Question is ⇒ In a series resonant circuit Q is more than 10. Then the lower half power frequency ω1, and resonant frequency ω0 are related as, Options are ⇒ (A) ω1 = ω0 + bandwidth, (B) ω1 = ω0 + 0.5 (bandwidth), (C) ω1 = ω0 - 0.5 (bandwidth), (D) ω1 = ω0 + bandwidth, (E) , Leave your comments or Download question paper.

Question is ⇒ In a series resonant circuit Q is more than 10. Then the lower half power frequency ω1, and resonant frequency ω0 are related as, Options are ⇒ (A) ω1 = ω0 + bandwidth, (B) ω1 = ω0 + 0.5 (bandwidth), (C) ω1 = ω0 - 0.5 (bandwidth), (D) ω1 = ω0 + bandwidth, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a series resonant circuit Q is more than 10. Then the lower half power frequency ω₁, and resonant frequency ω₀ are related as
A.	ω₁ = ω₀ + bandwidth [Wrong Answer]
B.	ω₁ = ω₀ + 0.5 (bandwidth) [Wrong Answer]
C.	ω₁ = ω₀ - 0.5 (bandwidth) [Correct Answer]
D.	ω₁ = ω₀ + bandwidth [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For a BJT, under the saturation condition,
I_C = βI_B
I_C = aI_B
I_C is independent of all other parameters
I_C < βI_B

⇒ Which part of radio spectrum is more crowded?
Lower frequency part
Higher frequency part
Both (a) and (b)
None of these

⇒ Consider the following statements: In a differential amplifier using JFET, the differential output offset is due to

mismatch between FET parameters
difference in values of resistances used in circuit
variation in supply voltage.

Of the statements, the correct statements are
1 and 2
1, 2, 3
2, 3
1, 3

⇒ The electric field of an EM wave propagating in the z direction given
linearly polarized in z direction
elliptically polarized
left hand circularly polarized
right hand circularly polarized

⇒ If the peak value of output of a half wave rectifier is 100 V, the rms value is
100 V
50 V
70.7 V
35.35 V

⇒ A uniform wave have components
in the perpendicular direction E existing while H is zero
in the direction of propagation E existing while H is zero
E and H are zero in direction perpendicular to direction of propagation
E and H existing only in direction perpendicular to direction of propagation

⇒ What will be minimum conversion rate in 6 bit dual slope A/D converter uses a reference of -6v and a 1 MHz clock. It uses a fixed count of 40 (101000).
9000
9259
1000
1000

⇒ The maximum power output of a standard A earth station over the total band allocated to satellite communication is about
0.5 kW
8 kW
20 kW
50 kW

⇒ Two similar mutually coupled coils have a total inductance of 900 mH and coefficient of coupling 0.5. The self inductance of each coils is
300 mH
150 mH
75 mH
50 mH

⇒ A trinitron colour picture tube uses
three electron guns
one electron gun
one electron gun with three separate in line cathodes
none of the above

⇒ Which of the following number specification refers to FET with one gate?
2N
3N
3Y
3X

⇒ The material used for the magnet of moving coil cone type loudspeaker is
steel alloy
soft iron
hard steel
Alnico

⇒ Frequency shift keying is used mostly in
telegraphy
telephony
satellite communication
radio transmission

⇒ In PCM, the quantization noise depends on
sampling rate
signal power
number of quantization level
signal energy

⇒ Which of the following amplifiers has a voltage gain of less than 1?
CE
CC
CB
CE or CB

⇒ Gold is often diffused into silicon P-N junction devices to
increase recombination rate
reduce recombination rate
make silicon a direct gap semiconductor
make silicon semimetal

⇒

Assertion (A): When Diode used as rectifier the reverse breakdown voltage should not be exceeded.

Reason (R): A high inverse voltage can destroy a p-n junction.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ On which of the following effect do thermocouples work?
Thomson effect
Seeback effect
Peltier effect
Joule effect

⇒ When a wave reaches an open circuit
the voltage at termination is doubled the incident voltage
the current at termination is doubled the incident voltage
the voltage at termination is zero
both V and I at termination are doubled the incident voltage and current

⇒ In a low level AM system, the modulated amplifiers stage must be
harmonic devices
non-linear devices
class C amplifier
linear devices

⇒ Which of the following statement about JFET is true?
In a JFET, gate and source have opposite polarity with respect to drain irrespective of the type of FET
In its schematic symbol for JFET, the arrow always points to p-type material
In an n-channel JFET, the channel is the narrowest under zero gate bias condition
In JFET, gate source cut off voltage is numerically equal to the pinch off voltage

⇒ An RC impadence function has a pole at s = 0. The first element in the Foster form of synthesis
is R
may be R and C
is C
is R and C in parallel

⇒ Which of the following is not necessarily the advantages of a push pull amplifier?
It gives more output
It removes odd a well as even harmonics
There is no effect of ripple of the power supply
It consumes least power

⇒ The chemical properties of atoms are determined by all the electrons and their configuration.
TRUE
FALSE

⇒ In the above case if another sine wave corresponding to 40% modulation is transmitted simultaneously, the total radiated power will be
9.9 kW
10.15 kW
10.84 kW
18.4 kW

⇒ The phase angle of lead circuit is
between 0 and -90°
between 0 and +90°
90°
more than 90°

⇒ The material used in RTD is
linear
aluminium
silver
platinum

⇒ A single phase full converter can operate in
4 quadrants
3 quadrants
2 quadrants
1 quadrant

⇒ The binary addition 1 + 1 =
11
10
111
100

⇒ Donor energy level is n type semiconductor is very near valence band.
TRUE
FALSE