Question is ⇒ In a single phase full wave regulator feeding a resistive load, the average current over one full cycle, Options are ⇒ (A) is always zero, (B) cannot be zero, (C) may be sometimes zero, (D) is always positive, (E) , Leave your comments or Download question paper.

Question is ⇒ In a single phase full wave regulator feeding a resistive load, the average current over one full cycle, Options are ⇒ (A) is always zero, (B) cannot be zero, (C) may be sometimes zero, (D) is always positive, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a single phase full wave regulator feeding a resistive load, the average current over one full cycle
A.	is always zero [Correct Answer]
B.	cannot be zero [Wrong Answer]
C.	may be sometimes zero [Wrong Answer]
D.	is always positive [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In figure the bridge is balanced when Z₄
120∠70°
187.5∠ - 10°
187.5∠ - 70°
333.3∠ - 70°

⇒ Consider the following statement associated with bipolar junction transistor and JFET

The former has higher input impedance than the later
The former has higher frequency stability than the later
The later has lower noise figure than the former
The later has higher power rating than the former.

Of these statements
1 and 2 are correct
2 and 3 are correct
3 and 4 are correct
1 and 4 are correct

⇒ The output V_R of the ratio detector is related with the output V_F of similar Foster-Seeley discriminator as follows.
V_R = V_F
V_R < V_F
V_R = 2V_F
V_F = 2V_R

⇒ Chrome signals in PAL colour television system consist of
R - Y and B - Y signal
V and U signals
I and Q signals
R - Y and G - Y signals

⇒ A zener diode is used in
voltage regulator circuit
amplifier circuits
both voltage regulator and amplifier circuit
none of the above

⇒ A parallel ac circuit in resonance will
act like a resistor of low value
have a high impedance
have current in each section equal to the line current
have a high voltage developed across each inductive and capacitive section

⇒ A Q meter uses the principle of
variation of self inductance
variation of mutual inductance
series resonance
none of the above

⇒ A half adder adds
2 bits
3 bits
4 bits
2 or 3 bits

⇒ The RF section of a radio transmit generally consists of
master oscillator
final power amplifier to feed antenna
buffer stage
all of the above

⇒ Current derating may be necessary when thyristors are operating in
series
parallel
series or parallel
none of the above

⇒ The parallel RLC circuit shown in figure is in resonance
I_R < 1 mA
| I_R + I_L | > 1 mA
| I_R + I_L | < 1 mA
| I_L + I_C | > 1 mA

⇒ The useful operational life of INSAT-IB (launched in 1983) is expected to end by
1992-93
1991-92
1989-90
1993-94

⇒ Consider the following expressions which indicate the step or impulse response of an initially relaxed system

[5 - 4 e^-2t] u(t)
[e^-2t + 5] u(t)
d(t) + 8 e^-2t u(t)
d(t) + 4 e^-2t u(t)

Those which correspond to the step and impulse response of the same system include
1 and 3
1 and 4
2 and 4
2 and 3

⇒ Which of the following is not advantage of FM over AM?
Noise immunity
Capture effect
Fidelity
Spluttering effect

⇒ A 16 bit type ADC uses 1 MHz clock its maximum conversion time is __________ .
16 μs
15 ms
6.5 ms
66 ms

⇒ In a system an input resistance of 20 kΩ causes a noise voltage of 15μV. If two such input resistances each of 20 kΩ are used in parallel, the total noise voltage will be about
15 μV
30 μV
7.5 μV
10.6 μV

⇒ In CE amplifier
input and output are in phase
phase difference between input and output is 30° to 90°
phase difference between input and output is 60° to 120°
output is inverted with respect to its input voltage

⇒ The SID data received is
LSB first
LSB last
1
none of these

⇒ A 5000 W signal is attenuated by - 196 dB. The resultant signal strength is
1.26 x 10⁶ W
1.26 x 10^-2 W
1.26 x 10^-8 W
1.26 x 10^-16 W

⇒ The measure of mismatch between the load and the transmission line is known as
directivity
Gain
standing wave ratio
reflection coefficient

⇒ Which gives minimum probability of error?
ASK
FSK
PSK
DPSK

⇒ The trigonometric Fourier series for the waveform f(t) shown below con
only cosine terms and zero value for the dc component
only cosine terms and a positive value for the dc component
only cosine terms and a negative value for the dc component
only sine terms and a negative for the dc component

⇒ In the following non planar graph number of independent loop equations
8
12
7
5

⇒ To ensure that a zener diode does not get destroyed
the applied voltage should not exceed breakdown voltage
the current should not exceed rated current
the current should be less than magnitude of barrier potential
both (a) and (b)

⇒ Which one of the following is correct?
Coding reduces the noise in the signal
Coding deliberately introduces redundancy into messages
Coding increases the information rate
Coding increases the channel bandwidth

⇒ An impulse function consist of
pure dc
pure a.c
entire frequency range with constant phase
infinite bandwidth with linear phase vaariations

⇒

Assertion (A): The frequency of light used for photoelectric emission is high.

Reason (R): As per Einstein's equation 0.5 mv² < hf - U_w.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ At present, the radio-frequency band mainly used by most satellites is
EHF
UHF
VHF
SHF

⇒ The critical frequency of 'F' layer is greater than 30 MHz.
TRUE
FALSE

⇒ In figure, the position of voltmeter and ammeter are exchanged. It may result in damage
both the instruments
ammeter
voltmeter
neither of two