Users Also Read
MCQ's Search Engine
Electrical Engineering
Mechanical Engineering
Civil Engineering
Automobile Engineering
Chemical Engineering
Computer Engineering
Electronics Engineering
Medical Science Engg
In a sine wave, maximum rate of change of voltage occurs at | |
A. | ascent of the waveform [Wrong Answer] |
B. | + ve maximum [Wrong Answer] |
C. | - ve maximum [Wrong Answer] |
D. | between maximum and minimum [Correct Answer] |
View Answer
Explanation:-
Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result |
Also Read Similar Questions Below :
⇒ Ground wave can be used for communication upto
5 kHz
12 kHz
16 kHz
25 kHz
⇒ For an N bit ADC, the percentage resolution is [1/2^{N} - 1)] 100.
TRUE
FALSE
⇒ A signal x_{1}(t) and x_{2}(t) constitute the real and imaginary parts respectively of a complex valued signal x(t). What form of waveform does x(t) possess?
Real symmetric
Complex symmetric
Asymmetric
Conjugate symmetric
⇒ With the switch in STOP position, Y will be equa
0
1
CLK
none of these
⇒ Which synthesis procedure requires the use of mutual inductance?
Foster's synthesis
Cauer synthesis
Bott-Duffin synthesis
Brune's synthesis
⇒ A dominant wave is characterised by which of the following?
No attenuation
Lowest cut off wavelength
Highest cut off wavelength
All of the above
⇒ For the infix expression (A/B) * (C * F + (A - D) * E) the corresponding Post fix notation is
A / D * CF AD - F * +
AB / CF * AD - E * + *
AB / C * FAD - E * + *
None of the above
⇒ In the field controlled motor the entire damping comes from
armature resistance
back emf
motor friction and load
field resistance
⇒ A 6 bit R-2R ladder D/A converter has a reference voltage of 6.5 V. It meets standard linearity then resolution in percent and volts.
3% 7 V
6.4 V, 2%
0.1%, 1.57 V
1.57%, 0.1 V
⇒ Which of the following does not cause losses in optical fibre cables?
Stepped index operation
Impurities
Microbending
Attenuation in glass
⇒ Consider the Schmitt trigger circuit shown below. A triangular wave which goes from - 12 V to 12 V is applied to the inverting input of the op-amp. Assume that the output of the op-amp moves from +15 V to -15 V. The voltage at the non-inverting switches bet
-12 V and +12 V
-7.5 V and +7.5 V
-5 V and +5 V
0 V and 5 V
⇒ In a good voltage amplifier, its input impedance
must be high compared to the resistance of the source
must be low compared to the resistance of the source
must be equal to the resistance of the source
must be half the resistance of the source
⇒ A copper specimen has resistivity equal to 1.8 x 10^{-8} ohm-m at room temperature. At a temperature of 700 K, the resistivity is likely to be
1.6 x 10^{-8} Ω-m
2 x 10^{-8} Ω-m
3 x 10^{-8} Ω-m
6 x 10^{-8} Ω-m
⇒ Hysteresis loss is proportional to
f and B^{1.6}_{m}
f and B_{m}
f^{2} and B_{m}
f^{2} and B^{2}_{m}
⇒ In 8085
all operations are on 8 bit data
majority of operations are on 8 bit data
all operations are on 8 bit or 4 bit data
either (a) or (c)
⇒ Which is correct for a transfer function?
The poles and zero must be complex
If the poles and zeros are complex or imaginary, they must be conjugate
If the poles and zeros are complex they must be simple
If a zero is imaginary, it must be simple
⇒ A balun transformer gives an impedance transformation of
0.167361111111111
0.0840277777777778
0.0444444444444444
0.0430555555555556
⇒ A 4 bit binary adder has 4 full adders.
TRUE
FALSE
⇒ If E_{b}, the energy per bit of a binary digital signal is 10^{-6} watt sec. and the one sided power spectral density of the white noise N_{0} = 10^{-5} W/Hz, then the output SNR of the matched filter is
26 dB
10 dB
20 dB
13 dB
⇒ In figure the bridge is balanced when Z_{4}
120∠70°
187.5∠ - 10°
187.5∠ - 70°
333.3∠ - 70°
⇒ The upper and lower side frequencies for 3 kHz audio modulation with a 27 MHz carrier frequency will be
30 and 24 MHz
27.3 and 26.7 MHz
27.3 and 26.97 MHz
27.3 and 26.97 MHz
⇒ Carbon resistances are used in very high values.
TRUE
FALSE
⇒ A radio frequency signal contains the following three frequencie
Push pull amplifier
Wideband amplifier
Audio frequency amplifier
Tuned voltage amplifier
⇒ In C-language f- = 9 is equivalent to
f = -9
f = f - 9
f = 9 - 1
-f = 9
⇒ An RLC series circuit is underdamped. To make it overdamped, the value of R
has to be increased
has to be decreased
has to be increased to infinity
has to be reduced to zero
⇒ In communication systems the frequency range used for voice is
15 Hz to 150 Hz
30 Hz to 1000 Hz
100 Hz to 1500 Hz
300 Hz to 3800 Hz
⇒ The fabrication of microstrip line is done by
photo etching
printed circuit technique
oxidation
cladding
⇒ The maximum power dissipation capacity of a transistor is 50 mW. If the collector emitter voltage is 10 V, what is the safe collector current that can be allowed through the transistor?
