Question is ⇒ In fibre optics the use is made of thin glass fibres for efficient transmission of light., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper.

Question is ⇒ In fibre optics the use is made of thin glass fibres for efficient transmission of light., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In fibre optics the use is made of thin glass fibres for efficient transmission of light.
A.	TRUE [Correct Answer]
B.	FALSE [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Find I in 4 Ω resis
0.0416666666666667
0.5 A
0.75 A
0.95 A

⇒

Assertion (A): For high frequency lines inductive reactance is very high as compared to ac resistance.

Reason (R): Due to skin effect ac resistance of line is higher than dc resistance.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Which of the following is not necessarily the advantages of a push pull amplifier?
It gives more output
It removes odd a well as even harmonics
There is no effect of ripple of the power supply
It consumes least power

⇒ In a JFET avalanche breakdown occurs when V_DS = 22 V and V_GS = 0. If V_GS = -1 V, the avalanche breakdown will occur at
V_DS = 22 V
V_DS more than 22 V
V_DS equal to or more than 22 V
V_DS less than 22 V

⇒ Consider the transmission line of length 37.5 cm, which is terminated into zero resistance. This line is being exited by a source of 1 GHz which has an internal impedance of 50 Ω. What is the input impedance of the line as seen by the source?
50 Ω
Zero Ω
100 Ω
Infinite Ω

⇒ When temperature is more than ferromagnetic curie temperature, the behaviour of a ferromagnetic material is similar to that of paramagnetic material.
TRUE
FALSE

⇒ The addition of a pole to the open loop transfer function pulls the root locus
to the right
to the left and making the system more stable
towards right or left depending on the position of new pole
none of the above

⇒

Assertion (A): A BJT can be used as a switch.

Reason (R): In forward active mode emitter base junction is forward biased and base collector junction is reverse biased.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ For a diamagnetic material, μ_r = 1.
TRUE
FALSE

⇒ Half wave sysmmetry means f(t) = - f(t ± T/2).
TRUE
FALSE

⇒ A trigonometric function is synonyms to
orthogonal function
triangular function
singular function
none of the above

⇒

Assertion (A): A demultiplexer cannot be used as a decoder

Reason (R): A multiplexer selects one of many outputs whereas a decoder selects on output corresponding to coded input.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ Symbol in the given figure is IEEE symbol
AND
OR
NAND
NOR

⇒ Which of these commutation methods is used in AC-DC converters?
Class A
Class C
Class D
Class F

⇒ To eliminate ghosts in the picture
use a longer transmission line
connect a booster
change the antenna orientation of location
twist the transmission line

⇒ Typical value of power consumption of TV transmitter is
0.5 kVA
2 kVA
50 kVA
1000 kVA

⇒ Hexadecimal number F is called to octal number
15
16
17
18

⇒ The storage capacity of audio CD is 540 Mb per side.
TRUE
FALSE

⇒

Assertion (A): In a push pull circuit each transistor stays in the active region for one half cycle

Reason (R): A push pull amplifier has low distortion

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ An energy signal has G(f) = 10. Its energy density spectrum is
10
100
50
20

⇒ For determining the network functions of a two-port network, it is required to consider that
all initial conditions remain same
all initial conditions are zero
part of initial conditions are equal to zero
initial conditions vary depending on nature of network

⇒ The current in a circuit with 10 Ω resistance is i = 3 + 4 sin (100 t + 45°) + 4 sin (300 t + 60°) A. The rms current and power dissipated are
41 A and 410 W
35 A and 350 W
5 A and 250 W
11 A and 1210 W

⇒ A cavity resonator is
a hollow metallic enclosure
a hollow enclosure having magnetic material as its walls
a hollow enclosure having dielectric material as its walls
either (b) or (c)

⇒ What is the propagation constant for air filled wave guide with dimensions a = 1.59" and b = 0.795" at 4.95 GHz?
0.6698
0.7698
0.503
0.6598

⇒ Study the circuit of figure and examine the following statem
1, 2 and 3
1 and 2
1 and 3
2 and 3

⇒ The logic circuit in the given figure realizes the func
(A + B + C) (D E)
(A + B + C) (D E)
(A + B + C) (D E)
(A + B + C) (D E)

⇒ The turn on time of an SCR is 5 micro second. Its trigger pulse should have
short rise time with pulse width = 2.5 μs
long rise time with pulse width = 3 μs
short rise time with pulse width = 4 μs
long rise time with pulse width = 4 μs

⇒ In figure the output V₀
2V₁ + V₂ - 2V₃
2(V₁ + V₂) - V₃
V₁ + V₂ + V₃
V₁ + 2V₂ - V₃

⇒ Which of the following can be used as a rotating amplifier in a control system?

Amplidyne
Separately excited dc generator
Synchro
Self excited dc generator

Select the answer from the following codes:
3 and 4
1 and 2
1, 2 and 3
all

⇒ Consider the following advantages of phase array radar

simple circuitry
ability to track and scan simultaneously
ability to track many targets together
very fast scanning

Which of the above are correct?
1, 2, 3
1, 3, 4
2, 3, 4
1, 4 only