Question is ⇒ In electromagnetic wave polarization is caused by, Options are ⇒ (A) refraction, (B) reflection, (C) longitudinal nature of electromagnetic waves, (D) transverse nature of electromagnetic waves, (E) , Leave your comments or Download question paper.

Question is ⇒ In electromagnetic wave polarization is caused by, Options are ⇒ (A) refraction, (B) reflection, (C) longitudinal nature of electromagnetic waves, (D) transverse nature of electromagnetic waves, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In electromagnetic wave polarization is caused by
A.	refraction [Wrong Answer]
B.	reflection [Wrong Answer]
C.	longitudinal nature of electromagnetic waves [Wrong Answer]
D.	transverse nature of electromagnetic waves [Correct Answer]
View Answer 3 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ During amplitude modulation, the phase angle of the modulating voltage changes by
0°
45°
90°
180°

⇒ In mode filter of the given figure which of the following modes is unaffe
TE₀₁
TE₁₀
TE₁₁
all TM

⇒ Satellite launch sites are invariably located on Eastern seaboards to ensure that
launch takes place eastward
expenditure of propulsion fuel is reduced during plane changing
the satellite achieves circular orbit quickly
spent rocket motor and other launcher debris falls into the sea

⇒ A₁₆ X 2₁₆ __________ .
16₁₆
15₁₆
14₁₆
13₁₆

⇒ In a single phase full converter fed by a source having inductance, the number of thyristors conducting during overlap is
1
2
3
4

⇒ The elements which become superconducting at extremely low temperatures are
good conductors at room temperature
ferromagnetic at room temperature
relatively poor conductors at room temperature
insulators at room temperature

⇒ The circuit shown below is the equivalent circuit of which one of the following microwave resonator ty
Butterfly resonator
Parallel-wire resonator
Cavity resonator
Coaxial line resonator

⇒ The 10 MHz in the specification of CRO means that
the sweep frequency is 10 MHz
the frequency of input signal should not be more than 10 MHz
the vertical amplifier has been designed for 10 MHz
none of the above

⇒ Parity means the same as positive or negative number.
TRUE
FALSE

⇒ Consider the following:

Coupling capacitor
Emitter by-pass capacitor
Emitter to base diffusion capacitance of the BJT
Stray capacitance of the circuit.

Which of these components in a R-C coupled amplifier control the lower cut-off frequency of the amplifier?
1 and 2
2 and 3
3 and 4
l and 4

⇒ Radiation resistance of half-wave dipole (λ/2) antenna is in free space
73 Ω
120 p
36.5 Ω
70 Ω

⇒ The number of flags available in 6800 are
6
5
7
4

⇒ If CS = A₁₅ A₁₄ A₁₃ is used as chip select logic of a 4 K RAM in 8085 system, its memory range is
3000 H - 3 FFF H
7000 H - 7 FFFH
5000 H - 5 FFF H and 6000 H - 6 FFF H
6000 H - 6 FFF H and 7000 H - 7 FFF H

⇒ An enhancement mode MOSFET is on when the gate voltage is
zero
positive
high
more threshold value

⇒ A plane electromagnetic wave travels in dielectric medium of relative permittivity 9. Relative to free space, the velocity of propagation in the dielectric is
increased by a factor of 9
increased by a factor of 3
unchanged
reduced by a factor of 1/3

⇒ Beamwidth of an antenna depends upon
shape of radiation pattern
dimensions
wavelength
all of the above

⇒ In spread spectrum technique
a modulated signal is modulated again
a modulated signal is modulated twice again
the power of a modulated signal is increased
the noise component of a modulated signal is decreased

⇒ The response to sinusoidal excitation can be found by
setting s = jω in the network function
setting s = -jω in the network function
taking inverse transform of network function
none of the above

⇒ In a bridge inverter with single pulse width modulation
the output frequency is equal to frequency of reference signal
the output frequency is equal to frequency of control signal
either (a) or (b)
neither (a) nor (b)

⇒ The pure capacitor connected across an A.C. voltage consumed 20 W. This is due to
the capacitive reactance in ohms
the current flowing in the capacitor
the fused capacitor was a big one
none of the above

⇒

Match the following:

	List I (Power device)		List II (Max. frequency)
A.	Power Bipolar	1.	MHz
B.	Power MOSFET	2.	100 kHz
C.	SCR	3.	10 kHz
D.	Insulated gate bipolar transistor	4.	1 kHz

A-2, B-1, C-3, D-4
A-3, B-4, C-2, D-1
A-3, B-1, C-4, D-2
A-4, B-1, C-3, D-2

⇒ In a differential amplifier, CMRR can be improved by using an increased
emitter resistance
collector resistance
power supply voltages
source resistance

⇒ Which of the following circuit would be preferred for a 355 KHz IF amplifier?
Resistance loaded
Double tuned transformer
Video amplifier
Class C

⇒ In a p-n-p transistor the main current carriers and the mechanism of flow respectively are
electrons, drift
holes, drift
holes, diffusion
electrons, diffusion

⇒ The addition of n type impurity to intrinsic material creates allowable energy levels.
slightly below conduction band
slightly above conduction band
slightly below valence band
slightly above valence band

⇒ Consider the following galvanometers

D'Arsonval
Ballistic
Vibration

Which of these are permanent magnet moving coil instruments?
1 and 2 only
1, 2 and 3
2 and 3 only
1 and 3 only

⇒ Which of the following devices exhibit negative resistance characteristics?
UJT
PUT
Both UJT and PUT
UJT, PUT and SBS

⇒ Conductivity is measured in terms of
mho/metre
ohm/metre
mho/metre²
ohm/metre²

⇒ A class A chopper has an input voltage of 200 V. T_on = 1.5 ms and T_off = 4.5 ms. The duty cycle, average output voltage and ripple factor respectively are
0.5, 100 V and 1
0.25, 50 V and 3
0.25, 50 V and 1
0.5, 100 V and 3

⇒ If e = 10 sin(10⁸ t + 3 sin 10⁴ t) then the deviation is
4.77 kHz
47.7 kHz
477 kHz
4770 kHz