Question is ⇒ In AM the amplitude of carrier components ... while in FM it, Options are ⇒ (A) remains constant, does not remain constant, (B) does not remain constant ... remains constant, (C) remains constant... also remains constant, (D) does not remain constant, also does not remain constant, (E) , Leave your comments or Download question paper.

Question is ⇒ In AM the amplitude of carrier components ... while in FM it, Options are ⇒ (A) remains constant, does not remain constant, (B) does not remain constant ... remains constant, (C) remains constant... also remains constant, (D) does not remain constant, also does not remain constant, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In AM the amplitude of carrier components ... while in FM it
A.	remains constant, does not remain constant [Correct Answer]
B.	does not remain constant ... remains constant [Wrong Answer]
C.	remains constant... also remains constant [Wrong Answer]
D.	does not remain constant, also does not remain constant [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): A small section of high impedance line is equivalent to a series inductance.

Reason (R): A small section of a low impedance line is equivalent to a series resistance.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Which of the following parameters of CE circuit has the unit of ohms?
h_ie
h_re
h_fe
h_oe

⇒ In a magnetron the magnetic flux density is of the order of
1 mWb/s
1 Wb/m²
10⁶ m/s
10¹² m/s

⇒ A carrier wave carries information.
TRUE
FALSE

⇒ A coil has a designed for high Q performance at a rated voltage and a specified frequency. If the frequency of operation is doubled, and the coil is operated at the same rated voltage, then the Q factor and the active power P consumed by the coil will be affected as follows.
P is doubled, Q is halved
P is halved, Q is doubled
P remains constant, Q is doubled
P decreases 4 times, Q is doubled

⇒ The magnetic field due to current I equals
I/2 pr
I/4 pr
I²/2 pr
I²/4 pr

⇒ In calculating input impedance, the load impedance is considered to be connected at the output.
TRUE
FALSE

⇒ Which quantity controls the effectiveness of LED in emitting light?
Applied voltage
Current
Extent of doping
Temperature

⇒ The affect of ground on radiation pattern is to
cause cancellation of radiation along the ground
produce more number of nulls
both (a) and (b)
either (a) or (b)

⇒ A current increasing at the rate of 1 A/s is passed through 1 F capacitor. At t = 0, i = 0. The charge stored after 1 second is
0.5 C
1 C
2 C
4 C

⇒

Assertion (A): In a common source amplifier with source terminal at ac ground the voltage gain is about g_m r_d

Reason (R): A common source amplifier is a source follower circuit

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ Fortran 77 has six arithmetic operators.
TRUE
FALSE

⇒ The clock shown in figure has a frequency of 6 MHz. The frequency of the Q output wil
12 MHz
24 MHz
3 MHz
1.5 MHz

⇒

Assertion (A): Increasing the system gain improves steady state behaviour but may result in instability.

Reason (R): A compensator is inserted into a system to ensure specified performance.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ The behaviour of a JFET is similar to that of
NPN transistor
PNP transistor
SCR
Vacuum triode

⇒ The ratio of diffusion constant for hole D_P to the mobility for holes is proportional to
T²
T
1/T
T³

⇒ Audio tapes have two tracks each 2.5 mm wide.
TRUE
FALSE

⇒ In any network of linear impedances the current flowing at any point equal to algebric sum of currents caused to flow at that point by each of the emf taken separately with all other emfs reduced to zero. The statement represents.
KCL
Norton's theorem
Thevenin's theorem
Superposition theorem

⇒ A white noise X(t) with two-sided power spectral density 1 x 10^-10 W/Hz is input to a filter whose magnitude squared response is shown be
5 x 10^-7W
1 x 10^-6W
2 x 10^-6W
5 x 10^-6W

⇒ In the dimension statement DIMENSION A (50, 50), K (100, 100) the total number of locations reserved will be
2500
100000
125000
250000

⇒

Match the following:

	List I		List II
A.	h_ie	1.	49
B.	h_re	2.	25 x 10^-6siemens
C.	h_fe	3.	2.4 x 10^-4
D.	h_oe	4.	1000 ohms

A-1, B-2, C-3, D-4
A-4, B-3, C-2, D-1
A-3, B-4, C-1, D-2
A-4, B-3, C-1, D-2

⇒ Germanium and Si phosphorus have their maximum spectral response in the
infrared region
ultraviolet region
visible region
X-ray region

⇒ Figure represen
Tunnel diode
Zener diode
Photo diode
Photo sensitive diode

⇒ The code which provides for parity check is
Baudot
ASCII
EBCDIC
Excess-3

⇒ In the stabilized reactance modulator AFC system
phase modulation is converted into amplitude modulation by the equalizer circuit
the discriminator frequency must not be too low or the system will fail
the discriminator must have a fast time constant to prevent demodulation
the higher discriminator frequency, better the oscillator frequency stability

⇒ A diode can have a very high forward resistance.
TRUE
FALSE

⇒ If the resolution of a printer is 1200 dpi, the number of dots per square inch is
1200
800
1200 x 1200
either (a) or (b)

⇒ In the state equation x = AX + Bu is a n x m matrix.
TRUE
FALSE

⇒ In the given figure, the number of individual loop
2
4
5
6

⇒ A hot wire instrument is not affected by stray magnetic fields.
TRUE
FALSE