Question is ⇒ In an impedance smith chart, a clockwise movement along a constant resistance circle gives rise to, Options are ⇒ (A) decrease in the value of reactance, (B) an increase in the value of reactance, (C) no change in the reactance value, (D) no change in the impedance value, (E) , Leave your comments or Download question paper.

Question is ⇒ In an impedance smith chart, a clockwise movement along a constant resistance circle gives rise to, Options are ⇒ (A) decrease in the value of reactance, (B) an increase in the value of reactance, (C) no change in the reactance value, (D) no change in the impedance value, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In an impedance smith chart, a clockwise movement along a constant resistance circle gives rise to
A.	decrease in the value of reactance [Wrong Answer]
B.	an increase in the value of reactance [Correct Answer]
C.	no change in the reactance value [Wrong Answer]
D.	no change in the impedance value [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following are true for magic tee in the given figure select the answer as per given c
1, 2 and 3
1, 2 and 4
2, 3 and 4
1, 3 and 4

⇒ In Z_RC(s) has a pole at s = 0, the first element in second Foster realization is
R
C
R and C in series
R and C in parallel

⇒ The simplest method of suppression of unwanted side band in AM is
filter method
phase shift method
third method
both (a) and (b)

⇒ Of the four INSAT-I satellites planned by India so for, only __________ has proved to be successful.
INSAT-IA
INSAT-IB
INSAT-IC
INSAT-ID

⇒ When a voltage is applied to a semiconductor crystal then the free electrons will flow.
towards positive terminal
towards negative terminal
either towards positive terminal or negative terminal
towards positive terminal for 1 μs and towards negative terminal for next 1 μs

⇒ The colour on the extreme left in general purpose fixed resistors represents
first significant digit
tolerance
wattage rating
voltage rating

⇒ The total number of fundamental products of three variables is
3
5
8
16

⇒ In Bode analysis the correction at corner frequency is 3 dB.
TRUE
FALSE

⇒ The maximum phase difference between the applied voltage and current in a RLC series current with finite values of R, L, C, and f can be
less than 90°
less than 45°
180°
30°

⇒ Push pull amplifier is
voltage amplifier
current amplifier
power amplifier
none of the above

⇒ Which of the following device acts as an N-P-N and a P-N-P transistor connected base to base and emitter to controller?
UJT
SCR
Diac
Triac

⇒ An FM signal with a deviation is passes through the mixer, and has its frequency reduced five fold. The deviation in the output of the mixer is
Δ
5Δ
Δ/5
indeterminant

⇒ X(t) is a stationary process with the power spectral density S_x(f) > 0 for all f. The process is passed through a system shown be
S_y(f) > 0 for all f
S_y(f) = 0 for |f| > 1kHz
S_y(f) = 0 for f = nf₀, f₀ = 2kHz, n any integer
S_y(f) = 0 for f = (2n + 1)f₀ = 1 kHz, n any integer

⇒ If E is energy level of electron and E_F is Fermi level, then
all quantum states with E less than E_F will be occupied at T = 0
all quantum states with E less than E_F will be empty at T = 0
some quantum states with E less than E_F will be occupied at T = 0
none of the above

⇒ In position control system the device used for providing rate feedback voltage is
potentiometer
synchro-transmitter
synchro-transformer
tacho generator

⇒ In commercial electron tubes the current produced by the cathode at 1000 K is about
0.01 A per cm² of cathode surface
0.1 A per cm² of cathode surface
1 A per cm² of cathode surface
5 A per cm² of cathode surface

⇒ Following figure repres
AND
OR
NAND
NOT

⇒ The load circuit of a single phase full bridge inverter
must be underdamped
must be overdamped
may be underdamped or overdamped
may be any type of load

⇒ In figure the zener has a resistance of 5 ohms. As the load resistance is varied, the output vol
will remain constant at 12 V
will vary between 12.05 and 12.65 V
will vary from 10 to 20 V
will remain constant at 12.05 V

⇒ Magnetic flux can be measured by
capacitive pick up
inductive pick up
resistive pick up
hall effect pick up

⇒ An unmodulated voltage 10 V effective is applied to a dioxide detector in which load resistance is 4 x 10^-5 ohms. A micrometer shows that the rectified DC current in this resistance is 30 A. The input resistance of the detector is
114 kW
336 kW
384 kW
455 kW

⇒ The log magnitude curve for a constant gain K is a horizontal straight line at a magnitude 20 log K dB.
TRUE
FALSE

⇒ As the area of a public meeting increases the amplifier power output required increases.
TRUE
FALSE

⇒ The operating voltage of a megger is about
100 V
12 V
6 V
1 V

⇒ For a Gaussian process, auto-correlation also implies
statistical dependence
statistical independence
ergodic process
none of the above

⇒ Which of the following logic no resistors are used?
CMOS
TTL
4 n sec ECL
8 sec ECL

⇒ An R-C coupled amplifier has mid-frequency gain of 200 and a frequency response from 100 Hz to 20 kHz. A negative feedback network with β = 0.2 is incorporated into the amplifier circuit, the Bandwidth will be
50 kHz
20 kHz
100 kHz
infinite

⇒ The resonant frequency of an R_F amplifier is 1 MHz and its bandwidth is 10 kHz. The Q factor will be
10
100
0.01
0.1

⇒ If a and b are the dimensions of waveguide then
a = 3b
a = 2b
a = b
a = b/4

⇒ Which of the following devices exhibit negative resistance characteristics?
UJT
PUT
Both UJT and PUT
UJT, PUT and SBS