Question is ⇒ In an R-S latch, to set the output to high, Options are ⇒ (A) R is low and S is high, (B) R and S are high, (C) R and S are low, (D) R is high and S is low, (E) , Leave your comments or Download question paper.

Question is ⇒ In an R-S latch, to set the output to high, Options are ⇒ (A) R is low and S is high, (B) R and S are high, (C) R and S are low, (D) R is high and S is low, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In an R-S latch, to set the output to high
A.	R is low and S is high [Correct Answer]
B.	R and S are high [Wrong Answer]
C.	R and S are low [Wrong Answer]
D.	R is high and S is low [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In p channel JFET, V_GS is positive.
TRUE
FALSE

⇒ A semiconductor diode is biased in forward direction and carrying current I. The current due to holes in p material is
I
0
less than I
0.5

⇒ A series RLC circuit has a resonance frequency of 1 kHz and a quality factor Q = 100. If each of R, L and C is doubled from its original value, the new Q of the circuit is
25
50
100
200

⇒

Assertion (A): Master slave JK flip flop is commonly used in high speed synchronous circuitry

Reason (R): Master slave JK flip flop uses two JK flip flops in cascade.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒

Assertion (A): The surge current which an SCR can withstand is much higher than rms on state current.

Reason (R): The duration of surge current is very small.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In figure, secondary winding has 40 turns. For maximum power transformer to 2 ohm resistance the number of turns in primar
20
40
80
160

⇒

Assertion (A): In FM the frequency of the carrier is varied by the modulating voltage

Reason (R): FM and PM are two forms of angle modulation.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ At very low temperatures, semiconducting materials behave as insulators.
TRUE
FALSE

⇒ The geostationary communication satellite APPLE is parked in the equatorial orbit at
102° E longitude over Sumatra
90° E longitude over Bangladesh
74° E longitude over India
67° E longitude over Pakistan

⇒ RECTIFIER : OSCILLATOR ::
Capacitance : Inductance
Series resonance : Parallel resonance
DC : AC
Regulation : Efficiency

⇒ What is the maximum output voltage from the 741 op-amp?
Zero
Approximately 1 V
Approximately 3 V
Approximately 5 V

⇒ A synchro transmitter receiver unit is a
two phase ac device
3 phase ac device
dc device
1 phase ac device

⇒ A Weinbridge oscillator is a
VHF oscillator
RF oscillator
microwave oscillator
audio frequency oscillator

⇒ Using 4-bit numbers (n = 4) if k = 0011₂, how is k expressed in 2's complement?
1011₂
1101₂
1100₂
0101₂

⇒ A JFET is a
unipolar device
bipolar device
tripolar device
none of the above

⇒ Fourier analysis indicate that a square wave can be represented as
a fundamental sine wave and odd harmonics
a fundamental sine wave and even harmonics
a fundamental sine wave and harmonics
fundamental and subharmonic sine waves

⇒ Consider the following statements

In 8085 address and data buses are multiplexed.
In Z 80 address and data buses are multiplexed
In Z 80 address and data buses are not multiplexed.
Z 80 has 16 bit address bus and 8 bit data bus.

Which of the above statements are correct?
1 and 2 only
1, 3 and 4 only
1, 2 and 4 only
2 and 4 only

⇒ The Gain margin for the system with open loop transfer functi
∞
0
1
-∞

⇒ The number of unused states in a 4 bit Johnson counter is
2
4
8
12

⇒ In figure readings of the two voltmeters shoul
100 V on each meter
200 V on each meter
150 V on V₁ and 50 V on V₂
50 V on V₁ and 150 V on V₂

⇒ In control systems the magnitude of error voltage
is very small
is very large
neither small nor large
may be any value from 0 to 50 V

⇒

LPEPSI
3
9
13
23



⇒ In a 3 phase semiconverter, the freewheeling diode comes into operation only if firing angle
is zero
is 60°
is more than 60°
is more than 90°

⇒ The atmospheric absorption of radio waves depends on
frequency of wave
the distance from transmitter
wave polarisation
atmospheric polarisation

⇒ The terminals of a power BJT are called
emitter, base, collector
emitter, base, drain
source, base, drain
source, base, collector

⇒ Which of the following is taken as reference antenna for directive gain?
Half wave dipole
Elementary doublet
Isotropic
Infinitesimal dipole

⇒ In a semiconductor avalanche breakdown occurs when
reverse bias exceeds the limiting value
forward bias exceeds the limiting value
forward current exceeds the limiting value
potential barrier is reduced to zero

⇒ Four terminal approach is used in measuring low resistance because it
eliminates thermoelectric energy
eliminates stray capacitance
eliminates stray inductance
eliminates the effect of leads and contacts

⇒ An LED is
an ohmic device
a display device
a voltage regulated device
all of the above

⇒ For frequency up to 1650 kHz, the transmitting antenna is used a
parabolic dish
vertical antenna
yagi antenna
turnstile antenna









Users Also Read
Previous Papers
Aptitude
Reasoning
Gen.Knowledge
Speak English
English / Verbal
Online / Mock Test
Vedic Math







    
	
	




    
	StudySite.org is world's best free online study content provider, Copyright © 2024 by 
StudySite.org All Rights Reserved