Question is ⇒ In a second order system, peak overshoot is independent of, Options are ⇒ (A) damping factor, (B) natural frequency, (C) both damping factor and natural frequency, (D) neither damping factor nor natural frequency, (E) , Leave your comments or Download question paper.

Question is ⇒ In a second order system, peak overshoot is independent of, Options are ⇒ (A) damping factor, (B) natural frequency, (C) both damping factor and natural frequency, (D) neither damping factor nor natural frequency, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a second order system, peak overshoot is independent of
A.	damping factor [Wrong Answer]
B.	natural frequency [Correct Answer]
C.	both damping factor and natural frequency [Wrong Answer]
D.	neither damping factor nor natural frequency [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Decimal 17 in octal system is represented by
888
111
21
27

⇒ Nichols chart consists of
constant magnitude loci
constant phase angle loci
magnitude and phase angle loci in log-magnitude versus phase diagram
none of the above

⇒ An ac wave with superimposed dc is symmetrical about x - axis.
TRUE
FALSE

⇒ For a random variable x following the probability density function, p(x), shown in figure, the mean and the variance are respective
1/2 and 2/3
1 and 4/3
1 and 2/3
2 and 4/3

⇒ A feedback network to be used with an amplifier to provide oscillation is tested and found to give an output of 0.124 V with a 0.5 V input. What percentage negative feedback should be introduced to the amplifier so that linear oscillations result?
0.0125
0.025
-0.0125
-0.025

⇒ The advantages of high density IC are
more circuits on chip
high operating speed
low power consumption
both (a) and (b)

⇒ A 3 bit binary adder should use
3 full adders
2 full adders and 1 half adder
1 full adder and 2 half adders
3 half adders

⇒ In 8085 the time required to add two 32 bit numbers is (if clock frequency is 5 MHz)
about 1 ns
about 1 μs
about 30 μs
about 100 μs

⇒ The antenna current of an AM transmitter is 8 A. When only the carrier is sent, but it increases to 8.93 A. When the carrier is sinusoidally modulated. The percentage modulation is nearly
0.9
0.8
0.75
0.7

⇒ Consider z transform of a signal as given b
IIR
FIR
Depends on value of n
Cannot determined

⇒ In a thyristor, the forward breakover voltage
is constant
may be constant or may depend on gate current
decreases as gate current is increased
increases as gate current is increased

⇒ A (75 - j 50) Ω load is connected to a coaxial line of Z₀ = 75 Ω at 10 GHz. The best method of matching consists of using
a capacitance at some specific distance from load
a short circuited stub at some specific distance from load
an inductance at load
a short circuited stub at load

⇒ In a backward wave oscillator the wave travelling along the line winds itself back and forth
TRUE
FALSE

⇒ One electron volt is equivalent to
1.6 x 10^-10 joule
1.6 x 10^-13 joule
1.6 x 10^-16 joule
1.6 x 10^-19 joule

⇒

Assertion (A): Water waves are longitudinal but EM waves are transverse

Reason (R): In an EM wave electric field, magnetic field and propagation are mutually perpendicular.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ A 4 line to 16 line decoder has
16 inputs and 4 outputs
4 inputs and 16 outputs
either (a) or (b)
neither (a) nor (b)

⇒ For a second order system, the position of poles is shown in the given figure. This syste
undamped
overdamped
underdamped
critically damped

⇒ The constellation diagram of a modem has four states as shown in the figure given below. What is the bit rate of this mod
Two times its band rate
Four times its band rate
Same as band rate
Sufficient information is not given to give the answer

⇒ A sinusoidal carrier voltage, having frequency 1000 Hz is amplitude modulated by a sinusoidal voltage of frequency 15 kHz. The frequency of upper and lower sidebands will be
1015 kHz and 985 kHz
1030 kHz and 970 kHz
13 kHz and 17 kHz
14 kHz and 16 kHz

⇒ A 6 bit dual slope A/D converter uses a reference of -6v and a 1 MHz clock. It uses a fixed count of 40 (101000). Then, what will be input, if the output register shows 100111 at the end of conversion.
5.85 V
6 V
5 V
10 V

⇒ If A = 3 + j1 and B = 4 + j3, A - B =
8.062 ∠29.7°
10 ∠45°
2.236 ∠243.43°
6.72 ∠243.43°

⇒ For a second order system delay time t_d is the time required to reach
half the final value for the very first time
the final value for the very first time
90% of the final value for the very first time
none of the above

⇒

Match the following:

	List I (Microwave device)		List II (Application)
A.	Reflex Klystron	1.	Wideband amplification
B.	TWT	2.	Very low power amplification
C.	Cavity Klystron	3.	Low power FM generation
D.	Maser	4.	Frequency multiplication

A-1, B-2, C-3, D-4
A-4, B-3, C-2, D-1
A-3, B-4, C-1, D-2
A-3, B-1, C-4, D-2

⇒ The Clapp oscillator shown in figure will operat
4.6 kHz
46 kHz
460 kHz
4600 kHz

⇒ Which impurity atom will give p type semiconductor when added to intrinsic semiconductor?
Phosphorus
Boron
Arsenic
Antimony

⇒ A function is given f(t) = sin²t + cos²t. Which of the following is true?
f has frequency components at 0 and 1/2p Hz
f has frequency components at 0 and 1/p Hz
f has frequency components at 1/2p and 1/p Hz
f has frequency components at 0, l/2p and 1/p Hz

⇒

Assertion (A): The reverse current in a p-n junction is nearly constant.

Reason (R): The reverse breakdown voltage of a p-n diode depends on the extent of doping.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ The received signal frequency at any time of a super-heterodyne receiver having IF = 456 kHz is 1 MHz. The corresponding image signal is
within the medium band
outside the medium band
depend upon modulation index
depends on Modulating frequency

⇒ An FM signal has modulating frequency f_m and maximum frequency deviation of δ. The bandwidth will be nearly equal to
δ
2 δ
2f_m δ
f_m δ

⇒ If a sample of germanium and a sample of Si have the impurity density and are kept at room temperature then
both will have equal value of resistivity
both will have equal -ve resistivity
resistivity of germanium will be higher than that of silicon
resistivity of Si will be higher than of germanium