⇒ Which of the following statement is incorrect?
UJT is a 3-terminal diode having two unequally doped regions
A UJT can be triggered by any one of its three terminals
The bi-directional switching characteristics of a diac are symmetrical
As compared to JFETs, MOSFETs generate less noise in high gain amplifiers

⇒ Quantization error occurs in
D/A converter
A/D converter
both D/A and A/D converter
neither D/A nor A/D converter

⇒ Which of the following are the memory performance parameters?

Access time and latency
Block size and Block access time
Cycle time and Bandwidth

Select the correct answer from the codes given below:
1 only
1 and 2 only
2 and 3 only
1, 2 and 3

⇒ When ω_m is the modulation frequency in frequency modulation, the modulation index is proportional to
ω_m
ω²_m
1/ω_m
1/ω²_m

⇒ When a p-n junction is forward biased, the current remains zero till the applied voltage overcomes the barrier potential.
TRUE
FALSE

⇒ Fermi level is the amount of energy in which
a hole can have at room temperature
an electron can have at room temperature
must be given to an electron move to conduction band
none of the above

⇒ If sound intensity is 8 W/m², the dB level of this sound is about
5 dB
50 dB
129 dB
1290 dB

⇒ A uniform wave have components
in the perpendicular direction E existing while H is zero
in the direction of propagation E existing while H is zero
E and H are zero in direction perpendicular to direction of propagation
E and H existing only in direction perpendicular to direction of propagation

⇒ Consider a random noise voltage which has a uniform density function as shown in the figure and is known to be wh
2 bits/reading
5 bits/reading
10 bits/reading
none of these

⇒ In all pure metals, temperature coefficient of resistance is positive.
TRUE
FALSE