Question is ⇒ In a two terminals network the O.C. voltage measured at the given terminals is 100 V and s.c., currents at the same terminals 5 A. If a load of 80 Ω resistance is connected at the terminals, load current is, Options are ⇒ (A) 0.0416666666666667, (B) 1.25 A, (C) 0.25, (D) 6.25 A, (E) , Leave your comments or Download question paper.

Question is ⇒ In a two terminals network the O.C. voltage measured at the given terminals is 100 V and s.c., currents at the same terminals 5 A. If a load of 80 Ω resistance is connected at the terminals, load current is, Options are ⇒ (A) 0.0416666666666667, (B) 1.25 A, (C) 0.25, (D) 6.25 A, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a two terminals network the O.C. voltage measured at the given terminals is 100 V and s.c., currents at the same terminals 5 A. If a load of 80 Ω resistance is connected at the terminals, load current is
A.	0.0416666666666667 [Correct Answer]
B.	1.25 A [Wrong Answer]
C.	0.25 [Wrong Answer]
D.	6.25 A [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The currents fed to the two dipoles of turnstile antenna are
in phase
in quadrature
in phase opposition
either (a) or (c)

⇒ For type 2 system, the magnitude and phase angle of the term (jω)² in the denominator, at ω = 0, are respectively
0 and - 90°
0 and + 90°
infinity and - 180°
infinity and + 180°

⇒

Assertion (A): At a temperature of 1000 K, thermionic emission current is about 0.1 A/cm² of surface.

Reason (R): Thermionic emission current is given by I_th = SA₀ T² e^-Ew/kT.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ A single phase electric heater uses phase controlled thyristors. The firing angle is 90°. The degree of heating is
25% of maximum
50% of maximum
75% of maximum
none of the above

⇒ In communication receivers the fidelity is provided by
audio stage
detector range
mixer stage
all of the above

⇒ Thyristors connected in series need static and dynamic stabilizing circuits.
TRUE
FALSE

⇒ When a current source I is suddenly connected across a two terminal relaxed RC circuit at time t = 0, the voltage across the current source is shown in figure. The RC circui
a series combination of R and C
a parallel combination of R and C
a series combination of R and parallel combination of R and C
a pure capacitor

⇒ The function H (s) is positive real if
H (s) has no poles or zeros in right half plane
The poles of H(s) on the imaginary axis are simple with real and positive residues
Re [H(jω)] ≥ 0 for 0 ≤ ω ≤ ∞
all of the above

⇒ In the circuit shown in the given figure, the current flowing through resistance of 100 Ω woul
8 mA
10 mA
20 mA
100 mA

⇒ An amplifier has open loop gain of 100, input impedance 1 kΩ and output impedance 100 Ω. If negative feedback with β = 0.99 is used, the new input and output impedances are
10 Ω and 1 Ω
10 Ω and 10 kΩ
100 kΩ and 1 Ω
100 kΩ and 10 Ω

⇒ A 3 phase induction motor is controlled by voltage and frequency control such that the ratio V/f is constant. At 50 Hz, the speed is 1440 rpm. At 25 Hz, the speed is likely to be
about 1350 rpm
about 720 rpm
about 360 rpm
either (b) or (c)

⇒ A step up chopper can give an output voltage
higher than input voltage
lower than input voltage
both higher and lower input voltage
all of the above

⇒ The inductance of a coil can be increased by
choosing core material having high relative permeability
decreasing diameter of the former
decreasing the number of turns
increasing core length

⇒ Modulation index of a AM wave is measured using oscilloscope. The display on the CRO is as shown in figure it can be concluded t
the output wave is distorted
the output wave is under modulated
the modulation index is 100%
the modulation index is 50%

⇒ If two networks are cascaded then
[y] = [y_a] . [y_b]
[Z] = [Z_a] . [Z_b]
[a_a] = [b_b]
[a_a] + [b_b]

⇒ A heterodyne frequency changer is called a
Modulator
Mixer
Demodulator
Frequency translator

⇒ In a class C power amplifier the input signal has a frequency of 250 kHz. If the collector current pulses are 0.1 μs wide, the duty cycle of current waveform is
0.5
0.25
0.025
0.0025

⇒ When the phase velocity of an EM wave depends on frequency in any medium, the phenomenon is called
scattering
polarization
absorption
dispersion

⇒ Which of the following is not true as regards communication receiver?
It is exactly same as radio receiver used in households
It can be used, besides communication, for detection in high frequency bridges
It is designed to perform the task of low and high frequency reception better than in household receiver
Its tuning and operation are more complicated than those in household receiver

⇒ In level clocking the output can change
on rising edge of clock cycle
on falling edge of clock cycle
during entire half cycle of the clock
none of the above

⇒ Which one of the following pairs is not correctly matched?
NaCl : Diamagnetic
Gd : Paramagnetic
Ferrite : Ferrimagnetic
Cr₂ O₃ : Ferromagnetic

⇒ In the circuit, shown in figure, V₀ = V_i. The values of 1, m, n are: (x represents don't care conditi
0, 1, 1
∞, x, x
x, ∞, x
0, x, ∞

⇒ A pulse width signal can be governed by
free running multi-vibrator
monostable multi-vibrator
Schmitt trigger
JK flip-flop

⇒ If in a broadcasting studio, a 1000 kHz carrier is modulated by an audio signal of frequency range 100-5000 kHz, the width of channel is __________ kHz.
5
4.9
995
10

⇒ Computer virus can hide itself in a diskette but not in a hard disk.
TRUE
FALSE

⇒ On which bands, do the optical fibers operate?

Ultra violet band
Ultra high frequency band
Visible light band
Infrared band

Select the correct answer from the codes given below:
1 only
1 and 2 only
1, 2 and only
1, 3 and 4

⇒ Thermistor has a positive temperature coefficient.
TRUE
FALSE

⇒ A woofer should be fed from the input through a
low pass filter
high pass filter
band pass filter
band stop filter

⇒ If a line is open circuited Z_in = Z₀ tanh (gl).
TRUE
FALSE

⇒ Self impedance is
same for transmitting (T_t) and receiving antenna (T_r)
T_t > T_r
T_r > T_t
no relation