Question is ⇒ In EPROM integrated dose is defined as, Options are ⇒ (A) UV light intensity x exposure time in seconds, (B) UV light intensity / exposure time in seconds, (C) exposure time in seconds / UV light intensity, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ In EPROM integrated dose is defined as, Options are ⇒ (A) UV light intensity x exposure time in seconds, (B) UV light intensity / exposure time in seconds, (C) exposure time in seconds / UV light intensity, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In EPROM integrated dose is defined as
A.	UV light intensity x exposure time in seconds [Correct Answer]
B.	UV light intensity / exposure time in seconds [Wrong Answer]
C.	exposure time in seconds / UV light intensity [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A sinusoidal carrier voltage, having frequency 1000 Hz is amplitude modulated by a sinusoidal voltage of frequency 15 kHz. The frequency of upper and lower sidebands will be
1015 kHz and 985 kHz
1030 kHz and 970 kHz
13 kHz and 17 kHz
14 kHz and 16 kHz

⇒ To realize the full power of 8086 the pin of 8086 connected to ground is
DEN
ALE
INTR
MN / MX

⇒ Measurement of non-electrical quantity involves the following subsystems

Amplifier block
Display block
Instrumentation block
Transducer block

The correct sequence of these blocks is
4, 1, 3, 2
4, 3, 1, 2
1, 3, 2, 4
1, 2, 3, 4

⇒ Six sets of electromagnetic waves are given bel
VLF, LF, MF, HF, VHF, UHF
LF, VLF, MF, HF, VHF, VHF
LF, VLF, HF, MF, VHF, UHF
VHF, VLF, HF, MF, LF, UHF

⇒ An air-filled rectangular waveguide has dimensions 8cm x 10cm . The phase velocity of guided wave at frequency of 3 GHz for TE₁₀ mode is
1.5 x 10⁸ m/s
5.5 x 10⁸ m/s
3.46 x 10⁸ m/s
0.18 x 10⁷ m/s

⇒ Ferrites have
a low copper loss
low eddy current loss
low resistivity
higher specific gravity compared to iron

⇒ The property is not valid for basic singularity function is
it is even signal
convolution of any arbitary function x(t) and an impulse is the original function itself
the sum of two impulses at same location is the impulse with the strength equal to the summation of individual strengths.
none of these.

⇒ Among the digital IC families - ECL, TTL, and CMOS
ECL has the least propagation delay
TTL has largest fan out
CMOS has the lowest noise margin
TTL has the lowest power consumption

⇒ Program counter in a digital computer
counts the number of programs run in the machine
counts the number of times a subroutine
counts the number of time the loops are executed
points the memory address of the current or the next instruction

⇒ For a current transformer, the standard secondary rating is
1 A or 5 A
2.5 A
0.416666666666667
5 A or 10 A

⇒ Radiation intensity does not depend upon
the antenna direction
antenna width
both (a) and (b)
none of the above

⇒ The decimal equivalent of the hexadecimal number E 5 is
279
229
327
0

⇒ The fixed count that should be used so that the output register will represent the input for a 6 bit dual slope A/D converter uses a reference of -6v and a 1 MHz clock. It uses a fixed count of 40 (101000).
110
10
1111
11101

⇒ MTI stands for
Moving Target Indicator
Microprocessor Tracking Index
Multiplexed Telemetry Index
Maximum Transmission Index

⇒ Carbon resistances are used in very high values.
TRUE
FALSE

⇒ SSB can be generated by
filter method
phase shift method
weaver's method
none of the above

⇒ The statement that the line integral of magnetic field about any closed path is exactly equal to the direct current enclosed by that path, is known as
Ampere's circuital law
Coulomb's law
Electrostatic's theory
None of the above

⇒ The attraction between the nucleus and valence electron of copper atom is
zero
weak
strong
either zero or strong

⇒ Which of the following microphones is used as a standard for calibration?
Moving coil
Carbon
Condenser
Ribbon

⇒ In the circuit shown in the given figure, switch k is closed at t = 0. The circuit was initially relaxed then which one of the following sources of v(t) will produce maximum current at t = 0^{+Unit step
Unit impulse
Unit ramp
Unit step plus unit ramp}

⇒ In common base connection, the output characteristics of a bipolar junction transistor is drawn between
I_C and V_CB
I_C and V_CE
I_E and V_CB
I_E and V_CE

⇒ An AC source or RMS voltage 20V with internal impedance Z_s = (1 + 2j) Ω feeds a load of impedance Z_L = (7 + 4j) Ω in the figure below. The reactive power consumed by the loa
8 VAR
16 VAR
28 VAR
32 VAR

⇒ Instruction cycle is the time required to complete the execution of an instruction.
TRUE
FALSE

⇒ The difference between sequential and combinational circuits is
Combinational circuits store bits
Combinational circuits have memory
Sequential circuits store bits
Sequential circuits have memory

⇒ In PAL system weighting of R - Y and B - Y signals is done to
prevent over modulation on saturated colours
prevent under modulation of saturated colours
allow over modulation of saturated colours
allow under modulation on saturated colours

⇒ A better SNR can be obtained in a PCM by
increasing sampling rate above Nyquist rate
decreasing the code bits
reducing channel bandwidth
increasing Quantization levels

⇒ In pulse code modulation when the maximum frequency in the signal is f_max the bandwidth required will be
≤ p.f_max
≥ p.f_max
≤ (p.f_max)²
≥ (p.f_max)²

⇒ The minority carrier life time and diffusion constant in a semiconductor material are respectively 100 microsecond and 100 cm²/sec. The diffusion length is
0.1 cm
0.01 cm
0.0141 cm
1 cm

⇒

Assertion (A): When a square periodic wave is applied to an RC circuit, the voltage across capacitor is observed to be a triangular periodic wave.

Reason (R): The RC circuit works as integrator and its time constant is much larger than time period of input wave.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ If an electron move through a potential difference of 500 V, the energy possesses by it will be
500 ergs
500 joules
500 eV
500 mV