Question is ⇒ In a system using QASK and 4 bits to form a symbol, the required bandwidth is, Options are ⇒ (A) same as BPSK, (B) half of that in BPSK, (C) one-fourth of that in BPSK, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ In a system using QASK and 4 bits to form a symbol, the required bandwidth is, Options are ⇒ (A) same as BPSK, (B) half of that in BPSK, (C) one-fourth of that in BPSK, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a system using QASK and 4 bits to form a symbol, the required bandwidth is
A.	same as BPSK [Wrong Answer]
B.	half of that in BPSK [Wrong Answer]
C.	one-fourth of that in BPSK [Correct Answer]
D.	none of the above [Wrong Answer]
View Answer 2 -2 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ If the energy is supplied from a source, whose resistance is 1 ohm, to a load of 100 ohms the source will be
a voltage source
a current source
both of the above
none of the above

⇒ In which one of the following types of analog to digital converts the conversion time is practically independent of the amplitude of the analog signal?
The dual slope integrating type
Successive approximation type
Counter ramp type
Tracking type

⇒ In op-amp integrating amplifier the input is feed to
inverting input
non-inverting input
both inverting and non-inverting input
either inverting or non-inverting input

⇒ Consider the following statements

Usable bandwidth of ridge wave guide is more than that of rectangular waveguide.
For a given value of TM₁₀ cutoff frequency the cross section of ridge wave guide is lesser that that of rect angular waveguide.
Ridge wave guide has higher conductor losser than a rectangular waveguide.
Ridge guide has higher conductor losser than a rectangular waveguide.

Which of the above statements are correct?
1 and 2 only
1, 2 and 3 only
2 and 3 only
All

⇒

Assertion (A): A GTO can be turned on and turned off by gate pulses

Reason (R): A GTO can be turned off by negative gate pulse.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ An AC source or RMS voltage 20V with internal impedance Z_s = (1 + 2j) Ω feeds a load of impedance Z_L = (7 + 4j) Ω in the figure below. The reactive power consumed by the loa
8 VAR
16 VAR
28 VAR
32 VAR

⇒ For matching over a range of frequencies in a transmission line it is best to use
a balun
a broad band directional coupler
double stub
a single stub of adjustable position

⇒ A duplexer is used to
couple two antennas to a transmitter
isolate the antenna from the local oscillator
prevent interference between two antennas connected to receiver
use an antenna for reception or transmission without interference

⇒ Calculate cut off frequency for dominant mode in rectangular waveguide if dimensions are a = 2, b = 1 cm.
7.5 GHz
1.5 GHz
15 GHz
150 GHz

⇒ Symbol shown in figure represen
P-channel enhancement MOSFET
N-channel DEMOSFET
UJT with P-type base
UJT with N-type base

⇒ If the energy gap of a semiconductor is 1.1 eV, then it would be
opaque to visible light
transparent to visible light
transparent to ultraviolet radiation
transparent to infrared radiation

⇒ Three resistance of 15 Ω each are connected in delta. The resistance of equivalent star will have a value of
15 Ω
5 Ω
5/3 Ω
45 Ω

⇒ The disturbance from adjacent power lines is known as
cross talk
cross fire
inductive disturbance
none of the above

⇒ The Thevenin equivalent circuit to the left of AB has R_{eq2 Ω
4 Ω
1 Ω
3 Ω}

⇒ If X(z) = (1 - az^-1), and |a| < |z|, the initial value x₀ is
1
0
2
∞

⇒ For a random variable x following the probability density function, p(x), shown in figure, the mean and the variance are respective
1/2 and 2/3
1 and 4/3
1 and 2/3
2 and 4/3

⇒ Soft iron is suitable for making temporary magnets.
TRUE
FALSE

⇒ In figure, V_{0-1 V
2 V
+1 V
+15 V}

⇒ In terms of signum function sgn(t), unit step function u(t) =
1 + sgn(t)
1 - sgn(t)
0.5 + 0.5 sgn(t)
0.5 - 0.5 sgn(t)

⇒ Which of the following circuits can operate class AB for audio power output?
Emitter follower
Push pull
Cascade
Darlington pair

⇒ The system shown in figure remains stable wh
k £ - 1
-1 < k < 1
l < k < 3
k > 3

⇒ The impedance of an RC series circuit is 12 Ω at f= 50 Hz. At f= 200 Hz, the impedance will be
more than 12
less than 3
more than 3 Ω but less than 12 Ω
more than 12 Ω but less than 24 Ω

⇒ When a lead acid battery is fully charged the colours of its positive and negative plates are
grey and dark brown
dark grey and brown
grey and brown
dark brown and grey

⇒ A parity detector can detect
single error only
single error or odd number of errors
two errors
single or two errors

⇒ A generator is feeding power to a transmission line of characteristic impedance Z₀. The line is terminated in impedance Z_L. Standing waves will be set up if
Z_L = Z₀
Z_L < Z₀
Z_L > Z₀
both (b) and (c)

⇒ Consider the following applications/ advantages of radar beacons

navigation
target identification
accurate tracking of enemy targets
large increase in maximum range

Which of the above are correct?
1, 2, 3, 4
1, 2, 4
1, 2
2, 3, 4

⇒

Assertion (A): Microstrip is very commonly used in microwave integrated circuits.

Reason (R): Microstrip has an easy access to the top-surface so that active and passive discrete components can be easily mounted.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Thu advantage of using a dual stop ADC in a digital voltmeter is that
its conversion time is small
its accuracy high
output is in BCD format
it does not require a comparator

⇒ The number of bits of information required to indicate the correct selection of 3 independent consecutive events out of 75 equally probable events is
6.23
18.69
10.46
24.92

⇒ Which of the following is the disadvantage of PDM and PPM?
It requires pulses of larger widths
More samples are needed per second
More powerful transmitter is required
None of the above