Question is ⇒ In an n-p-n transistor biased for operation in forward active region, Options are ⇒ (A) emitter is positive with respect to base, (B) collector is positive with respect to base, (C) base is positive with respect to emitter and collector is positive with respect to base, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ In an n-p-n transistor biased for operation in forward active region, Options are ⇒ (A) emitter is positive with respect to base, (B) collector is positive with respect to base, (C) base is positive with respect to emitter and collector is positive with respect to base, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In an n-p-n transistor biased for operation in forward active region
A.	emitter is positive with respect to base [Wrong Answer]
B.	collector is positive with respect to base [Wrong Answer]
C.	base is positive with respect to emitter and collector is positive with respect to base [Correct Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The number of doped regions in PIN diode is
1
2
3
1 or 2

⇒ A capacitor used for power factor correction in single- phase circuit decreases
the power factor
the line current
both the line current and the power factor
the line current and increases power factor

⇒ Figure is a 24 V_r stabilized power supply. The zener is 24 V, 600 mW. The minimum zener current is 10 mA. Proper values R and maximum load current
320 Ω, 10 mA
400 Ω, 15 mA
400 Ω, 10 mA
320 Ω, 15 mA

⇒

Assertion (A): L[e^-at f(t)] = F(s + a)

Reason (R): In use of Laplace transform method, initial conditions may be neglected.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ Antenna reciprocity is put to use in
radar system
commercial broadcast
TV broadcast system
none of the above

⇒

Assertion (A): A Darlington amplifier has very low output impedance

Reason (R): The circuit has a low resistance R_E between emitter and ground

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ Three point tracking is achieved with
double conversion
padder capacitor
double spotting
variable selectivity

⇒ The resistance of voltmeter affects the accuracy of measurement in loss of charge method.
TRUE
FALSE

⇒ During day time ionosphere consist of
D, E, F₂ layers
D, E, F layers
D, E, F₁, F₂ layer
none

⇒ The units of resistivity are ohm-metre.
TRUE
FALSE

⇒ When the modulating frequency is doubled, the modulation index is halved and the modulating voltage remains constant. The modulation system is
FM
AM
phase modulation
none of the above

⇒ In a circuit the value of resistor is made four times. The noise voltage generated by this resistance will
be doubled
be increased four times
remain the same
become half

⇒ The operating voltage of a megger is about
100 V
12 V
6 V
1 V

⇒ A message signal x(t) is amplitude modulated with carrier c(t2ω
3ω
1ω
0.5ω

⇒ A 300 MHz plane EM wave is propagating in free space. The wave is incident normally on an infinite copper slap. The antenuation constant for the wave is (σ_copper = 5.8 x 10⁷ mho/ m). The skin depth is
0.005 x 10^-3 m
0.0038 x 10^-3m
0.0028 x 10^-3 m
0.0024 x 10^-3 m

⇒ In figure, the short circuit current through terminal AB wil
0.125
1.5 A
0.0833333333333333
0.0416666666666667

⇒ Find R_{TH200 Ω
0 Ω
400 Ω
None of these}

⇒ Which of the following statements regarding two transistor model of p-n-n-p device is correct?
It explain only the turn on portion of the device characteristics
It explain only the turn off portion of the device characteristics
It explain only the negative region portion of the device characteristics
It explain all the regions of the device characteristics

⇒ A 4 cm by 3 cm rectangular waveguide with air cavity, is operating at 12 GHz with TE₁₁ mode. The cut-off frequency is:
6.25 GHz
4.75 GHz
1.5 GHz
8.75 GHz

⇒ Which of the following microphones has lowest output impedance?
Moving coil
Ribbon
Crystal
Condenser

⇒ When an electron rises through a potential of 100 V it will acquired an energy of
100 eV
100 Joules
100 ergs
100 x 10^-6 Newtons

⇒ A 1 kHz sinusoidal signal is ideally sampled at 1500 samples/sec and the sampled signal is passed through an ideal low pass filter with cut off frequency 800 Hz. The output signal has the frequency.
0 Hz
0.75 kHz
0.5 kHz
0.25 kHz

⇒ Class C operation finds application in
RF power amplifiers
frequency multipliers
both (a) and (b)
neither (a) nor (b)

⇒ How many JK flip-flops are needed to make a 4-bit shift register?
2
4
6
8

⇒ If a 'live' conductor of a public supply touches earth metal
supply voltage will increase
supply voltage will decrease
no current will flow
current will flow to earth

⇒ The polar plot for positive frequencies is shown below. The gain margi
- 8.02 dB
6.02 dB
5 dB
none of these

⇒ Minute cracks in metals and minute faults in welded joints can be detected using
IR rays
UV rays
a rays
X-ray/γ-rays

⇒ The circuit below represents function X(A, B, C, D)
Σ(5, 8, 13, 14)
∏(0, 1, 2, 3, 4, 6, 7, 8, 10, 11, 12)
Σ(5, 9, 13, 14)
∏(0, 1, 2, 3, 4, 5, 6, 7, 8, 10, 11, 12, 15)

⇒ Find curren
4/5 A
5/4 A
1.23 A
1.32 A

⇒ In the given figure
A
B
A + B + C
ABC

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math