Question is ⇒ In an induction wattmeter, the shading bands are made of non conducting material., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper.

Question is ⇒ In an induction wattmeter, the shading bands are made of non conducting material., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In an induction wattmeter, the shading bands are made of non conducting material.
A.	TRUE [Wrong Answer]
B.	FALSE [Correct Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ If air pressure in a rectangular waveguide is increased the maximum power handling capacity
is decreased
is increased
remains the same
may increase or decrease depending on pressure

⇒ If it is desired to have low output impedance in an amplifier circuit then we should use
common collector circuit
common base circuit
common emitter circuit
either (b) or (c)

⇒ In figure the cut in voltage of diode is 0.7 V and its bulk resistance is 20 Ω. The peak value of circuit current of during positive and negative half cycles
10 mA and zero
9.12 mA and zero
9.3 mA and zero
zero and 9.12 mA

⇒ A material has conductivity of 10^-2 mho/m and a relative permittivity of 4. The frequency at which conduction current in the medium is equal to displacement current is
45 MHz
90 MHz
450 MHz
900 MHz

⇒ In an op-amp a common mode signal is applied to
inverting terminal
non-inverting terminal
both terminals
one or both the terminals

⇒ A series resonant circuit has inductance L. If L is increased, the resonant frequency
increases
decreases
remains constant
may increases or decreases

⇒ The system of the given fi
has two poles and one zero in left half plane
has two poles and one zero in right half plane
has two poles in left half plane and zero in right half plane
none of the above

⇒ The voltage gains of an amplifier without feedback and with negative feedback respectively are 100 and 20. The percentage of negative feedback (β) would be
0.4
0.05
0.2
0.8

⇒ A bistable multivibrator
has no stable state
has one stable state
has two stable state
none of the above

⇒ In a CE amplifier circuit, the output voltage
is very small
is always constant
depends on β
none of the above

⇒ State variable formulation is very suitable for computer solution.
TRUE
FALSE

⇒ The given figure shows a K-map for a Boolean function. The number of essential prime implicant
4
5
6
8

⇒ In a half bridge inverter the gate pulses of the two thyristors have a phase displacement of
60°
90°
120°
180°

⇒ VSB modulation is preferred in TV because
it reduces the bandwidth requirement to half
it avoids phase distortion at low frequencies
it results in better reception
none of the above

⇒ In body centred cubic structure, comers and centre of the cube are occupied by identical atoms.
TRUE
FALSE

⇒ Calculate cut off frequency for dominant mode in rectangular waveguide if dimensions are a = 2, b = 1 cm.
7.5 GHz
1.5 GHz
15 GHz
150 GHz

⇒ Class A and Class B power amplifiers predominate at
audio frequencies
radio frequencies
all frequencies
audio and radio frequency

⇒ Consider the following statements about a magic tee

The collinear arms are isolated from each other.
On of the collinear arms is isolated from E arm.
On of the collinear arms is isolated from H arm.
E and H arms are isolated from each other.

Of the above statements
1 and 2 are correct
1 and 3 are correct
1 and 4 are correct
2 and 3 are correct

⇒

Assertion (A): In India we use CCIR-B standard

Reason (R): Video signals are frequency modulated.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Thermistors are made of
pure metals
pure insulators
tintered mixture of metallic oxides
pure semiconductors

⇒ A machine cycle has one clock cycle.
TRUE
FALSE

⇒ Which one of following is correct condition to check the stability of system?
Bounded I/P unbounded O/P
Bounded I/P and O/P
Bounded O/P and I/P
Bounded I/P Bounded O/P

⇒ The gate width of a monostable multivibrator is given by
T = 1.1 RC
T = 0.693 RC
0.963 RC
T = 0.369 RC

⇒ Which of the following real expressions is correct in Pascal?
- Z + P * X
(X + Y) (A + B)
Z ** M
Z P * M

⇒ If temperature is increased, the temperature coefficient of a metal
increases
decreases
may increase or decrease
remains constant

⇒ The conductivity of intrinsic semiconductor is given by
en_i(μ_p - μ_n)
en_i(μ_p + μ_n)
n_i(μ_p + μ_n)
n_i(μ_pμ_n)

⇒ In a radio detector
stabilization against signal strength variation is provided
linearity is worse than in a phase discriminator
the circuit is the same as in discriminator except that diodes are reversed
output is twice that obtainable from a similar phase discriminator

⇒ Ohmic range of carbon composition resistors is
10 to 100 ohms
10 to 10 K ohms
10 to 200 ohms
10 to 25 M ohms

⇒ Both Impatt and Trapatt devices use avalanche effect
TRUE
FALSE

⇒ In FM signal with a modulation index m_f is passed through a frequency tripler. The wave in the output of the tripler will have a modulation index of
m_f
3m_f
m_f/3
m_f/9