Question is ⇒ In a television camera tube, scanning of a picture is done, Options are ⇒ (A) line by line from left to right, (B) line by line from right to left, (C) line by line from top to bottom, (D) line by line from bottom to top, (E) , Leave your comments or Download question paper.

Question is ⇒ In a television camera tube, scanning of a picture is done, Options are ⇒ (A) line by line from left to right, (B) line by line from right to left, (C) line by line from top to bottom, (D) line by line from bottom to top, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a television camera tube, scanning of a picture is done
A.	line by line from left to right [Correct Answer]
B.	line by line from right to left [Wrong Answer]
C.	line by line from top to bottom [Wrong Answer]
D.	line by line from bottom to top [Wrong Answer]
View Answer 2 -2 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The effective height of an antenna is slightly greater than physical height because
wave velocity in conductor is less than its velocity in free space
wave velocity in conductor is more than its velocity in free space
resistance of conductor is less than that of free space
none of the above

⇒ Some desirable features of a computer communication network are

It should accept an intended transmission without excessive delay
The data arriving at a receiving point should be processed rapidly
When a transmission calls for a response, the delay of response should be minimum.

Which of the above are true?
1 and 2 only
1 and 3 only
1, 2, 3
2 and 3 only

⇒ A circular waveguide has an infinite set of TE and TM modes.
TRUE
FALSE

⇒ In case of low level amplitude modulation system, the amplifiers following the modulated stage must be
class C amplifiers
linear devices
non-linear devices
harmonic devices

⇒ Modulated carrier power in FM
increases with modulating signal power
decreases with modulating signal power
is independent of the modulating signal power
none

⇒ A transmitter serial current contains
carrier frequencies
audio frequencies
radio frequencies
none of the above

⇒ A sinusoidal ac voltage of amplitude 100 V is applied to a rectifying device which offers 10 Ω resistance in forward direction and infinite resistance in reverse direction. The reading on hot wire ammeter will be
0.416666666666667
0.208333333333333
3.185 A
1.414 A

⇒ Assuming accumulator contain A 64 and the carry is set (1). What will register A and (CY) contain after XRA A?
A 6 H, 1
A 6 H, 0
00 H, 0
00 H, 1

⇒ An ammeter of 0-25 A range has a guaranteed accuracy of 1% of full scale reading. The current measured is 5 A. The limiting error is
0.02
0.025
0.04
0.05

⇒ When a wave reaches the open circuited end of a line
all the forward energy is reflected by the open circuit
all the forward energy is absorbed by the open circuit
a small portion of energy is radiated into atmosphere and the remaining energy is reflected
either (a) or (b)

⇒ Tracking of extra terrestrial objects requires
high transmitting power
very sensitive receiver
fully steerable antenna
all of the above

⇒ Which pair is correctly matched?
Symmetrical two port AD - BC = 1
Reciprocal two port z₁₁ = z₁₂
Inverse hybrid parameter A, B, C, D
hybrid parameter (V₁, I₂) = f(I₁, V₂)

⇒ A single phase half bridge inverter required to feed R-L loads needs
2 thyristors
4 thyristors
2 thyristors and two diodes
4 thyristors and 4 diodes

⇒ In high power AM transmission, modulation is done at
IF stage
buffer stage
RF stage
oscillator stage

⇒ A full adder adds
2 bits
3 bits
4 bits
any number of bits

⇒ A JK flip flop has t_pd= 12 ns. The largest modulus of a ripple counter using these flip flops and operating at 10 MHz is
16
64
128
256

⇒ Which of the following are synonymous?
MOSFET and IGEFT
FET and JFET
JFET and MOSFET
P-N-P and N-P-N

⇒ X and Y are two random variable and Z = X + Y. Let σ_x², σ_y² and σ_z² be variance of X, Y and Z. Then
σ_z² = σ_x² + σ_y²
σ_z² ≤ σ_x² + σ_y²
σ_z² < σ_x² + σ_y²
σ_z² > σ_x² + σ_y²

⇒ A voltage multiplier circuit, using diodes and capacitors is suitable for
high voltage high current device
high voltage low current device
low voltage low current device
low voltage high current device

⇒ If the intermediate frequency of a superheterodyne receiver falls within the tuning range of the receiver
Unsuitability will occur
Heterodyne whistles will be heard
Tuning to the frequency band immediately adjacent to the intermediate frequency will become impossible
All of the above

⇒

Assertion (A): In a BJT base current is very small.

Reason (R): In a BJT recombination in base region is high.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ A sinusoidal ac voltage of amplitude 100 V is applied to a rectifying device which offers 10 Ω resistance in forward direction and infinite resistance in backward direction. A moving coil ammeter is also connected in the circuit. The reading of ammeter will be
0.416666666666667
0.208333333333333
3.185 A
14.14 A

⇒ In a digital measuring device the input electrical signal is in the frequency range of dc to ac (50) Hz. It must be sampled at a rate of
f times/sec
0.5 f times/sec
0.25 f times/sec
2 f times/sec

⇒ Vidicon and plumbicon operate on the principle of
photo conduction
photo emission
photo voltaic
none of the above

⇒ Find cut off wavelength for mode TE₁₁ in a circular waveguide having radius 2 cm. Assume K'_a = 1.841
4 cm
6.82 cm
8 cm
68.2 cm

⇒ In FORTRAN 77 IFIX (-73.2) gives the value
73
-73
-7
-73.2

⇒ Which component is allowed to pass through it by a choke filter?
Dc
Ac
Both dc and ac
Only high frequency ac

⇒ A wave E_m cos (bx - ωt) is a backward wave.
TRUE
FALSE

⇒ One of the following can be used to generate a pulse whenever triggered
flip-flop
monostable multivibrator
stable multivibrator
Schmitt trigger

⇒ In an n channel JFET, the gate is
n type
p type
either n or p
partially n & partially p