Question is ⇒ In figure, a voltmeter of internal resistance 1200 Ω is connected across 600 Ω resistance and it reads 5 V. The value of, Options are ⇒ (A) 1200 Ω, (B) 2400 Ω, (C) 3600 Ω, (D) 7200 Ω, (E) , Leave your comments or Download question paper.

Question is ⇒ In figure, a voltmeter of internal resistance 1200 Ω is connected across 600 Ω resistance and it reads 5 V. The value of, Options are ⇒ (A) 1200 Ω, (B) 2400 Ω, (C) 3600 Ω, (D) 7200 Ω, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In figure, a voltmeter of internal resistance 1200 Ω is connected across 600 Ω resistance and it reads 5 V. The value of
A.	1200 Ω [Wrong Answer]
B.	2400 Ω [Correct Answer]
C.	3600 Ω [Wrong Answer]
D.	7200 Ω [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Ferrites are
hard materials
brittle materials
not easily machinable
materials with all above properties

⇒ A microwave link uses only line-of-sight propagation.
TRUE
FALSE

⇒ The transfer function V₂/V₁ for figure
a zero at origin
a zero at infinity
no zero
a zero at j1

⇒ At corner frequency the phase angle of factor 1/(1 + jωT) is
+90°
-90°
+45°
-45°

⇒ 2's complement of a given 3 or more bit number of non-zero magnitude is the same as the original number if all bits except
MSB are zero
LSB are zero
MSB are 1
LSB are 1

⇒ Which of the following is true?
The poisson distribution is limiting case of binomial distribution.
In symmetrical distribution, the mean, median and mode coincide.
Regression is the estimation or production of unknown values of one variables from known values of another variable.
All are true.

⇒ A horizontal output stage is cutoff for retrace and 40% of trace. If time for each horizontal line is 64 μs and retrace time is 12 μs, the transistor is conducting for about
64 μs
6.4 μs
31 μs
3.1 μs

⇒ The number of leads in a DIAC are
2
3
4
6

⇒ Which of the following is true?
A silicon wafer heavily doped boron is a p⁺ substrate
A silicon wafer lightly doped boron is a p⁺ substrate
A silicon wafer heavily doped arsenic is a p⁺ substrate
A silicon wafer lightly doped arsenic is a p⁺ substrate

⇒ The hexadecimal number 64 AC is equivalent to decimal number
25727
25722
25772
25777

⇒ When determining Thevenin's resistance of a circuit
all sources must be open circuited
all sources must be short circuited
all voltages sources must be open circuited and all current sources must be short circuited
all sources must be replaced by their internal resistances

⇒ Which one of the following gives maximum probability of error?
ASK
DPSK
FSK
PSK

⇒ The chip 8254 is a 40 pin programmable interval timer. The number of its independent 16 bit counters is
2
3
4
5

⇒ The sum of two sine waves of different frequencies is a sine wave.
TRUE
FALSE

⇒ Figure shows the arrangement
FM
PM
AM-DSB
AM-SSB

⇒

Match the following:

	List I (Instrument)		List II (Parameters)
A.	Moving coil galvanometer	1.	High inertia, soft spring control
B.	Ballistic galvanometer	2.	No control, high damping
C.	Vibration galvanometer	3.	Soft spring control, critical damping
D.	Moving coil flux meter	4.	Low inertia, tuned spring control

A-4, B-2, C-3, D-1
A-1, B-3, C-2, D-4
A-2, B-1, C-4, D-3
A-3, B-1, C-4, D-2

⇒ N circles for a = a₁, and a = a₁ ± 180° n (where n = 1, 2, 3, ....) are the same.
TRUE
FALSE

⇒ Machine cycle is always the same as instruction cycle.
TRUE
FALSE

⇒ As temperature increases
the forbidden energy gap in silicon and germanium increase
the forbidden energy gap in silicon and germanium decrease
the forbidden energy gap in silicon decreases while that in germanium decreases
the forbidden energy gap in silicon increases while that in germanium decreases

⇒ The time needed by a TTL circuit to switch from 0 to 1 or 1 to 0 is about
10 μs
10 ns
100 μs
50 ns

⇒ Two coils having self inductances of 10 mH and 40 mH are mutually coupled. The maximum possible mutual inductance is
40 mH
20 mH
10 mH
5 mH

⇒ If an admittance Y(s) has a term Ks, the realization would give
an inductance of value K
a resistance of value K
a capacitance of value K
either (a) or(c)

⇒ Light dependent resistor is
photo resistive device
photo voltaic device
photo emissive device
either (a) or (c)

⇒ If e = 10 sin(10⁸ t + 3 sin 10⁴ t) then the deviation is
4.77 kHz
47.7 kHz
477 kHz
4770 kHz

⇒

Assertion (A): JFET is a voltage controlled device.

Reason (R): The drain current can be controlled by controlling V_GS.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ The number of thyristors in a single phase fully controlled bridge rectifier is
16
8
4
2

⇒ The given characteristic polynomial s⁴ + s³ + 2s² + 2s + 3 = 0 has
zero root in RHS of s-plane
one root in RHS of s-plane
two roots in RHS of s-plane
three roots in RHS of s-plane

⇒ (1 2 1)_x = (1 0 0)₄ Then x is equal to
2
3
5
does not exist

⇒ Separation property of state-transition matrix is
φ(t - t₀) = φ(t) φ(t₀)
φ(t - t₀) = φ^-1(t) φ^-1(t₀)
φ(t - t₀) = φ(t) φ^-1(t₀)
φ(t - t₀) = φ^-1(t) φ^-1(t₀)

⇒ In 2 out of 5 code, decimal number 8 is
11000
10100
11000
1010