Question is ⇒ In FDM systems used for telephone, which modulation scheme is adopted?, Options are ⇒ (A) AM, (B) DSB-SC, (C) SSB-SC, (D) FM, (E) , Leave your comments or Download question paper.

Question is ⇒ In FDM systems used for telephone, which modulation scheme is adopted?, Options are ⇒ (A) AM, (B) DSB-SC, (C) SSB-SC, (D) FM, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In FDM systems used for telephone, which modulation scheme is adopted?
A.	AM [Wrong Answer]
B.	DSB-SC [Wrong Answer]
C.	SSB-SC [Wrong Answer]
D.	FM [Correct Answer]
View Answer 6 -5 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A cycloconverter is
ac-dc converter
dc-ac converter
dc-dc converter
ac-ac converter

⇒ An op-amp has zero gain for common mode inputs. Then CMRR =
zero
infinite
high
low

⇒ Diamond is a paramagnetic material.
TRUE
FALSE

⇒ Figure shows an R-L circuit. The current is i = 1 - e^-t. The rate of change of current at t = 1 secon
1 A/s
0.63 A/s
0.37 A/s
0

⇒ It is desired to couple a coaxial line to a two parallel wire line. It is best to use
quarter wave transformer
balun
slotted line
directional coupler

⇒ HVDC transmission systems generally use
12 pulse converters
6 pulse converters
3 pulse converters
either 12 or 6 pulse converters

⇒ A conductor has a cylindrical shape with a diameter d. Its resistance is 2 Ω. It is recast into a cylindrical conductor of diameter 0.3d. The resistance of new conductor is likely to be
less than 2 Ω
less than 0.6 Ω
between 2 and 100 Ω
more than 100 Ω

⇒ In the sale of diamonds the unit of weight is carat. One carat is equal to
100 mg
150 mg
200 mg
500 mg

⇒ A receiver having an RF amplifier and an IF of 450 kHz, has Q of the coils 65 and an incoming frequency of 1200 kHz. The image rejection of the receiver is
5870
3655
236
13.3

⇒ In selecting a satellite system, the First determining factor is its
EIRP
antenna size
coverage a sea
antenna gain

⇒ An intrinsic semiconductor (intrinsic electron density = 10¹⁶ m^-3) is deped with donors to a level of 10²² m^-3. What is the hole density assuming all donors to be ionized?
10⁷ m^-3
10⁸ m^-3
10¹⁰ m^-3
10⁶ m^-3

⇒ A tape recorder and deck are entirely similar.
TRUE
FALSE

⇒ A single-sideband (SSB) signal contains 3 kW. The power content of the carrier is __________ kW.
2
2
3
0

⇒ For a sine wave the average value is calculated over half the cycle.
TRUE
FALSE

⇒ In the given circuit, the switch has been in position 1 for quite a long time. At t = 0 the switch is moved to position 2. At this position what is the time const
0.1 s
1 s
0.11 s
1.11 s

⇒ In MF range, increasing the transmitter power
increases the range of transmitter
does not increase the range of transmitter because propagation is limited by tilt
decreases the range of transmitter because propagation is limited by tilt
increases the range of transmitter because propagation is through space waves

⇒

Assertion (A): When a high reverse voltage is applied to a p-n junction the diode breaks down.

Reason (R): High reverse voltage causes Avalanche effect.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ An amplitude modulated wave
0.5
0.3
0.7
0.4

⇒ If V = 4 in the figure, the value of I_S is given
0.25
5/2 A
0
None of these

⇒ In a biased limiter the clipping level can be adjusted by adjusting the voltage of battery.
TRUE
FALSE

⇒ A network has two branches in parallel. One branch contains impedance Z₁ and the other branch has impedance Z₂. If it is fed from an ac voltage V of frequency f, the current through Z₁ depends, on
V, Z₁, Z₂
V, Z₁
Z₁, Z₂
V, Z₁, f

⇒ BCD equivalent of - 8₁₀ is
110
10110
11000
1000

⇒ Four MSI TTL 4-bit ripple counters are cascaded to form a 16-bit binary counter. Its propagation delay is about __________ nanoseconds.
70
140
210
280

⇒ Consider the following rules about integer constant in C

An integer constant must have at least one digit.
An integer constant must not have a decimal point.
An integer constant may be positive or negative.
The default sign is positive.
A maximum of one comma or blank is allowed.

Which of the above are correct?
All
1, 2, 3, 4 only
1, 2, 3, 5
2, 3, 4, 5 only

⇒ The low pass filter characteristic shown in figure realiza
TRUE
FALSE

⇒

Assertion (A): The 'do while' statement is used less frequently than the 'while' statement.

Reason (R): For most applications it is more natural to test for continuation of loop at the beginning than at the end of loop.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ The most commonly used magnetron is
cylindrical
parallel plate
inclined plate
flat plate

⇒

Assertion (A): If minimum phase system has a gain margin of 8 dB and phase margin of 21°, the system is stable.

Reason (R): For a minimum phase system both GM and PM must be positive for the system to be stable.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ The current wave in figure is passed through 3 H inductor. The voltage across inductance during the period 2 < t < 3 second
12 V
- 12 V
6 V
- 6 V

⇒ Which of these is the most recent display device?
LED
LCD
VF
(a) and (c)