Users Also Read

MCQ's Search Engine

Electrical Engineering

Mechanical Engineering

Civil Engineering

Automobile Engineering

Chemical Engineering

Computer Engineering

Electronics Engineering

Medical Science Engg

Q1. | In AM, the modulation envelope has a peak value double the unmodulated carrier level, when the modulation is |

A. | 0.25 [Wrong Answer] |

B. | 0.33 [Wrong Answer] |

C. | 0.5 [Wrong Answer] |

D. | 1 [Correct Answer] |

View Answer
Explanation:-
Answer : DDiscuss it below :!! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒ The chemical properties of atoms are determined by all the electrons and their configuration.

TRUE

FALSE

⇒ In a biased limiter the clipping level can be adjusted by adjusting the voltage of battery.

TRUE

FALSE

⇒ In a lead acid battery

the numbers of positive and negative plates are equal

the number of positive plates may be equal to or more than the number of negative plates

the number of positive plates is more than the number of negative plates

the number of negative plates is more than the number of positive plates

⇒ Which of the following operations will give the result 2 in C?

42857

4.0 / 2

4.0 / 2.0

4 / 2.0

⇒ When a

*p*-

*n*-

*p*transistor is properly biased to operate in active region the holes from emitter.

diffuse through base into collector region

recombine with electrons in base

recombine with electrons in emitter

none of the above

⇒ If A = 4∠7°, A

^{2}is

16∠14°

16∠49°

16∠7°

16∠3.5

⇒ Maximum undistorted power output of a transmitter is obtained when its modulation is __________ percent.

more than 100

100

less than 100

50

⇒ -8 is equal to signed binary number

10001000

1000

10000000

11000000

⇒ In figure, the time constant for the capacitor chargin

6 μ

*s*

10 μ

*s*

15 μ

*s*

25 μ

*s*

⇒ If a signal band limited for

*f*is sampled at a rate less than 2

_{m}*f*the reconstructed signal will be

_{m}smaller in amplitude

distorted

having higher frequencies suppressed

none of the above

⇒ For a second order system, damping ratio ζ is such that 0 < ζ <. Then the roots of characteristic equation are

real but not equal

real and equal

complex conjugate

imaginary

⇒ Transformer coupling in transistor amplifier circuits provides high efficiency, because

d.c. resistance is low

collector voltage is stepped up

flux linkages are incomplete

all of the above

⇒ The current source in figure, can be replace

a voltage source of 20 V in series with 5 ohm resistance

a voltage source of 16 V in series with 4 ohm resistance

a voltage source of 20 V in series with 4 Ω resistance

a voltage source of 16 V in series with 5 Ω resistance

⇒ Epitaxial growth is used in IC

*s*

because it produces low parasitic capacitance

because it yields back to back isolating

*pn*junction

to grow single crystal

*n*doped silicon on a single crystal

*p*type substrate

to grow selectively single crystal

*p*doped silicon of one resistivity on a

*p*type substrate of a different resistivity

⇒ The most commonly used bias in BJT amplifier circuits is

voltage divider bias

emitter bias

collector bias

collector feedback bias

⇒ In a series RLC circuit excited by

*e*= E

_{m}sin ω

*t*is seen that LC < 1/ω

^{2}. Then

I lags E

I leads E

I leads E are in phase

voltage across L and C are equal

⇒ The current flowing through a pure capacitor is called displacement current.

TRUE

FALSE

⇒ Zero mean Gaussian noise of variance N is applied to a half wave rectifier. The mean squared value of the rectified output will be

0

N/2

N/2

N

⇒ A silicon PN junction diode under reverse bias has depletion region of width 10 μm. The relative permittivity of silicon, ε

_{r}= 11.7 and the permittivity of free space ε

_{0}= 8.85 x 10

^{-12}F/m. The depletion capacitance of the diode per square meter is

100 μF

10 μF

1 μF

20 μF

⇒ The poles and zeros of a positive real functions are real or occur in conjugate pair.

TRUE

FALSE

⇒ The channel of JFET consists of

*p*type material only

*n*type material only

conducting material

either

*p*or

*n*type material

⇒ A counter has 4 flip flops. It divides the input frequency by

4

2

8

16

⇒ In figure the bridge is balanced when Z

_{4}

120∠70°

187.5∠ - 10°

187.5∠ - 70°

333.3∠ - 70°

⇒ Read the following statements about TWT

- It uses thermionic emission.
- It uses an attenuater.
- It is inherently a resonant device.
- It has broad bandwidth.

1, 2, 3 and 4

1, 2 and 3

1, 3 and 4

1, 2 and 4

⇒ The noise performance of a square law demodulator of AM signal is

better than that of an envelope detector

better than that of a synchronous detector

identical with that of a synchronous detector

poorer than that of an envelope detector

⇒ How many distinct binary trees can be constructed with three nodes?

1

2

3

5

⇒ Q of a coil

- increases with Q increasing frequency
- varies linearly with frequency
- increase with increasing frequency because R increases at high frequency
- decrease after the peak frequency because R increases at H.F. the correct statements are

A, B

C, D

A, C

B, D

⇒ Consider Pole zero diagram as shown, If two Poles are moved in opposite direction towards ω = p/2 and -p/2, the filter wil

change to high pass filter

change to Band Pass filter

remains same

change to LPF

⇒ In magnetic film memory, the memory element consits of

plated wires

superconductive material

nickel iron alloy

doped aluminium

⇒ Two current sources each of rms value 10 A have frequencies 40 Hz and 50 Hz respectively. They are connected in series, the expression for resultant wave is

*i*= 10 sin 40

*t*+ 10 sin 50

*t*

*i*= 14.14 sin 40

*t*+ 14.14 sin 50

*t*

*i*= 14.14 sin 80 p

*t*+ 14.14 sin 100 p

*t*

*i*= 20 sin 80 p

*t*+ 20 sin 100 p

*t*