Users Also Read

MCQ's Search Engine

Electrical Engineering

Mechanical Engineering

Civil Engineering

Automobile Engineering

Chemical Engineering

Computer Engineering

Electronics Engineering

Medical Science Engg

Q1. | In an A.C. circuit power is dissipated in |

A. | Resistance only [Correct Answer] |

B. | Inductance only [Wrong Answer] |

C. | Capacitance only [Wrong Answer] |

D. | None of the above [Wrong Answer] |

View Answer
Explanation:-
Answer : ADiscuss it below :!! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒ The r.m.s. value of pure cosine function is

0.5 of peak value

0.707 of peak value

Same as peak value

Zero

⇒ The ratio of active power to apparent power is known as ____ factor.

Demand

Load

Power

Form

⇒ At half power points of a resonance curve, the current is____ times the maximum current.

1/2

1/ √2

√2

2

⇒ In A.C. circuit the power curve is a sine wave having

Double the frequency of voltage

Same frequency as that of voltage

Half the frequency of the voltage

None of these

⇒ A network is said to be non-linear if it does not satisfy

Homogeneity condition

Superposition condition

Both (A) and (B)

Associative condition

⇒ All the rules and laws of D.C. circuit also supply to A.C. circuit containing

Capacitance only

Inductance only

Resistance only

All above

⇒ For the full wave rectified sine wave the r.m.s. value is

0.707 I

_{max}

0.636 I

_{max}

0.318 I

_{max}

Zero

⇒ The r.m.s. value and mean value is the same in the case of

Triangular wave

Sine wave

Square wave

Half wave rectified sine wave

⇒ The dual of a link is

Twig

Node

Loop

Tree branch

⇒ The best place to install a capacitor is

Very near to inductive load

Across the terminals of the inductive load

Far away from the inductive load

Any where

⇒ The power factor of incandescent bulb is

0.8 lagging

0.8 leading

Unity

Zero

⇒ In an A.C. circuit I sin Φ is called

Active component

Wattless component

Any of the above

None of these

⇒ Two sinusoidal quantities are said to be phase quadrature, when their phase difference is

0

30°

45°

90°

⇒ The power factor at resonance in RLC parallel circuit is

Zero

0.08 Lagging

0.8 Leading

Unity

⇒ In an A.C. circuit power is dissipated in

Resistance only

Inductance only

Capacitance only

None of the above

⇒ For the same peak value which of the following wave will have the highest r.m.s. value ?

Square wave

Half wave rectified sine wave

Triangular wave

Sine wave

⇒ Which of the following circuit component opposes the change in the circuit voltage

Inductance

Capacitance

Conductance

Resistance

⇒ The power factor of a D.C. circuit is always

Less than unity

Unity

Greater than Unity

Zero

⇒ In the R - L - C containing R = 4.5ω L = 0.06 H,C = 0.6 µF the power factor will be

Zero

Lagging

Leading

Unity

⇒ The power is measured in terms of decibles in case of

Electronic equipment

Transformers

Current transformers

Auto-transformers

⇒ The ratio of the bandwidth to the resonance frequency is called the____ of the circuit.

Impedance

Susceptance

Quality factor

Selectivity

⇒ The form factor is the ratio of

Peak value to r.m.s. value

r.m.s. value to average value

Average value to r.m.s. value

None of these

⇒ The voltage of domestic supply is 220 V. This figure represents-

Mean value

r.m.s. value

Peak value

Average value

⇒ For the same peak value of voltage which wave form will have the least r.m.s. value ?

Sine wave

Square wave

Triangular wave

Full wave rectified sine wave

⇒ The frequency of domestic power supply in India is

200 Hz

100 Hz

60 Hz

50 Hz

⇒ A coil with large distributed capacitance has a

High resonant frequency

Low resonant frequency

Low quality factor

Low resistance

⇒ Higher the Q of a series circuit

Broader its resonance curve

Narrower its pass band

Greater its band width

Sharper its resonace

⇒ The r.m.s. value of a sinusoidal A.C. current is equal to its value at an angle of____ degrees

90

60

45

30

⇒ Inductance affects the direct current flow

Only at the time of turning off

Only at the time of turning on

At the time of turning on and off

At all the time of operation

⇒ Form factor is the ratio of

Average value/r.m.s. value

Average value/peak value

r.m.s. value/average value

r.m.s. value/peak value