Question is ⇒ In a valence crystal, the valence electrons, Options are ⇒ (A) are not shared, (B) are shared between neighbouring atoms, (C) are shared by all atoms, (D) any of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ In a valence crystal, the valence electrons, Options are ⇒ (A) are not shared, (B) are shared between neighbouring atoms, (C) are shared by all atoms, (D) any of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a valence crystal, the valence electrons
A.	are not shared [Wrong Answer]
B.	are shared between neighbouring atoms [Correct Answer]
C.	are shared by all atoms [Wrong Answer]
D.	any of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Consider the following statements about a magic tee

The collinear arms are isolated from each other.
On of the collinear arms is isolated from E arm.
On of the collinear arms is isolated from H arm.
E and H arms are isolated from each other.

Of the above statements
1 and 2 are correct
1 and 3 are correct
1 and 4 are correct
2 and 3 are correct

⇒ When a normal atom loses an electron
the atom loses one-proton simultaneously
rest of the electrons move faster
the atom becomes a positive ion
the atom becomes a negative ion

⇒ Reflex klystron oscillator is essentially a low power device
TRUE
FALSE

⇒ If C is thermal capacitance, m is mass of liquid and c is specific heat, then
C = mc
c = mC
m = cC
C = (mc)²

⇒ A resistance strain gauge is usually
wire grid type
foil type
any of these
none of these

⇒ The current through a PN Junction diode with v volts applied to the P region to the N region, where (I₀ is the reverse saturation current to the diode, m the ideality factor, k the Boltzmann constant, T the absolute temperature and q the magnitude of charge on an electron) is
I₀ (e^-qv/mkT - 1)
I₀ e^-qv/mkT
I₀ (1 - e^qv/mkT)
I₀ (e^qv/mkT - 1)

⇒ A magnetron requires an external magnetic field with flux lines parallel to axis of cathode
TRUE
FALSE

⇒ How much is contributed by each bit in the code word of a PCM system under uniform and symmetric quantization to the signal to noise ratio?
3 dB
4 dB
5 dB
6 dB

⇒ AE 139 is a
tunnel diode
germanium power transistor
photoconductive cell
silicon diode

⇒

Assertion (A): When all inputs of a NAND-gate are shorted to get a one input, one output gate, it becomes an inverter.

Reason (R): When all inputs of a NAND-gate are at logic 'O' level, the output is at logic 'I' level.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ If a piece of wood is placed in a magnetic field
the magnetic field will not be affected
the magnetic lines of force will bend towards the piece
the magnetic lines of force will bend away from the piece
the flux may increase or decrease

⇒ Dual slope ADC uses an op amp comparator.
TRUE
FALSE

⇒

Assertion (A): A video monitor does not need RF tuner and IF amplifier

Reason (R): The picture tube in TV is basically a CRT.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The forbidden energy gap for silicon is
0.12 eV
1.12 eV
0.72 eV
7.2 eV

⇒ In a circular waveguide with radius r, the dominant mode is
TM₀₁
TE₀₁
TM₁₁
TE₁₁

⇒ Typical values of voltage gain for CE, CB and CC amplifiers are
100, 100 and 1 respectively
100, 1 and 100 respectively
100, 1 and 1 respectively
1, 100 and 100 respectively

⇒ The line of sight communication requires that transmit and receive antennas to face each other. If the transmit antenna is vertically polarized, for the best reception the receive antenna should be
horizontally polarized
vertically polarized
at 45° with respect to horizontal polarization
at 45° with respect to vertical polarization

⇒ Calculate wave impedance for TE mode
(377)Ω
226 Ω
∞
629 Ω

⇒ In Intel 8085, the integer range per word length is
-128 to 127
-127 and 128
-64 and 63
-63 and 64

⇒ The source of which of the following noise is different from that of the remaining?
Solar noise
Cosmic noise
Galactic noise
Atmospheric noise

⇒ In the given figure reflection coefficient at loa
0.6
-0.6
0.4
-0.4

⇒ The point P in the following figure is stock at 1. The output f wil
ABC
A
AB C
A

⇒ The gap width in audio heads is about 0.01 mm.
TRUE
FALSE

⇒ In amplitude modulation
the amplitude of carrier varies in accordance with the amplitude of the modulating signal.
the modulating frequency lies in the audio range
the amplitude of the carrier remains constant
the amplitude of the carrier varies in accordance with the frequency of the modulating signal.

⇒ A coil has a designed for high Q performance at a rated voltage and a specified frequency. If the frequency of operation is doubled, and the coil is operated at the same rated voltage, then the Q factor and the active power P consumed by the coil will be affected as follows.
P is doubled, Q is halved
P is halved, Q is doubled
P remains constant, Q is doubled
P decreases 4 times, Q is doubled

⇒ When a large number of atoms are brought together to form a crystal
the energy levels of inner shell electrons are affected appreciably by the presence of other neighbouring atoms.
The energy levels of outer shell electrons are affected appreciably by the presence of other neighbouring atoms.
the energy levels of both inner and outer shell electrons are affected appreciably by the presence of other neighbouring atoms.
none of the above.

⇒ The passband of the tuned circuits of a radio receiver should be equal to
20 kHz
455 kHz
1455 kHz
more than 455 kHz

⇒ Noise limiter is provided on AM receivers to
reduce interfering noise due to ignition system
reduce noise due to electrical storms
reduce interference due to electrical machinery
all of the above

⇒

Assertion (A): CMOS devices have very high speed.

Reason (R): CMOS devices have very small physical size and simple geometry.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ Transformer coupling is mostly used in
RF amplifier
audio amplifier
both audio and RF amplifier
none of the above