Question is ⇒ In a single phase half wave converter feeding resistive load and full wave converter (M - 2 connection) feeding a resistive load the circuit conditions are similar. The firing angle is a. Then the waveshapes of voltages across thyristors, Options are ⇒ (A) are similar, (B) are not similar, (C) may be similar or dissimilar, (D) are similar only for some values of a, (E) , Leave your comments or Download question paper.

Question is ⇒ In a single phase half wave converter feeding resistive load and full wave converter (M - 2 connection) feeding a resistive load the circuit conditions are similar. The firing angle is a. Then the waveshapes of voltages across thyristors, Options are ⇒ (A) are similar, (B) are not similar, (C) may be similar or dissimilar, (D) are similar only for some values of a, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a single phase half wave converter feeding resistive load and full wave converter (M - 2 connection) feeding a resistive load the circuit conditions are similar. The firing angle is a. Then the waveshapes of voltages across thyristors
A.	are similar [Correct Answer]
B.	are not similar [Wrong Answer]
C.	may be similar or dissimilar [Wrong Answer]
D.	are similar only for some values of a [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ ∈_r is determined by the atomic structure of the dielectric.
TRUE
FALSE

⇒ The power dissipated in 4 Ω resistance in figur
64 W
32 W
16 W
8 W

⇒ When the core of a saturable reactor is saturated, the inductance is high.
TRUE
FALSE

⇒ Find Y in the circuit bel
f₂
f₂
0
∑(0, 1, 2, 3, 5, 6, 9)

⇒ Consider z transform of a signal as given b
IIR
FIR
Depends on value of n
Cannot determined

⇒ The output resistance of a microphone is 20 ohms. It is to feed a line of impedance 320 ohms. To ensure maximum power transfer, the turn ratio of transformer is
16
256
2
4

⇒ The use of thermocouple meters for ac measurement leads to a scale which is
linear
square law
logarithmic
exponential

⇒ Reluctivity is analogous to
permeability
conductivity
resistivity
retentivity

⇒ Two port circuits are connected in parallel. To determine the response, it is more convenient to use
O.C. impedance parameters
S.C. admittance parameters
ABCD parameters
h parameters

⇒ The most suitable method for detecting a modulated signal g(t) = (3 to 6 cos 2pf_mt) cos 2pf_ct is
envelope detector
synchronous detector
ratio detector
both a and b

⇒ The two numbers represent in signed 2's complement form are P = 11101101 and Q = 111001110. If Q subtracted from P, the value obtained in signed 2's complement form is
100000111
111
11111001
111111001

⇒

Assertion (A): In Hall effect the O.C. transverse voltage developed by a current carrying semiconductor with a steady magnetic field perpendicular to the current direction has opposite signs for n and p semiconductors.

Reason (R): The magnetic field pushes both holes and electrons in the same direction.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ In a highly capacitive circuit the
apparent power is equal to the actual power
reactive power is more than the apparent power
reactive power is more than the actual power
actual power is more than its reactive power

⇒ Short circuit is the dual of open circuit.
TRUE
FALSE

⇒ When a semi-conductor is doped, its electrical conductivity
increases
decreases in the direct ratio of the doped material
decreases in the inverse ratio of the doped material
remains unaltered

⇒ Which of the following pulse-time modulation is least used?
PDM
PPM
PWM
PAM

⇒ As the diameter of a wire is doubled, the resistance becomes
twice
one half
one fourth
four times

⇒

Match the following:

	List I		List II
A.	lag compensation	1.	Exterior of unit circle \|z\| = 1
B.	lead compensation	2.	PD control
C.	stability	3.	Non-minimum phase
D.	Instability	4.	Left half s plane
		5.	PI control

A-2, B-5, C-1, D-3
A-3, B-1, C-2, D-5
A-1, B-2, C-3, D-4
A-5, B-2, C-4, D-1

⇒ In a p-n-p transistor operating in forward active mode
base is positive with respect to emitter and collector
base is negative with respect to emitter and collector
emitter is positive with respect to base and base is positive with respect to collector
emitter is negative with respect to base and base is positive with respect to collector

⇒ A Hartley oscillator uses FET with g_m of 2 ms and r_d = 2 KΩ. The total coil inductance is 10 μH with turns ratio of input to output side of 1 : 10. It is tuned with a 50 pf capacitor. Find frequency of oscillations, amplifier gain margin in dB.
7.11 MHz, 13.97 dB
7.3 MHz, 14.1 dB
6.93 MHz, 12.9 dB
7.4 MHz, 13 dB

⇒ Consider isotropic radiator radiating a power of 1 watt. At a distance of 1 metre, the power per unit area with equal
1 watt/m²
4p watt/m²
1/4p watt/m²
2p watt/m²

⇒ Which of the following types of noise assumes greater importance at high frequencies?
Transit time noise
Shot noise
Impulse noise
Random noise

⇒ The main application of enhancement mode MOSFET is in
amplifier circuits
oscillator circuits
switching circuits
all of the above

⇒ The generic microprocessor contains a zero and a carry flag. These are located on
interrupt control
status register
either (a) or (b)
none of the above

⇒ A transistor with a = 0.9 and I_CBO = 10 μA is biased so that I_BQ = 90 μA. Then I_EQ will be
5.15 mA
5.2 mA
5 mA
990 mA

⇒

Assertion (A): The main use of Miller integrator is to generate ramp

Reason (R): An inverting amplifier can handle more than one input at the same time.

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒

Match the following:

	List I (Application of circuit)		List II (Circuit Name)
A.	Divider	1.	Astable multivibrator
B.	Clips input voltage at two predetermined levels	2.	Schmitt trigger
C.	Square wave generator	3.	Bistable multivibrator
D.	Narrow current pulse generator

A-4, B-2, C-1, D-3
A-3, B-2, C-1, D-4
A-4, B-1, C-2, D-3
A-3, B-1, C-2, D-4

⇒ A signal m(t) is multiplied by a sinusoidal waveform of frequency f_c such
0.5 M(f + f_c)
0.5 M(f - f_c)
0.5 M(f + f_c) + 0.5 M(f - f_c)
0.5 M(f - f_c) + 0.5 M(f - f_c)

⇒ In figure, S is closed at t = 0. At t = t₁, I = 1 A and di/dt = 1 A/s. Then the value of
1 H
2 H
3 H
4 H

⇒ If x^k = a^k and k &g
TRUE
FALSE