Question is ⇒ In a transistor push pull amplifier, Options are ⇒ (A) there is no dc present in the output, (B) there are no even harmonics in the output, (C) both (a) and (b), (D) neither (a) nor (b), (E) , Leave your comments or Download question paper.

Question is ⇒ In a transistor push pull amplifier, Options are ⇒ (A) there is no dc present in the output, (B) there are no even harmonics in the output, (C) both (a) and (b), (D) neither (a) nor (b), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a transistor push pull amplifier
A.	there is no dc present in the output [Wrong Answer]
B.	there are no even harmonics in the output [Wrong Answer]
C.	both (a) and (b) [Correct Answer]
D.	neither (a) nor (b) [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Armstrong FM transmitter uses
LC oscillator
crystal oscillator
RC oscillator
either (a) or (c)

⇒ Hystresis loss least depends on
frequency
magnetic field intensity
volume of the material
grain orientation of material

⇒ A XOR gate has inputs A and B and output Y. Then the output equation is
Y = AB
Y = AB + A B
Y = A B + A B
Y = A B + A B

⇒ Consider Pole zero diagram as shown, If two Poles are moved in opposite direction towards ω = p/2 and -p/2, the filter wil
change to high pass filter
change to Band Pass filter
remains same
change to LPF

⇒

Assertion (A): Logical group of instructions contains instructions for logic operations.

Reason (R): Data transfer group instruction is basically a copying instruction.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ The circuit shown depic
voltage series negative feedback
voltage shunt negative feedback
current series negative feedback
current shunt negative feedback

⇒ If L [f(t)] = F(s), Lf(t - T)
e^sTF(s)
e^-sTF(s)
F(s) - e^-sT
F(s) + e^-sT

⇒ A permanent magnet moving coil measures
true rms value
dc value
peak value
rms plus dc value

⇒ In the case of an amplifier, the normalised voltage gain is given
f_P >> f₀
f_P = f₀
f_P << f₀
f₀ = 2 f_P

⇒

Assertion (A): In circular waveguide the attenuation of TE₀₁ mode decreases as the operating frequency increases.

Reason (R): The wall currents in a circular waveguide in TE_Q1 mode are completely circumferential.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ A series circuit has R = 5 Ω and C = 10 μF. At t = 0 it is switched on to a 10 V dc battery. The maximum current in the circuit is
0.0833333333333333
0.0416666666666667
10⁶A
10 μA

⇒ Which one is correct option?
TEM mode exist in free space of infinite boundary
TEM mode exist in two conductor pattern system for finite-boundary
TEM mode exist in waveguide only
Both (a) and (b)

⇒ Decimal number 10 is equal to binary number
1110
1010
1001
1000

⇒ For a given voltage four heating coils will give maximum heat when connected
in parallel
in series
with two parallel pairs in series
with one pair in parallel and the other two in series

⇒ Short-circuited stubs are preferred to open circuited stubs because the latter are
more difficult to make and connect
incapable of giving a full range of reactances
made of transmission line with a different characteristic impedance
liable to radiate

⇒ Which of the following cannot be the Fourier series expansion of a periodic signal?
x(t) = 2 cos t + 3 cos 3t
x(t) = 2 cos pt + 7 cos t
x(t) = cos t + 0.5
x(t) = 2 cos 1.5pt + sin 3.5 pt

⇒ Radiation resistance of half-wave dipole (λ/2) antenna is in free space
73 Ω
120 p
36.5 Ω
70 Ω

⇒ The relationship of hysteresis loss to maximum flux density was first determined by
C. Steinmetz
G.R. Kirchoff
Mr. Laplace
Mr. Ampere

⇒ A PC can be upgraded to a multimedia PC by adding CD ROM drive, sound card etc.
TRUE
FALSE

⇒ Maximum usable frequency is [f_muf]
f_c sec i
f_c cos i
f_c sin i
f_c sec i

⇒ In the circuit of figure the current through 5 Ω resistance at t = 0^{+0
0.416666666666667
6.67 A
5.1 A}

⇒ The number of switching functions of 3 variables are
3
8
16
32

⇒ Multiplex techniques are used for
low density communications
low density point-to-point communications
high-density point-to-point communications
all of the above

⇒ Wood is a diamagnetic material.
TRUE
FALSE

⇒ SCR turns of from conducting state to blocking state on
reducing gate current
reversing gate voltage
reducing anode current below holding current value
applying ac to the gate

⇒ The first row of the window is called ' Title bar '.
TRUE
FALSE

⇒ Find curren
4/5 A
5/4 A
1.23 A
1.32 A

⇒ Consider the following program in Pascal 2
2.6
2.63
26.3

⇒ TE₁₀ mode of propagation of electromagnetic energy in waveguides can be thought of as
three TEM waves travelling along length of wave-guide
One TEM wave travelling along length of wave guide and one TEM wave propagation in the transverse plane
One TEM wave travelling along the length of wave guide and two TEM waves
none of the above

⇒ For the ring oscillator shown in the figure, the propagation delay of each inverter is 100 pico sec. What is the fundamental frequency of the oscillator output _______
10 MHz
100 MHz
1 GHz
2 GHz