Question is ⇒ In an R-L circuit excited by a battery of voltage E, the current and voltage across resistor are 1- e-t and 2(1 - e-t) respectively. If there were an initial current of 2 A in the inductance, the voltage across resistance would have been, Options are ⇒ (A) 1 - e-t, (B) 2 - 2e-t, (C) 2 + 2e-t, (D) 4 - 4e-t, (E) , Leave your comments or Download question paper.

Question is ⇒ In an R-L circuit excited by a battery of voltage E, the current and voltage across resistor are 1- e-t and 2(1 - e-t) respectively. If there were an initial current of 2 A in the inductance, the voltage across resistance would have been, Options are ⇒ (A) 1 - e-t, (B) 2 - 2e-t, (C) 2 + 2e-t, (D) 4 - 4e-t, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In an R-L circuit excited by a battery of voltage E, the current and voltage across resistor are 1- e^-t and 2(1 - e^-t) respectively. If there were an initial current of 2 A in the inductance, the voltage across resistance would have been
A.	1 - e^-t [Wrong Answer]
B.	2 - 2e^-t [Wrong Answer]
C.	2 + 2e^-t [Correct Answer]
D.	4 - 4e^-t [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ When a BJT is operated under saturated condition
both junctions are forward biased
both junctions are reverse biased
CB junction is forward biased and EB junction is reverse biased
EB junction is forward biased and CB junction is reverse biased

⇒ In 8085 microprocessor, in order to enable RST 5.5, RST 6.5 and RST 7.5 interrupts, which of the following instruction are needed?
EI only
SIM only
EI and SIM both
None

⇒ F₂ layer of atmosphere extends from
250 km to 400 km
150 km to 250 km
50 km to 150 km
15 km to 50 km

⇒ In a PCM the amplitude levels are transmitted in a 7 unit code. The no. of levels is
18
14
128
64

⇒ A transistor amplifier has pole
s₁
s₁ + s₂ + s₃ + s₄
s₁ + s₄
s₄

⇒ Fibers have numerical aperture (NA) in the range of 0.15 to 0.4 Fibers with higher NA value would have
reduced losses
high bandwidth
reduced losses and low bandwidth
more losses and low bandwidth

⇒ The expression A ** B / C + D is equivalent to
AB / C + D
AB / C + D
AB / (C + D)
None of the above

⇒ For high frequencies a capacitor like
an open circuit
a short circuit
either open circuit or short circuit
none of the above

⇒

Assertion (A): Drift velocity of electrons is proportional to the applied electric field E.

Reason (R): The average drift velocity per unit field is called mobility.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒

Assertion (A): The reverse current in a p-n junction is nearly constant.

Reason (R): The reverse breakdown voltage of a p-n diode depends on the extent of doping.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ In high power AM transmission modulation is done at
IF stage
RF power
buffer stage
oscillator stage

⇒ The core of a solenoid is made of material of relative permeability μ_r. A small cavity area dA and length dl is cut in the core. If it is desired that flux density in the cavity should be equal to B₀
the fields inside and outside the cavity must be equal
the field inside the cavity must be made stronger than field outside the cavity
the field inside the cavity must be made weaker than the field outside the cavity
none of the above

⇒ To produce magnetic flux, mmf is necessary.
TRUE
FALSE

⇒ A chopper cannot be line commutated.
TRUE
FALSE

⇒ Each frequency in the modulating wave gives rise to four side bands.
TRUE
FALSE

⇒ An amplifier signal is made up of just two frequencies 1000 Hz. The output signal consists of 500 Hz and 25000 Hz frequencies. This may be attributed to
harmonic distortion
intermodulation distortion
both (a) and (b)
none of the above

⇒ The speeds used in recording audio programs in house hold recorders are
38 cm/s and 9.5 cm/s
38 cm/s and 19 cm/s
9.5 cm/s and 4.75 cm/s
38 cm/s and 4.75 cm/s

⇒ If a driving point function N(s) = p(s)/q(s), then
the terms of lowest degree in p(s) and q(s) may differ in degree by zero only
the terms of lowest degree in p(s) and q(s) may differ by one at the most
the terms of lowest degree in p(s) and q(s) may differ in degree by two at the most
the terms of lowest degree in p(s) and q(s) may differ in degree by three at the most

⇒ If a dipole is meant for a frequency of 1 MHz, the length of each rod is about
5 m
20 m
100 m
50 m

⇒ Voltage V_L in the circuit when V_s < 0 where D is an ideal diode. (Take R₁ = R_s = R_L = 1 &o
0
1
1.5
cannot find

⇒ Consider the following materials

Nickel
Silver
Oxygen
Aluminium

The correct sequence in the order of decreasing permeability is
1, 4, 3, 2
1, 4, 2, 3
4, 1, 3, 2
4, 1, 2, 3

⇒ Gold is often diffused into silicon PN junction devices to
increase the recombination rate
reduce the recombination rate
make silicon a direct gap semiconductor
make silicon semimetal

⇒ Which of the following array names in Fortran 77 is invalid?
A(6)
A(R)
A(I)
A(N)

⇒ Photo electric emission can occur only if
wave length of incident radiation is equal to threshold value
wave length of incident radiation is less than threshold value
frequency of incident radiation is less than threshold frequency
none of the above

⇒ The properties of JFET resemble those of
thermionic values
N-P-N transistors
P-N-P transistors
unijunction transistor

⇒

Match the following:

	List I (Instruction)		List II (Flag's getting affected)
A.	ORI	1.	CY reset
B.	DAA	2.	CY reset and AC reset
C.	PCHIL	3.	S, Z, AC, P, CY flags affected
		4.	S, S, P are modified
		5.	No flags affected

A-2, B-3, C-5
A-4, B-3, C-5
A-1, B-2, C-3
A-2, B-4, C-1

⇒ Convolution of x(t + 5) with impulse function δ(t - 7) is equal to
x(t - 2)
x(t + 12)
x(t - 12)
(t + 2)

⇒

Match the following:

	List I		List II
A.	RC coupled amplifier	1.	Very low drift
B.	Tuned amplifier	2.	Flat frequency response from zero frequency onwards
C.	Chopper stabilized amplifier	3.	Flat frequency response with upper and lower cut off frequency
D.	DC amplifier	4.	Peak in gain frequency response

A-4, B-3, C-1, D-2
A-3, B-4, C-2, D-1
A-3, B-4, C-1, D-2
A-4, B-3, C-2, D-1

⇒ The output of the circuit shown below will be of the frequ
125 Hz
250 Hz
500 Hz
750 Hz

⇒ Which among the following waveforms can be reconstructed from its samples without distort
1 and 2
2 and 3
1 and 3
Only 2