Question is ⇒ In a thyristor, the forward breakover voltage, Options are ⇒ (A) is constant, (B) may be constant or may depend on gate current, (C) decreases as gate current is increased, (D) increases as gate current is increased, (E) , Leave your comments or Download question paper.

Question is ⇒ In a thyristor, the forward breakover voltage, Options are ⇒ (A) is constant, (B) may be constant or may depend on gate current, (C) decreases as gate current is increased, (D) increases as gate current is increased, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a thyristor, the forward breakover voltage
A.	is constant [Wrong Answer]
B.	may be constant or may depend on gate current [Wrong Answer]
C.	decreases as gate current is increased [Correct Answer]
D.	increases as gate current is increased [Wrong Answer]
View Answer 2 -4 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The clear data and present input of the JK flip-flop are known as
direct inputs
synchronous inputs
indirect inputs
either direct inputs or synchronous inputs

⇒

Assertion (A): In loss of charge method, it is preferable to use an electronic voltmeter.

Reason (R): The resistance of electronic voltmeter is very high.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ The high voltage level of a digital signal in positive logic is
1
0
either 1 or 0
-1

⇒ For a photoengraving the mask used is
master mask
slave mask
working mask
photo mask

⇒ For a 50 Ω resistor for 3 GHz application, the stray capacitance should be less than
1 μF
1 nF
1 pF
0.1 pF

⇒ The 10 MHz in the specification of CRO means that
the sweep frequency is 10 MHz
the frequency of input signal should not be more than 10 MHz
the vertical amplifier has been designed for 10 MHz
none of the above

⇒ In the circuit shown, the steady state is reached with S open S is closed at t = 0, the current I in the 1 Ω resistor connected is to be determined at t = 0⁺ is give
1
2
3
42828

⇒

Assertion (A): In an R-L circuit having high inductance, the rise of current is very slow.

Reason (R): The time constant of R-L circuit is L/R.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ In telephone systems the relation between load r, number of calls initiated during a specified interval λ and average duration of a call (h) is
r = λh
r = λh²
λ = rh
h = λr

⇒ In the circuit of figure the current through L at t = &infin
0
0.416666666666667
6.67 A
5.1 A

⇒ L [f(t - a)] = F(jω) e^-jωa
TRUE
FALSE

⇒ Which of the following instruments is used almost exclusively to measure radio frequency currents?
Moving coil
Rectifier
Moving iron
Thermocouple

⇒ The self bias provides
stable Q point
large voltage gain
high input impedance
high base current

⇒ In 8085 microprocessor with memory mapped I/O which of the following is true?
I/O devices have 16 bit addresses
I/O devices are accessed during IN and OUT instructions
There can be a maximum of 256 input and 256 output devices
Logic operations can not be performed

⇒ The main advantage of TDM over FDM is
TDM requires more bandwidth than FDM
less complicated in hardware than FDM
better SNR
required filter

⇒ Basically a potentiometer is a device for
comparing two votage
measuring a voltage
comparing two currents
measuring a current

⇒ Which of the following transducers requires a high input impedance preamplifier for proper measurements?
Thermocouple
Piezoelectric
Thermistor
L.V.D.T

⇒ The rate of change of digital signals between High and Low level is
very fast
fast
slow
very slow

⇒ If the sign bit of mantissa is 0 and the exponent is increased from a positive to a more negative number the result is
a larger floating point number
a smaller floating point number
either (a) or (b) depending on the actual number
a negative floating point number

⇒ In a colour TV receiver, which of the following incorporates colour saturation control?
Chroma detector
Colour killer circuit
SAW filter
Chroma amplifier

⇒

Assertion (A): In a BCD to 7 segment decoder the number of outputs active at one time is always the same.

Reason (R): A decoder can be used to interface BCD input to LED display.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In the schematic representation of bipolar junction transistor, the direction of arrow shows the direction of flow of
holes
electrons
holes in pnp and electrons in npn
electrons in pnp and holes in npn

⇒ In a two stage cascade amplifier, each stage has a gain of 10 dB and noise figure of 10 dB. The overall noise factor is
10
1.09
1
10.9

⇒ The modulating frequency in frequency modulation is increased from 10 kHz to 30 kHz. The bandwidth is increased by
6
1/6 times
increase by 30 kHz
increase by 20 kHz

⇒ Measurement of Hall coefficient enables the determination of
recovery time of stored carrier
type of conductivity and concentration of charge carriers
temperature coefficient and thermal conductivity
Fermi level and forbidden energy gap

⇒ Consider the following ON GO TO statement in Ba
10, 20, 30, 20 respectively
10, 20, 20, 30 respectively
20, 30, 20, 10 respectively
10, 30, 20, 20 respectively

⇒ In figure, a voltmeter of internal resistance 1200 Ω is connected across 600 Ω resistance and it reads 5 V. The value of
1200 Ω
2400 Ω
3600 Ω
7200 Ω

⇒ At a frequency less than the resonant frequency
series circuit is inductive and parallel circuit is capacitive
series circuit is capacitive and parallel circuit is inductive
both circuits are capacitive
both circuits are inductive

⇒ In figure, the value of R shoul
0.2 Ω
0.1 Ω
0.05 Ω
0.1 Ω

⇒ The two numbers represent in signed 2's complement form are P = 11101101 and Q = 111001110. If Q subtracted from P, the value obtained in signed 2's complement form is
100000111
111
11111001
111111001