5 mA
2.5 mA
10 mA
25 mA
⇒ Which of the following is operating system?
MS WORD
Ventura
Java
Windows
⇒ A communication receiver is
TRF receiver
a superheterodyne receiver
either (a) or (b)
neither (a) nor (b)
⇒ Ground wave can be used for communication upto
5 kHz
12 kHz
16 kHz
25 kHz
⇒ For an N bit ADC, the percentage resolution is [1/2^{N} - 1)] 100.
TRUE
FALSE
⇒ A signal x_{1}(t) and x_{2}(t) constitute the real and imaginary parts respectively of a complex valued signal x(t). What form of waveform does x(t) possess?
Real symmetric
Complex symmetric
Asymmetric
Conjugate symmetric
⇒ With the switch in STOP position, Y will be equa
0
1
CLK
none of these
⇒ Which synthesis procedure requires the use of mutual inductance?
Foster's synthesis
Cauer synthesis
Bott-Duffin synthesis
Brune's synthesis
⇒ A dominant wave is characterised by which of the following?
No attenuation
Lowest cut off wavelength
Highest cut off wavelength
All of the above
⇒ For the infix expression (A/B) * (C * F + (A - D) * E) the corresponding Post fix notation is
A / D * CF AD - F * +
AB / CF * AD - E * + *
AB / C * FAD - E * + *
None of the above
⇒ In the field controlled motor the entire damping comes from
armature resistance
back emf
motor friction and load
field resistance
⇒ A 6 bit R-2R ladder D/A converter has a reference voltage of 6.5 V. It meets standard linearity then resolution in percent and volts.
3% 7 V
6.4 V, 2%
0.1%, 1.57 V
1.57%, 0.1 V
⇒ Which of the following does not cause losses in optical fibre cables?
Stepped index operation
Impurities
Microbending
Attenuation in glass
⇒ Consider the Schmitt trigger circuit shown below. A triangular wave which goes from - 12 V to 12 V is applied to the inverting input of the op-amp. Assume that the output of the op-amp moves from +15 V to -15 V. The voltage at the non-inverting switches bet
-12 V and +12 V
-7.5 V and +7.5 V
-5 V and +5 V
0 V and 5 V
⇒ In a good voltage amplifier, its input impedance
must be high compared to the resistance of the source
must be low compared to the resistance of the source
must be equal to the resistance of the source
must be half the resistance of the source
⇒ A copper specimen has resistivity equal to 1.8 x 10^{-8} ohm-m at room temperature. At a temperature of 700 K, the resistivity is likely to be
1.6 x 10^{-8} Ω-m
2 x 10^{-8} Ω-m
3 x 10^{-8} Ω-m
6 x 10^{-8} Ω-m
⇒ Hysteresis loss is proportional to
f and B^{1.6}_{m}
f and B_{m}
f^{2} and B_{m}
f^{2} and B^{2}_{m}
⇒ In 8085
all operations are on 8 bit data
majority of operations are on 8 bit data
all operations are on 8 bit or 4 bit data
either (a) or (c)
⇒ Which is correct for a transfer function?
The poles and zero must be complex
If the poles and zeros are complex or imaginary, they must be conjugate
If the poles and zeros are complex they must be simple
If a zero is imaginary, it must be simple
⇒ A balun transformer gives an impedance transformation of
0.167361111111111
0.0840277777777778
0.0444444444444444
0.0430555555555556
⇒ A 4 bit binary adder has 4 full adders.
TRUE
FALSE
⇒ If E_{b}, the energy per bit of a binary digital signal is 10^{-6} watt sec. and the one sided power spectral density of the white noise N_{0} = 10^{-5} W/Hz, then the output SNR of the matched filter is
26 dB
10 dB
20 dB
13 dB
⇒ In figure the bridge is balanced when Z_{4}
120∠70°
187.5∠ - 10°
187.5∠ - 70°
333.3∠ - 70°
⇒ The upper and lower side frequencies for 3 kHz audio modulation with a 27 MHz carrier frequency will be
30 and 24 MHz
27.3 and 26.7 MHz
27.3 and 26.97 MHz
27.3 and 26.97 MHz
⇒ Carbon resistances are used in very high values.
TRUE
FALSE
⇒ A radio frequency signal contains the following three frequencie
Push pull amplifier
Wideband amplifier
Audio frequency amplifier
Tuned voltage amplifier
⇒ In C-language f- = 9 is equivalent to
f = -9
f = f - 9
f = 9 - 1
-f = 9
⇒ An RLC series circuit is underdamped. To make it overdamped, the value of R
has to be increased
has to be decreased
has to be increased to infinity
has to be reduced to zero
⇒ In communication systems the frequency range used for voice is
15 Hz to 150 Hz
30 Hz to 1000 Hz
100 Hz to 1500 Hz
300 Hz to 3800 Hz
⇒ The fabrication of microstrip line is done by
photo etching
printed circuit technique
oxidation
cladding
⇒ The maximum power dissipation capacity of a transistor is 50 mW. If the collector emitter voltage is 10 V, what is the safe collector current that can be allowed through the transistor?
5 mA
2.5 mA
10 mA
25 mA
⇒ Which of the following is operating system?
MS WORD
Ventura
Java
Windows
⇒ A communication receiver is
TRF receiver
a superheterodyne receiver
either (a) or (b)
neither (a) nor (b)