Question is ⇒ In a single phase full wave ac regulator the rms value of load current is 20 A load is purely resistive. Then, Options are ⇒ (A) average thyristor current will be less than 20 A but rms thyristor current will be more than 20 A, (B) both the average and rms thyristor currents will be less than 20 A, (C) both the average and rms thyristor currents will be more than 20 A, (D) rms thyristor current will be 20 A and average thyristor current will be 10 A, (E) , Leave your comments or Download question paper.

Question is ⇒ In a single phase full wave ac regulator the rms value of load current is 20 A load is purely resistive. Then, Options are ⇒ (A) average thyristor current will be less than 20 A but rms thyristor current will be more than 20 A, (B) both the average and rms thyristor currents will be less than 20 A, (C) both the average and rms thyristor currents will be more than 20 A, (D) rms thyristor current will be 20 A and average thyristor current will be 10 A, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a single phase full wave ac regulator the rms value of load current is 20 A load is purely resistive. Then
A.	average thyristor current will be less than 20 A but rms thyristor current will be more than 20 A [Wrong Answer]
B.	both the average and rms thyristor currents will be less than 20 A [Correct Answer]
C.	both the average and rms thyristor currents will be more than 20 A [Wrong Answer]
D.	rms thyristor current will be 20 A and average thyristor current will be 10 A [Wrong Answer]
View Answer 2 -2 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The bandwidth of DSB suppressed carrier modulation system when the modulating frequency varies between 500 Hz and 5 kHz is
555 kHz
505 kHz
500 kHz
9 kHz

⇒ If A = 7 ∠15, A² is
49 ∠225°
49 ∠30°
49 ∠15°
49 ∠7.5°

⇒ In a 3 phase system, the zero sequence component of line to line voltages is zero
if line to line voltages are balanced
if line to line voltages are unbalanced
if line to line voltages are balanced or unbalanced
if degree of unbalanced in line to line voltages is small

⇒ Brewster angle is the angle for which there is
no reflection and the incident wave is vertically polarized
reflection and the incident wave is horizontally polarized
no reflection and the incident wave is horizontally polarized
none of the above

⇒ The primary function of lag compensator is to provide sufficient
gain margin
phase margin
both gain margin and phase margin
either (a) or (b)

⇒ In a metal, the valence electrons
are not shared
are shared only between neighbouring atoms
are shared by all atoms
either (b) or (c)

⇒ Which control action is also called rate control?
Proportional
Derivative
Integral
Proportional plus integral

⇒ For broadcasting purpose, full AM signal is preferred to SSB signal because
it requires large bandwidth
generation of full AM is easier
detection of full AM is simpler
none of the above

⇒ In a JK flip flop toggle means
set Q = 1 and Q = 0
set Q = 0 and Q = 1
change the output to the opposite state
no change in output

⇒ It is desired to design a phase shift oscillator using an FET having a g_m = 5000 μSiemen, r_d = 40 kΩ and feedback circuit value of R = 10 K. Then value of C for oscillator operation at 1 kHz and that of R_D for A = 40 to ensure oscillator action are
6.4 nF, 80 K
6.5 nF, 10 K
6.5 pF, 10 K
65 pF, 80 K

⇒ Microwave signals follow the curvature of the earth and the phenomenon
tropospheric scatter
faraday effect
duct propagation
none

⇒ A string of series connected thyristors needs equalising circuit to
ensure proper firing
ensure proper current division
ensure proper voltage division
none of the above

⇒ Which of the following is error correcting code?
EBCDIC
Gray
Hamming
ASCII

⇒ Among the logic families, the family which can be used at very high frequency greater than 100 MHz in a 4 bit synchronous counter is
TTL
CMOS
ECL
TTLLS

⇒ At t = 0⁺, the current i_{1- V/2R
- V/4R
- V/R
zero}

⇒ In a CE amplifier drives a low load resistance directly the result will be
overloading of amplifier
underloading of amplifier
overloading or underloading of amplifier depending on circuit
none of the above

⇒ If zeros at infinity are included in the count, the number of zeros of G(s) H(s) is
equal to number of poles
one more than the number of poles
one less than the number of poles
none of the above

⇒ A single phase full wave regulator feeds a resistive load. The firing angle of thyristors is 90°. The input power factor is
1
0.707 lagging
0.5 lagging
0.2 lagging

⇒ Consider the following statements in amplitude modulation

The harmonic and intermodulation distortion may occur in audio and RF amplifiers
The sum and difference frequencies are present in the output of mixer
The diode detector has audio frequencies in its output
A balanced modulator cannot produce an AM with suppressed carrier

Which of the above are true?
1, 2, 3, 4
1, 2, 3
1, 2
3, 4

⇒ In the given figure shows a logic circuit. The minimum Boolean expression for this circui
A + B
A + B + C
AB + C
AB + AC + BC

⇒

Assertion (A): A large negative feedback is deliberately introduced in an amplifier to make its gain independent of variation is in parameters of active device and other components.

Reason (R): A large negative feedback results in a high value of return difference compared to unity which makes the feedback gain inversely proportional to feedback factor.

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ In following circuit, steady state is reached with S open, S is closed at t = 0, the current I at t = 0⁺ is give
9 Ω
6 Ω
7 Ω
10 Ω

⇒ A 3 kV circuit uses SCR of 800 V rating. If derating is 25%, the number of SCRs in series is
4
5
6
8

⇒ The polar plot of P (jω) = 45° as ω varies from -∞ to ∞ is
a straight line parallel to x-axis
a straight line parallel to y-axis
a line passing through origin and inclined at 45°
a line in first quadrant passing through origin and inclined at 45° to positive x-axis

⇒ An amplifier has input impedance of 4 kΩ and output impedance of 80 kΩ. It is used in negative feedback circuit with 10% feedback. If open loop gain is 90, the closed loop input and output impedances are
40 kΩ and 8 kΩ respectively
4 kΩ and 80 kΩ respectively
0.4 kΩ and 800 kΩ respectively
8 kΩ and 160 kΩ respectively

⇒ Which of the following best represents the input impedance of an actual op-amp?
10 ohm
1 k ohm
1 M ohm
100 M ohm

⇒ In terms of signum function sgn(t), unit step function u(t) =
1 + sgn(t)
1 - sgn(t)
0.5 + 0.5 sgn(t)
0.5 - 0.5 sgn(t)

⇒ Frequency range for satellite communication is
1 kHz to 100 kHz
100 kHz to 10 MHz
10 MHz to 100 MHz
1 GHz to 30 GHz

⇒ A + (B . C) =
A . B + C
A . B + A . C
A
(A + B) . (A + C)

⇒ For the amplifier in figure, β = 800. The mid-band voltage gain V₀/V_{i0
< 1
≈ 1
800}