Question is ⇒ In energy band diagram of <i>p</i> type semiconductor the acceptor energy level is, Options are ⇒ (A) in valence band, (B) in conduction band, (C) slightly above valence band, (D) slightly below conduction band, (E) , Leave your comments or Download question paper.

Question is ⇒ In energy band diagram of <i>p</i> type semiconductor the acceptor energy level is, Options are ⇒ (A) in valence band, (B) in conduction band, (C) slightly above valence band, (D) slightly below conduction band, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In energy band diagram of p type semiconductor the acceptor energy level is
A.	in valence band [Wrong Answer]
B.	in conduction band [Wrong Answer]
C.	slightly above valence band [Correct Answer]
D.	slightly below conduction band [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For static electric and magnetic fields in an homogenous source-free medium, which of the following represents the correct form of Maxwell's equations?
Δ.E = 0
Δ.E = 0
Δ x E = 0
Δ x E = 0

⇒ The materials not having negative temperature coefficient of resistivity are
metals
semiconductors
insulators
none of the above

⇒ The oscillator frequency is set for
best picture
max. sound
min. sound
sound in picture

⇒

Assertion (A): A good op-amp should have very large band width

Reason (R): An ideal op-amp should have infinite input resistance and zero output resistance

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ The number of repeaters in a coaxial cable link depends on
system bandwidth
separation of equalizers
the number of coaxial cables in the tube
none of the above

⇒

Match the following:

	List I (Logic family)		List II (Characteristic of logic family)
A.	TTL	1.	Maximum power Consumption
B.	ECL	2.	Highest Packing Density
C.	NMOS	3.	Least Power Consumption
D.	CMOS	4.	Saturated Logic

A-1, B-4, C-2, D-3
A-1, B-4, C-3, D-2
A-4, B-1, C-2, D-3
A-4, B-1, C-3, D-2

⇒ In p mode of operation of magnetron the spikes due to phase focussing effect rotate at an angular velocity corresponding to
one pole/cycle
two pole/cycle
four pole/cycle
six pole/cycle

⇒ If the intermediate frequency of a superheterodyne receiver falls within the tuning range of the receiver
Unsuitability will occur
Heterodyne whistles will be heard
Tuning to the frequency band immediately adjacent to the intermediate frequency will become impossible
All of the above

⇒ The function A e^st where s = s + jω represents
A phasor whose magnitude changes with time
A phasor whose frequency is ω
A phasor rotating in counterclockwise direction at angular frequency ω and whose magnitude increases with t
A phasor rotating in clockwise direction at angular frequency ω and whose magnitude increases with t

⇒ The resolution of a 12-bit D/A converter using a binary ladder with + 10V as the full scale output will be
2.44 mV
3.50 mV
4.32 mV
5.12 mV

⇒ Lowest resistivity of the following is
constantan
german silver
manganin
nichrome

⇒ If H(s) is positive real, 1/H(s)
is positive real
is not positive real
may or may not be positive real
must possess some other properties also if it is to be positive real

⇒ A microwave junction is matched at all ports if the S matrix
has all diagonal elements zero
has all diagonal elements equal but not zero
has all diagonal elements complex
is Hermitian

⇒ Which one of the following is not necessarily an advantage of the phase cancellation method of obtaining SSB over the filter method?
It is possible to generate SSB at any frequency
SSB with lower audio frequencies present can be generated
Switching from one sideband to other is simpler
There are more balanced modulators; therefore the carrier is suppressed better

⇒ Which of the following conditions must be satisfied for a transistor to remain under saturation?

Its collector to base junction should be under forward bias.
Its collector to base junction should be under reverse bias.
Its emitter to base junction should be under reverse bias.
Its emitter to base junction should be under forward bias.

Select the correct answer from the codes given below:
1 and 2
1 and 3
2 and 3
1 and 4

⇒ A thermistor is used for
over voltage protection
temperature alarm circuit
automatic light control
none of the above

⇒ A voltage tripler circuit uses
2 diodes and 2 capacitors
3 diodes and 3 capacitors
2 diodes and 3 capacitors
3 diodes and 2 capacitors

⇒ In rectifiers the use of RC filters is recommended when
load current is high
load current is small
load current is neither high nor small
either (a) or (c)

⇒ The total number of leads in reverse conducting thyristor is
2
3
1
4

⇒ In indicating instruments the controlling torque is provided by a spring.
TRUE
FALSE

⇒ Costa's receiver is used for
coherent detection of AM-SC signal
asynchronous detection of AM-SC signal
amplitude modulation of signal
frequency modulation of signal

⇒ TE₁₀ mode of propagation of electromagnetic energy in waveguides can be thought of as
three TEM waves travelling along length of wave-guide
One TEM wave travelling along length of wave guide and one TEM wave propagation in the transverse plane
One TEM wave travelling along the length of wave guide and two TEM waves
none of the above

⇒ The number of tightly bound electrons in silicon atom are
14
10
6
4

⇒ The secondary constants of a line are
Z₀
Z₀ and γ
Z₀, γ and wave velocity
Z₀, γ and L

⇒ Number of fundamental cut-sets of any graph will be
same as the number of twigs
same as the number of tree branches
same as the number of nodes
equal to one

⇒ Mesh analysis is applicable __________ only.
planar network
non planar network
a circuit which contains only current sources
none

⇒ In all base driver amplifiers
ac collector voltage is 180° out of phase with ac base voltage
ac emitter voltage is 180° out of phase with ac base voltage
ac collector voltage is in phase with ac base voltage
none of the above

⇒ In the above case if the modulating frequency is increased to 20 kHz the bandwidth will be
0.05 MHz
1 MHz
2 MHz
4 MHz

⇒ In a JK flip-flop, J is connected to Q and K is connected to Q outputs. The JK FF converts into a
RS FF
D FF
T FF
Clocked RS FF

⇒ In a series R, L, C circuit the impedance triangle is the same when X_L < X_C and X_L > X_C .
TRUE
FALSE