Question is ⇒ In cell communication, Options are ⇒ (A) carrier frequency change, (B) carrier frequency constant, (C) depend upon location, (D) depend upon geographical area, (E) , Leave your comments or Download question paper.

Question is ⇒ In cell communication, Options are ⇒ (A) carrier frequency change, (B) carrier frequency constant, (C) depend upon location, (D) depend upon geographical area, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In cell communication
A.	carrier frequency change [Correct Answer]
B.	carrier frequency constant [Wrong Answer]
C.	depend upon location [Wrong Answer]
D.	depend upon geographical area [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A ripple in collector supply voltage of the output stage of amplifier causes noise.
TRUE
FALSE

⇒ Most popular IF for receivers tuning to 540 to 1650 kHz is
433 kHz
455 kHz
545 kHz
555 kHz

⇒ For a good voltage amplifier, its input impedance should be
low as compared to the resistance of the source
high as compared to the resistance of the source
always inductive
always capacitive

⇒ The function shown in figure, can represent a probability density function for A _______
A = 1/4
A = 1/6
A = 1/9
A = 1/2

⇒

Assertion (A): The maximum range of a radar is proportional to fourth root of the peak transmitted pulse power.

Reason (R): Radar signals are subjected twice to inverse square law.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Which one of the following statement is correct?
Both Laplace's (L) and Poisson's (P) equation are non linear
L is non linear but P is linear
L is linear but P is non linear
L, P both is linear

⇒ If word length is 16 bits the decimal equivalent of largest number which can be stored is
32767
32766
16383
16384

⇒

Assertion (A): When the forward gain of a system is increased, the transient response becomes oscillatory.

Reason (R): Increasing the forward gain reduces steady state error.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ A complementary symmetry amplifier has
1 P-N-P and 1 N-P-N transistor
2 P-N-P transistor
2 N-P-N transistor
2 P-channel FETs

⇒ In figure, the magnitude
must be more than that of V_a
must be more than that of V_b
must be more than that of V_a or V_b
can be equal to or less than or more than that of V_a or V_b

⇒ In a purely inductive ac circuit, the supply voltage and voltage induced across inductance are equal and opposite at all instants.
TRUE
FALSE

⇒ Consider the differential amplifier shown in figure. (Assume β is very hi
1 MΩ
100 kΩ
15 kΩ
≈ 0

⇒ In a pure sample of silicon
the number of holes and free electrons is always equal
the number of free electrons is more than the number of holes
the number of free electrons and holes is equal at low temperature
the number of free electrons is less than number of holes

⇒ To measure an emf by dc potentiometer it is necessary to standardise the potentiometer with the help of a standard cell.
TRUE
FALSE

⇒ In order to enable TRAP interrupt, which of the following instructions are needed?
El only
SIM only
El and SIM both
None

⇒ What is the maximum output voltage from the 741 op-amp?
Zero
Approximately 1 V
Approximately 3 V
Approximately 5 V

⇒ A resistance wire strain gauge has gauge factor 2. If stress is 100 mega newton/m² and Young's modulus is 200 giga newton/ m², the percentage change in gauge resistance due to stress is
0.1
0.2
0.4
0.5

⇒ Which of the following circuit cannot be used to demodulate SSB?
Phase discriminator
Produce detector
Balanced modulator
Beat frequency oscillator

⇒ The number of distinct Boolean expression of 4 variables is
16
256
1024
65536

⇒

Match the following:

	List I (Octal)		List II (Decimal number)
A.	35	1.	53
B.	65	2.	62
C.	54	3.	29
D.	76	4.	44

A-4, B-3, C-2, D-1
A-1, B-2, C-3, D-4
A-2, B-3, C-1, D-4
A-3, B-1, C-4, D-2

⇒ If X = - 285.56 and the Pascal write statement used is WRITE (X : 8). Then the print out will appear as
-285.56
-2.85 E + 02
-2.85560 E + 02
-2.8 E + 02

⇒ As temperature increases
the forbidden energy gap in silicon and germanium increase
the forbidden energy gap in silicon and germanium decrease
the forbidden energy gap in silicon decreases while that in germanium decreases
the forbidden energy gap in silicon increases while that in germanium decreases

⇒ If f(t) ↔ F(jω), f(- t) ↔
- F(jω)
F(- jω)
F(jω)
0.5 F(jω)

⇒ Which of the following frequencies cannot be used for reliable beyond-the-horizon terrestrial communications without repeaters?
25 kHz
15 MHz
750 MHz
12 GHz

⇒ Two capacitors of 2 μF and 4 μF capacitance are connected in series across a 30 V dc battery. After the capacitors have been charged, the voltage across them will be
15 V each
10 V and 20 V
20 V and 10 V
30 V each

⇒ Karnaugh map is used to
minimise the number of flip flops in a digital circuit
minimise the number of gates only in a digital circuit
minimise the number of gates and fan in a digital circuit
design gates

⇒ A 16-megabit dynamic random access memory (DRAM) is an integrated circuit capable of storing __________ characters (bytes).
1048567
16 x 1024 x 10⁶
16 x 10⁶
2.1 x lo⁶

⇒ In an ac circuit the fundamental component of current wave lags the corresponding voltage wave by 20°. The third harmonic component of current wave lags the corresponding voltage by an angle.
less than 20°
more than 20°
equal to 20°
equal to or more than 20°

⇒ A 300 MHz plane EM wave is propagating in free space. The wave is incident normally on an infinite copper slap. The antenuation constant for the wave is (σ_copper = 5.8 x 10⁷ mho/ m)
262 x 10³
254 x 10³
352 x 10³
354 x 10³

⇒ A single phase half wave regulator uses
2 diodes and 2 thyristors
2 thyristors
1 diode and 1 thyristor
2 diodes