Question is ⇒ In a semi-conductor diode, the barrier offers opposition to, Options are ⇒ (A) holes in P-region only, (B) free electrons in N-region only, (C) majority carriers in both regions, (D) majority as well as minority carriers in both regions, (E) , Leave your comments or Download question paper.

Question is ⇒ In a semi-conductor diode, the barrier offers opposition to, Options are ⇒ (A) holes in P-region only, (B) free electrons in N-region only, (C) majority carriers in both regions, (D) majority as well as minority carriers in both regions, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a semi-conductor diode, the barrier offers opposition to
A.	holes in P-region only [Wrong Answer]
B.	free electrons in N-region only [Wrong Answer]
C.	majority carriers in both regions [Correct Answer]
D.	majority as well as minority carriers in both regions [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For type 2 system, the magnitude and phase angle of the term (jω)² in the denominator, at ω = 0, are respectively
0 and - 90°
0 and + 90°
infinity and - 180°
infinity and + 180°

⇒ In an LC immittance H (s)
the slope of dH (jω)/dω is always negative
the slope of dH (jω)/dω is always positive
the slope of dH (jω)/dω may be positive or negative
the slope of dH (jω)/dω is constant

⇒ Two network said to be dual to each other
if mesh equation of one is same to other of node equation
if mesh equation of both is same
if node equation of both is same
neither mesh equation nor node equation is same

⇒ Which of following antenna produces elliptical polarisation?
Helical
Parabolic
Dipole
None

⇒ A divide by 78 counters can be realized by using
six mod-13 counters
thirteen mod-6 counters
one mod 13 counter followed by one mod-6 counter
thirteen mod-13 counters

⇒ In an ac network the sum of currents entering a node is 10 ∠45°. The sum of currents leaving the node is
19.32 ∠45°
15 ∠45°
20 ∠45°
zero

⇒ Which of the following are linear ICs?
RF and IF amplifiers
Wide band amplifier
Audio amplifiers
All of the above

⇒ RF amplifiers are used in radio receivers for
improved image frequency rejection
improved rejection of adjacent unwanted signals
prevention of re-radiation of the local oscillator through the antenna of the receiver
all of the above

⇒ The output of a diode detector contains
D.C. voltage
modulating signal
RF ripple
all of the above

⇒ Which of the following circuits come under the class of combinational logic circuits?

Full adder
Full subtractor
Half adder
J-K flip-flop
Counter

Select the correct answer from the codes given below:
1 only
3 and 4
4 and 5
1, 2 and 3

⇒

Assertion (A): A BJT can be used as a switch.

Reason (R): In forward active mode emitter base junction is forward biased and base collector junction is reverse biased.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ A series RLC circuit has a resonant frequency of 1000 Hz. The maximum voltage across C is likely to occur at a frequency of about
1000 Hz
2000 Hz
1025 Hz
975 Hz

⇒ Two linearly polarized plane waves A and B travelling in free space in the positive x direction meet at a point. Wave A is polarized in the y direction and the wave B is polarized in the z direction. If the two waves are of equal amplitude and are in phase quadrature, the resultant wave will be
circularly polarized
elliptically polarized
linearly polarized
vertically polarized

⇒ For a second order system, the position of poles is in the shaded region shown in the given figure. The variation in damping facto
from 0 to 1
from about 0.3 to 0.7
from 1 to 5
from 0 to 3

⇒ Equation x_l0 = 11001001₂ when solved for x gives the value of x as
8
111
152
201

⇒

Assertion (A): Linear ICs include audio amplifier, wideband amplifier, RF amplifier and IF amplifier

Reason (R): The error voltage in a feedback circuit is very small

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ For VLF antennas radiation resistance is usually of the order of
less than one ohm
13 to 20 ohms
around 100 ohms
more than 200 ohms

⇒ When measuring phase angle between two waves using a CRO, the time base generator is connected to
X plate
Y plate
both X and Y plate
neither X nor Y plates

⇒ A + (B . C) =
A . B + C
A . B + A . C
A
(A + B) . (A + C)

⇒ The chip 8257 is a
programmable interrupt controller
programmable DMA controller
programmable peripheral interface
none of the above

⇒ In 8086 the number of bytes which can be addressed directly is about
1000
10000
100000
one million

⇒ If air pressure in a rectangular waveguide is increased the maximum power handling capacity
is decreased
is increased
remains the same
may increase or decrease depending on pressure

⇒ A standard waveguide W R90 has inside wall dimensions of a = 2.286 cm and b = 1.016 cm. What is the cut-off wavelength for TE₀₁ mode?
4.572 cm
2.286 cm
2.032 cm
1.857 cm

⇒ Read the following statements:

A μP generally interfaced to several memory chips and I/O devices
Address space provided by μP is partitioned into sub sets of addresses
Address map and address partition refer to different terms in address space

Which of the above are correct?
All
1 and 2 only
2 and 3 only
1, 3 only

⇒ Instruction cycle is the time required to complete the execution of an instruction.
TRUE
FALSE

⇒ If A = 20 and B = - 7 in PASCAL, A mod B =
6
2
-1
3

⇒ What is the addressing mode used in instruction MOV M, C?
Direct
Indirect
Induced
Immediate

⇒ The inverse of given Laplace transfor
sin t
cos t
e^t
e^2t

⇒ The given figure shows three Nyquist plots of G(s) H(s) = e^-sT/[s(s + 1)] for different values of T. The curves 1, 2, 3 ca
for T = 0, 0.5 and 1 respectively
for T = 1, 0.5 and 0 respectively
for T = 0.5, 1 and 0 respectively
for T = 0, 1 and 0.5 respectively

⇒

Assertion (A): Peak to peak value of a sinusoidal wave is 2.828 times the rms value.

Reason (R): Peak factor of a sinusoidal wave is 1.414.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true