Question is ⇒ In a series inverter, Options are ⇒ (A) the commutating elements L and C are in parallel, (B) the commutating elements L and C are in series with load, (C) the commutating L and C may be in series or parallel with the load, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ In a series inverter, Options are ⇒ (A) the commutating elements L and C are in parallel, (B) the commutating elements L and C are in series with load, (C) the commutating L and C may be in series or parallel with the load, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a series inverter
A.	the commutating elements L and C are in parallel [Wrong Answer]
B.	the commutating elements L and C are in series with load [Correct Answer]
C.	the commutating L and C may be in series or parallel with the load [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The upper and lower side frequencies for 3 kHz audio modulation with a 27 MHz carrier frequency will be
30 and 24 MHz
27.3 and 26.7 MHz
27.3 and 26.97 MHz
27.3 and 26.97 MHz

⇒ The relation AD - BC = 1 where A, B, C, D are transmission parameters of a network is valid for
every network
passive but not reciprocal network
passive and reciprocal network
both active and passive networks

⇒ The instrument used to check insulation of household wiring is
megger
ohmmeter
multimeter
high resistance voltmeter

⇒ For 10 bit PCM system, the signal to quantization noise ratio is 62 dB. If the number of bits is increased by 2, then the signal to quantization noise ratio will
increased by 6 dB
increased by 12 dB
decreased by 6 dB
decreased by 12 dB

⇒ Reflection from the object to be measured is significant only when the wavelength is
much bigger than the size of object
much smaller than the size of object
almost of the size of object
either (a) or (c)

⇒ Calculate the directivity of a given linear end fire, uniform array of 20 element, each separated by λ/3
100
10
26.66
30

⇒ An audio signal of FM radio station is sampled at a rate of 15% above the Nyquist rate. Signal is sampled in 512 levels and bandwidth of the signal is 4 KHz. The minimum bandwidth required to transmit this signal will be
77 K bits/sec
92 K bits/sec
84.8 K bits/sec
82.8 K bits/sec

⇒

Assertion (A): In 8085 when RESET OUT goes low processing begins.

Reason (R): CPU remains reset till RESET IN signal goes high.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ As the magnitude of reverse bias is increased, the capacitance of varactor diode
increases
decreases
first increase, then decreases
first decreases then increases

⇒ 11101₂ x 10001₂ =
111101101
111101100
11110
1100110

⇒ For 8 bit representation the minimum positive and minimum negative numbers are
2^-128 each
2^-28 and 2^-127
2^-127 and 2^-128
2^-127each

⇒ When x(n) is real then the Fourier series coefficients are correlated as __________ .
a_-k = a_k^*
a_k = ak^*
a_k+1 = a_k_*
a_-k+1 = a_k^*

⇒ Which of the following diode is designed to operate in the breakdown region?
Signal diode
Power diode
Zener diode
None of the above

⇒ In which function is each term known as minterm?
SOP
POS
Hybrid
Both SOP and POS

⇒ A varactor diode is
reverse biased
forward biased
biased to breakdown
unbiased

⇒ In 8085 microprocessor, which of the following interrupts is unmaskable interrupts?
RST 5.5
RST 7.5
TRAP
INTR

⇒ The slope of log magnitude asymptote changes by - 40 dB/ decade at a certain frequency and the error between asymptote and actual curve is - 6 dB. This means that
a double pole is present
a pair of complex conjugate poles is present
either a double pole or a pair of complex conjugate poles is present
either a pole or zero at that frequency is present

⇒ The characteristic equation of a control system is given as s⁴ + 8s³ + 24s² + 32s + K = 0. What is the range of values of K for this system to be stable?
0 ≤ K < 80
0 ≤ K < 100
0 ≤ K < 2300
0 ≤ K < 600

⇒ The given figure shows a control system. The maximum value of gain for which the system is stabl
3
3
4
5

⇒ In microwave system the function of mode filter is
to suppress modes with lower cut off frequencies
to suppress modes with higher cut off frequencies
to change mode of wave transmission
both (b) and (c)

⇒ The ALU carrier out arithmetic and logic operations (OR AND, NOT, etc.) it processes
decimal numbers
binary numbers
hexadecimal numbers
octal numbers

⇒ In terrestrial microwave links, the number of 'fades' per unit increases as
both the transmission and the distance between the antennas are increased
the transmission frequency is increased but the distance between the antennas is decreased
the transmission frequency is decreased but the distance between the antennas is increased
both the transmission frequency and distance between the antennas are decreased

⇒

Assertion (A): The Fourier series of the wave shown in the figure does not contain even harmao
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ For measurement of high voltage capacitors the suitable bridge is
Wien bridge
modified De Sauty bridge
Schering bridge
either (a) or (b)

⇒ The use of SSB
halves the bandwidth required for transmission
does not affect the bandwidth for transmission
decreases the bandwidth required for transmission by 25%
decreases the bandwidth required for transmission by 66.6%

⇒ In a superheterodyne receiver
the IF stage has better selectivity than RF stage
the RF stage has better selectivity than IF stage
the RF stage has same selectivity than IF stage
none of the above

⇒ A moving iron voltmeter reads 250 V when connected to 250 V dc. If connected to 250 V 50 Hz, the voltmeter reading is likely to be
250 V
252 V
248 V
210 V

⇒

Assertion (A): The variable name 5KING is not valid in Fortran 77.

Reason (R): In Fortran 77 the first character of a variable name must be an alphabet.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ PAL stands for
Phase Attenuation by Line
Phase Alternation by Line
Parabolic Alternation by Line
Picture Alternation by Line

⇒ A 16:1 multiplexer has 4 select input lines.
TRUE
FALSE