Question is ⇒ In a series circuit with X<sub>L</sub> constant and R variable the current locus lies in the third quadrant., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper.

Question is ⇒ In a series circuit with X<sub>L</sub> constant and R variable the current locus lies in the third quadrant., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a series circuit with X_L constant and R variable the current locus lies in the third quadrant.
A.	TRUE [Wrong Answer]
B.	FALSE [Correct Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The ending part of the popular teleserial Mahabharat will be beamed to the viewers
WESTAT
INSAT-IC
ARABSAT
INSAT-ID

⇒ The scaling factor of an MOS device using constant voltage scaling model, the gate area of the device will be scaled as
1/a
1/a²
1/a³
1/a⁴

⇒ A 7477 decoder drives
seven-segment display
nickel tape
relays
diode matrix

⇒ Pick the Odd one out
MOSFET
FET
Planer transistor
Unijunction transistor

⇒

Assertion (A): A GTO circuit is more compact than SCR circuit

Reason (R): A GTO can be turned off by negative gate pulse.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Which of the following is true for RC impedance?
The lowest critical frequency is a pole
The lowest critical frequency is zero
The lowest critical frequency may be pole or zero
The lowest critical frequency is a pole but cannot be at s = 0

⇒ Which of the following circuits can operate class AB for audio power output?
Emitter follower
Push pull
Cascade
Darlington pair

⇒ In the circuit of figure the current through 3 Ω resistance at t = 0^{+0.166666666666667
2.5 A
3.1 A
0}

⇒ Consider the following statements about mutual inductances:

The value should remain constant under all conditions.
The mutual inductance should not vary with temperature.
The inductance should be independent of excitation.
They have two coils wound on a bobbin of hard magnetic material, coils being separated by a range.

Out of the above, correct statement are
2, 3, 4
1, 2, 3
1, 3, 4
1, 2, 4

⇒ N circles for a = a₁, and a = a₁ ± 180° n (where n = 1, 2, 3, ....) are the same.
TRUE
FALSE

⇒ Statement 1
Statement 1 is true but statement 2 is false
Statement 1 is false but statement 2 is true
Both the statements are true
Both the statements are false

⇒ The minterm designation for ABCD is
m₈
m₁₀
m₁₄
m₁₅

⇒ For the control system in the given figure, the value of K for critical dampin
1
5.125
6.831
10

⇒ The bunching action which occurs in multicavity klystron amplifier can be represented by Applegate diagram
TRUE
FALSE

⇒ e^-2t is __________ .
energy signal
power signal
neither energy signal nor power signal
both energy and power signal

⇒
Match the following:
List I (Characteristic equation) List II (Degree of damping)
A. s² + 15s + 56.25 1. Undamped
B. s² + 5s + 6 2. Underdamped
C. s² + 20.25 3. Critically damped
D. s² + 4.55s + 42.25 4. Overdamped

A-1, B-2, C-3, D-4
A-2, B-3, C-1, D-4
A-3, B-4, C-1, D-2
A-1, B-2, C-4, D-3

⇒ When a magnetic circuit is compared with an electric circuit, the equivalent of the magnetic flux is
the conductivity of the lines
the voltage of the source
the current in the lines
the conductance of the load

⇒ Gain of isotropic antenna is
10 dB
0 dB
∞
1 dB

⇒ Baudot code is a six bit code.
TRUE
FALSE

⇒ The requirements of carrier frequency are
precise frequency value
low frequency drift
both (a) and (b)
neither (a) nor (b)

⇒
Match the following:
List I List II
A. Resistance 1. M^-1L^-2T²I²
B. Inductance 2. ML²T^-2I^-2
C. Capacitance 3. M^-1L^-2T⁴I²
D. Reluctance 4. ML²T^-3I^-2

A-1, B-2, C-3, D-4
A-2, B-1, C-3, D-4
A-4, B-2, C-3, D-1
A-2, B-4, C-3, D-1

⇒ The specified maximum junction temperature of thyristors is about
50°C
80°C
120°C
200°C

⇒
Match the following:
List I List II
A. 200 MHz 1. SHF
B. 20 GHz 2. UHF
C. 500 kHz 3. VHF
D. 500 MHz 4. MF

A-3, B-1, C-4, D-2
A-3, B-2, C-4, D-1
A-3, B-4, C-1, D-2
A-3, B-4, C-2, D-1

⇒ In figure the diode is ideal (zero cut in voltage zero forward resistance). Then the current through diod
0
0.166666666666667
0.0416666666666667
none of the above

⇒ The PSD and the power of a signal g(t) are respectively S_g(ω) and P_g, the PSD and the power of signal a.g(t) are respectively
aS²_g (ω) and a²P_g
aS_g² (ω) and aP_g
aS_g (ω) and a²P_g
aS_g (ω) and aP_g

⇒ Performance of a PIN diode switch is represented by
insertion loss when switch is off
insertion loss when switch is on
insertion loss when switch is on and isolation loss when switch is off
insertion loss when switch is off and isolation loss when switch is on

⇒
Match the following:
List I (Comm.services) List II (Bandwidth)
A. AM broadcast 1. 10 kHz
B. Telephone 2. 4 kHz
C. wide-band FM 3. 200 kHz
D. TV 4. 7 MHz

A-1, B-2, C-3, D-4
A-3, B-4, C-1, D-2
A-1, B-4, C-3, D-2
A-3, B-2, C-1, D-4

⇒ In a transistor amplifier, the reverse saturation current I_CO
Doubles for every 10°C rise in temperature
Doubles for every 20°C rise in temperature
Increase 100°C with temperature
Doubles for every 5°C rise in temperature

⇒ A forward voltage of 9 V is applied to a diode in series with a 1 kΩ load resistor. The voltage across load resistor is zero. It indicates that
diode is short circuited
diode is open circuited
resistor is open circuited
diode is either short circuited or open circuited

⇒ A universal shift register can shift left or right.
TRUE
FALSE

	List I (Characteristic equation)		List II (Degree of damping)
A.	s² + 15s + 56.25	1.	Undamped
B.	s² + 5s + 6	2.	Underdamped
C.	s² + 20.25	3.	Critically damped
D.	s² + 4.55s + 42.25	4.	Overdamped

	List I		List II
A.	Resistance	1.	M^-1L^-2T²I²
B.	Inductance	2.	ML²T^-2I^-2
C.	Capacitance	3.	M^-1L^-2T⁴I²
D.	Reluctance	4.	ML²T^-3I^-2

	List I		List II
A.	200 MHz	1.	SHF
B.	20 GHz	2.	UHF
C.	500 kHz	3.	VHF
D.	500 MHz	4.	MF

	List I (Comm.services)		List II (Bandwidth)
A.	AM broadcast	1.	10 kHz
B.	Telephone	2.	4 kHz
C.	wide-band FM	3.	200 kHz
D.	TV	4.	7 MHz

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math