Question is ⇒ In a tape recorder the output from RF oscillator is given to, Options are ⇒ (A) only erase head coil, (B) only record head coil, (C) coils of both erase head and record head, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ In a tape recorder the output from RF oscillator is given to, Options are ⇒ (A) only erase head coil, (B) only record head coil, (C) coils of both erase head and record head, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a tape recorder the output from RF oscillator is given to
A.	only erase head coil [Correct Answer]
B.	only record head coil [Wrong Answer]
C.	coils of both erase head and record head [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Consider the following expressions in J
42, 40, 42 respectively
42, 42, 42 respectively
40, 42, 42 respectively
40, 40, 42 respectively

⇒ In the op-amp circuit of figure, V_{0V_i
3 V_i
5 V_i
0.5 V_i}

⇒ A series RLC circuit has a resonant frequency of 1000 Hz. The maximum voltage across C is likely to occur at a frequency of about
1000 Hz
2000 Hz
1025 Hz
975 Hz

⇒ The colour code on a carbon resistor is brown-black-red-gold. The value of resistance is
100 Ω
1000 Ω
1000 Ω ± 5%
1000 Ω ± 10%

⇒ If input ac is 10 V_rms, then maximum voltage that will appear across the diode of a half wave rectifier with a capacitor I/P filter will be
10 V
14 V
20 V
28 V

⇒ Which of the following impedance inversion is obtained?
Short-circuited stub
A quarter wave line
Balun transformer
A half wave line

⇒ In VHS format the width of tape is
2"
1"
1/2"
1/4"

⇒ The characteristic impedance of a cable is about
300 Ω
50 Ω
5 Ω
2 Ω

⇒ The input to an op-amp integrating amplifier is a constant voltage. The output will be
a constant voltage
a sawtooth wave
a ramp
ac voltage

⇒

Assertion (A): A graph is planar if it has a dual.

Reason (R): The dual of a graph can be found by window dot method.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Barkhausen criterion is 1 + A_vβ = 0.
TRUE
FALSE

⇒ In the spectrum of a FM wave
the carrier frequency cannot disappear
the carrier frequency disappears when the modulation index is large
the amplitude of any sideband depends on the modulation index
the total number of sidebands depends on the modulation index

⇒ In figure, the value of R shoul
5 kΩ
50 kΩ
20 kΩ
10 kΩ

⇒ An AM signal is detected using an envelope detector, the carrier frequency and modulating signal frequency are 1 MHz and 2 kHz respectively. An appropriate value for the time constant of the envelope detector is
500 μ sec
20 μ sec
0.2 μ sec
1 μ sec

⇒ The maximum effective aperture of λ/2 (half-wave) antenna is
0.013 λ²
0.13 λ²
1.3 λ²
13 λ²

⇒ Characteristic impedance of a coaxial cable is inversely proportional to ∈_r.
TRUE
FALSE

⇒ A JFET can operate on
enhancement mode only
depletion mode only
both depletion as well as enhancement modes
neither depletion nor enhancement mode

⇒ If V = 20 + j20, then log_e(A) A is
3.342 + j 45
28.28 ∠45°
400 ∠45°
3.342 + j 0.785

⇒ Nickel is a non-magnetic material.
TRUE
FALSE

⇒

Assertion (A): The response of a network to unit impulse can be obtained directly from the network function.

Reason (R): The response of a network for any input can be obtained from impulse response.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ In CE connection, the leakage current of a transistor is about
10 x 10^-9 A
5 x 10^-6 A
200 x 10^-6 A
5 x 10^-3 A

⇒

Assertion (A): The propagation delay in ECL is minimum

Reason (R): Transistors used in ECL switch between active and cutoff regions.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ A half adder adds __________ bits and a full adder adds __________ bits.
two, three
three, four
four, six
two, four

⇒ A continuous time LTI system is describe
(e^t - e^3t) u(t)
(e^-t - 3e^-3t) u(t)
(e^-t + e^-3t) u(t)
(e^t + e^3t) u(t)

⇒ In a colour TV receiver, PAL Dematrix consists of
chroma detector to separate the three primary colours
delay line and PAL matrix to give U and V signals
delay line and PAL matrix to give RGB colours
none of the above

⇒ In microprocessor 8088
8 data bits are multiplexed with 8 least significant bits of address bus
8 data bits are multiplexed with 8 most significant bits of address bus
16 data bits are multiplexed with 16 bits of address bus
none of the above

⇒ In the given figure, the curves 1, 2, 3 are respectively
all pass, minimum phase and non-minimum phase functions
minimum phase, all pass and non-minimum phase functions
non-minimum phase, all pass and minimum phase functions
minimum phase, non-minimum phase and all pass functions

⇒ 4 bit ripple counter and 4 bit synchronous counter are made using flip-flop having a propagation delay of 10 ns each. If the worst case delay in the ripple counter and the synchronous counter be R and S respectively, then
R = 10 ns, S = 40 ns
R = 40 ns, S = 10 ns
R = 10 ns, S = 30 ns
R = 30 ns, S = 10 ns

⇒ Calculate the wave impedance for TM mode in rectangular waveguide for dominant mode at 3 GHz having
(120p) Ω
377 Ω
226 Ω
629 Ω

⇒ The range of life time carriers (electrons and holes) is
1 μs to 100 μs
1 nano sec to 1 μs
1 nano sec to hundreds of μs
none of the above